Influence of bentonite clay on the rheological behaviour of fresh mortars

Fine mineral additives are often used in the formulation of ready-mix mortars as thickeners and thixotropic agents. Yet, these attributed fresh state properties are not clearly defined from the rheological point of view. In the present study, we consider the influence of bentonite (montmorillonite-based clay mineral) on the rheological behaviour of mortars, including in particular creep and thixotropy. The mortar pastes are subjected to different shear-rates and then allowed to creep under fixed shear stresses until reaching steady state, which corresponds to either rest if the applied stress is smaller than the yield stress or permanent flow otherwise. The evolution of the creep strain is investigated depending on shear history for different contents of bentonite. The microstructure rebuilding kinetics after shear (thixotropy) is considered by analysing the temporal evolution of the creep strain for different applied shear stresses (lower than the yield stress). As expected, bentonite is found to enhance the mortar creep (or sag) resistance. This enhancement consists of both an increase of the yield stress recovered after shear, and a diminution of the characteristic time for yield stress recovery (related to microstructure rebuilding).

[1]  C. Atzeni,et al.  Comparison between rheological models for portland cement pastes , 1985 .

[2]  F. Galindo-Rosales,et al.  Structural breakdown and build-up in bentonite dispersions , 2006 .

[3]  M. Bousmina,et al.  Determination of shear rate and viscosity from batch mixer data , 1999 .

[4]  J. Labrincha,et al.  Effects of a water-retaining agent on the rheological behaviour of a single-coat render mortar , 2006 .

[5]  V. Ferreira,et al.  Rheology and hardened properties of single-coat render mortars with different types of water retaining agents , 2009 .

[6]  R. Le Roy,et al.  Rheological behaviour of fresh cement pastes formulated from a Self Compacting Concrete (SCC) , 2006 .

[7]  P. Marchal,et al.  Quantitative Analysis of Mixer-Type Rheometers using the Couette Analogy , 2002 .

[8]  G H Tattersall,et al.  Workability and quality control of concrete , 1991 .

[9]  H. Barnes.  Thixotropy—a review , 1997 .

[10]  Kamal H. Khayat,et al.  Influence of Thixotropy on Stability Characteristics of Cement Grout and Concrete , 2002 .

[11]  Nicolas Roussel,et al.  Steady and transient flow behaviour of fresh cement pastes , 2005 .

[12]  Kamal H. Khayat,et al.  Analytical models for estimating yield stress of high-performance pseudoplastic grout , 2001 .

[13]  Philippe Coussot,et al.  Avalanche behavior in yield stress fluids. , 2002, Physical review letters.

[14]  Elton Bauer,et al.  Study of the laboratory Vane test on mortars , 2007 .

[15]  Philippe Coussot,et al.  Viscosity bifurcation in thixotropic, yielding fluids , 2002 .

[16]  A. Papo,et al.  Rheological models for cement pastes , 1988 .

[17]  M. Chaouche,et al.  Influence of Viscosity-Modifying Admixtures on the Thixotropic Behaviour of Cement Pastes , 2008 .

[18]  Kamal H. Khayat,et al.  Applicability of rheological models to high-performance grouts containing supplementary cementitious materials and viscosity enhancing admixture , 2003 .

[19]  Phillip Frank Gower Banfill,et al.  RHEOLOGICAL METHODS FOR ASSESSING THE FLOW PROPERTIES OF MORTAR AND RELATED MATERIALS , 1994 .