Effects of Long-Term Dynamic Loading and Fluctuating Water Table on Helical Anchor Performance for Small Wind Tower Foundations

The application of this study is to use helical anchors as a foundation system for small wind tower (1–10 kW) guyed cables. Helical anchors are currently used to anchor guyed cables of cell or transmission towers. However, the increased dynamic vibrations a wind turbine adds to the tower and foundation system under working loads, as well as extreme environmental conditions (e.g., straight line winds, ice load, or sudden furling shocks), require additional knowledge about the behavior of helical anchors. These field conditions were simulated in this study from tower-instrumented field data on wind speed and tower response. These tower responses were then transmitted to the helical anchors through an extensive, large-scale testing program that included monitoring the performance of the helical anchor foundation under dynamic loads, subject to natural variations in both wind regimes, precipitation (water level) and variations in helical anchor geometry. This paper compares the uplift prediction methods used in helical anchor design as well as discusses the effects of long-term dynamic loading and fluctuating water table on helical anchor performance.

[1]  Amy B. Cerato,et al.  Effects of Helical Anchor Geometry on Long-Term Performance of Small Wind Tower Foundations Subject to Dynamic Loads , 2008 .

[2]  R. C. Harvey,et al.  Embedded anchor response to uplift loading , 1981 .

[3]  Y. V. S. N. Prasad,et al.  Estimation of Uplift Capacity of Helical Anchors in Clays , 1993 .

[4]  H Taylor,et al.  SELECTION AND PERFORMANCE OF ANCHORS FOR GUYED TRANSMISSION TOWERS , 1969 .

[5]  Samuel P. Clemence,et al.  Closure to “Pullout Performance of Inclined Helical Screw Anchors in Sand” by Ashraf M. Ghaly and Samuel P. Clemence , 1999 .

[6]  T. W. Klym,et al.  A Study of Anchorages for Transmission Tower Foundations , 1972 .

[7]  Mark Randolph,et al.  Interface load transfer degradation during cyclic loading: a microscale investigation , 2003 .

[8]  Adel Hanna,et al.  Model investigation of the performance of single anchors and groups of anchors , 1994 .

[9]  Howard A. Perko.  Energy Method for Predicting Installation Torque of Helical Foundations and Anchors , 2000 .

[10]  John S. Pack.  Design of Helical Piles for Heavily Loaded Structures , 2000 .

[11]  Mark Randolph,et al.  Microscale observation and modeling of soil-structure interface behavior using particle image velocimetry , 2006 .

[12]  T. H. Hanna,et al.  THE BEHAVIOUR OF DEAD ANCHORS SUBJECTED TO REPEATED AND ALTERNATING LOADS , 1978 .

[13]  S. N. Rao,et al.  Pullout behaviour of model pile and helical pile anchors Subjected to lateral cyclic loading , 1994 .

[14]  Adel Hanna,et al.  INSTALLATION TORQUE OF SCREW ANCHORS IN DRY SAND , 1991 .

[15]  Clemence,et al.  DYNAMIC UPLIFT CAPACITY OF HELICAL ANCHORS IN SAND , 1983 .

[16]  Braja M. Das.  Resistance of Shallow Inclined Anchors in Clay , 1985 .

[17]  H. John Hovland.  Discussion of "Helical Anchors in Dry and Submerged Sand Subjected to Surcharge" , 1993 .