Optical characterization of combustion processes in a DISI engine equipped with plasma-assisted ignition system

Abstract Currently, direct injection (DI) for gasoline engines is a primary trend for improving efficiency allowing reduced fuel consumption and the possibility to meet stringent emission standards. A large temporal and spatial variation of mixture composition near the spark location during low speed and high load operation are driving the demands for significantly improved ignition systems. Recently, plasma-assisted ignition systems received increasing interest, as they are used for combustion initiation and control and show the potential for flame stabilization. The aim of this paper is to improve the understanding of the processes related to the use of a plasma-assisted ignition system and its influence on combustion development. Experiments were performed in an optical spark ignition (SI) engine equipped with the cylinder head and injection system of a commercial gasoline turbocharged engine. The effects of spark plug geometry and different plasma configurations were investigated. UV–visible digital imaging was applied; the optical data were correlated to in-cylinder pressure traces and exhaust emission measurements. Significantly higher stability, quantified through the coefficients of variation for the indicated mean effective pressure and flame radius, was obtained using the alternative ignition system in stoichiometric and lean burn conditions. An improvement in engine performance and pollutant emissions was also achieved.

[1]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[2]  Jesús Benajes,et al.  An investigation of partially premixed compression ignition combustion using gasoline and spark assistance , 2013 .

[3]  Mohamed H. Morsy,et al.  Review and recent developments of laser ignition for internal combustion engines applications , 2012 .

[4]  Lloyd Withrow,et al.  Motion Pictures of Engine Flames Correlated with Pressure Cards , 1938 .

[5]  E. Tomita,et al.  Jet-guided combustion characteristics and local fuel concentration measurements in a hydrogen direct-injection spark-ignition engine , 2013 .

[6]  C. Bae,et al.  Effects of the injection timing on spray and combustion characteristics in a spray-guided DISI engine under lean-stratified operation , 2013 .

[7]  Samveg Saxena,et al.  Extending the Lean Stability Limits of Gasoline Using a Microwave-Assisted Spark Plug , 2011 .

[8]  Robert W. Dibble,et al.  Enhancement of flame development by microwave-assisted spark ignition in constant volume combustion chamber , 2013 .

[9]  Joachim Demuynck,et al.  The potential of methanol as a fuel for flex-fuel and dedicated spark-ignition engines , 2013 .

[10]  Jonathan Dale,et al.  Application of high energy ignition systems to engines , 1997 .

[11]  Dimitrios Moshou,et al.  Detection of fuel type on a spark ignition engine from engine vibration behaviour , 2013 .

[12]  Tie Li,et al.  Combined effects of cooled EGR and a higher geometric compression ratio on thermal efficiency improvement of a downsized boosted spark-ignition direct-injection engine , 2014 .

[13]  Antonio García,et al.  A spectroscopy study of gasoline partially premixed compression ignition spark assisted combustion , 2013 .

[14]  Cheolwoong Park,et al.  Stratified lean combustion characteristics of a spray-guided combustion system in a gasoline direct injection engine , 2012 .

[15]  N. Aleksandrov,et al.  Plasma-assisted ignition and combustion , 2013 .

[16]  Campbell D. Carter,et al.  Direct ignition and S-curve transition by in situ nano-second pulsed discharge in methane/oxygen/helium counterflow flame , 2012 .

[17]  Gequn Shu,et al.  Effects of EGR, compression ratio and boost pressure on cyclic variation of PFI gasoline engine at WOT operation , 2014 .

[18]  Andrew K. C. Wong,et al.  A new method for gray-level picture thresholding using the entropy of the histogram , 1985, Comput. Vis. Graph. Image Process..

[19]  Adrian Irimescu,et al.  Compression ratio and blow-by rates estimation based on motored pressure trace analysis for an optical spark ignition engine , 2013 .

[20]  Hua Zhao,et al.  Application of a hybrid breakup model for the spray simulation of a multi-hole injector used for a DISI gasoline engine , 2014 .

[21]  Soon H. Kwon,et al.  Threshold selection based on cluster analysis , 2004, Pattern Recognit. Lett..

[22]  S. Starikovskaia,et al.  Plasma assisted ignition and combustion , 2006 .

[23]  L. Gary,et al.  ABELL F. Dereck, Defining The Business. The Starting Point of Strategic Planning . USA, Prentice Hall, Englewood Cliffs, New Jersey, 1980. , 1996 .

[24]  Alberto A. Boretti,et al.  Water injection in directly injected turbocharged spark ignition engines , 2013 .

[25]  A. Agarwal,et al.  Comparative experimental evaluation of performance, combustion and emissions of laser ignition with conventional spark plug in a compressed natural gas fuelled single cylinder engine , 2014 .

[26]  Simona Silvia Merola,et al.  Optical investigations of the early combustion phase in spark ignition boosted engines , 2011 .

[27]  D. Brüggemann,et al.  Advancing lean combustion of hydrogen–air mixtures by laser-induced spark ignition , 2011 .

[28]  Chen-Fang Chang,et al.  Cylinder-Pressure-Based Engine Control Using Pressure-Ratio-Management and Low-Cost Non-Intrusive Cylinder Pressure Sensors , 2000 .