Comparison of different simplistic prediction models for forecasting PV power output: Assessment with experimental measurements

Abstract This paper tested the energy outputs of different types of PV modules and evaluated the accuracies of different simplistic PV module power prediction models. A test rig was developed in Hong Kong to assess the PV power outputs of ten PV modules. The solar radiation, ambient temperature and power generation are recorded. The evaluated models include simple efficiency model, temperature correction model and one-diode model. The results show that the mono-Si PV module is the highest in terms of the annual energy outputs per unit area, and a-Si PV modules is the lowest. The simple efficiency model overestimates the power output of all types of PV modules for more than 10% except for a CdTe PV module. The one-diode model demonstrated the highest accuracy for mono-Si and poly-Si PV modules. The accuracies of the evaluated models are low for thin-film PV technologies. Although the mean bias error of the one-diode model is larger than 10% for the thin-film PV modules (expect for one CdTe PV module), the one-diode model has the highest accuracy among the three models. Further studies should be conducted to investigate the energy performance of thin-film PV modules and then improve their prediction accuracy.

[1]  Sakaros Bogning Dongue,et al.  Modeling Of Electrical Response of Illuminated Crystalline Photovoltaic Modules Using Four- And Five-Parameter Models , 2012 .

[2]  J. Amador,et al.  A single procedure for helping PV designers to select silicon PV modules and evaluate the loss resistances , 2007 .

[3]  M. Wang,et al.  A new model to evaluate solar spectrum impacts on the short circuit current of solar photovoltaic modules , 2019, Energy.

[4]  Dirk Jordan,et al.  Compendium of photovoltaic degradation rates , 2016 .

[5]  Hongxing Yang,et al.  Assessment of energy performance of semi-transparent PV insulating glass units using a validated simulation model , 2016 .

[6]  Marcelo Gradella Villalva,et al.  Comprehensive Approach to Modeling and Simulation of Photovoltaic Arrays , 2009, IEEE Transactions on Power Electronics.

[7]  Gilles Notton,et al.  Optimal sizing of a grid-connected PV system for various PV module technologies and inclinations, inverter efficiency characteristics and locations , 2010 .

[8]  E. D. Mehleri,et al.  Determination of the optimal tilt angle and orientation for solar photovoltaic arrays , 2010 .

[9]  J. Marcos,et al.  PV performance modelling: A review in the light of quality assurance for large PV plants , 2017 .

[10]  Dirk C. Jordan,et al.  Photovoltaic Degradation Rates—an Analytical Review , 2012 .

[11]  M. Saad,et al.  Analysis of multi-crystalline silicon solar cells at low illumination levels using a modified two-diode model , 2010 .

[12]  Manuel Fuentes,et al.  An Assessment on Simple Modeling Approaches to the Electric Behavior of Two CIS PV Modules in a Sunny Climate , 2009 .

[13]  L. Frearson,et al.  An Assessment of Photovoltaic Modelling Software Using Real World Performance Data , 2011 .

[14]  Brian P. Dougherty,et al.  Evaluation and Validation of Equivalent Circuit Photovoltaic Solar Cell Performance Models , 2011 .

[15]  Hongxing Yang,et al.  Numerical investigation of the energy saving potential of a semi-transparent photovoltaic double-skin facade in a cool-summer Mediterranean climate , 2016 .

[16]  J. V. Muñoz,et al.  Analysis of the dependence of the spectral factor of some PV technologies on the solar spectrum distribution , 2014 .

[17]  Hongxing Yang,et al.  Validation of the Sandia model with indoor and outdoor measurements for semi-transparent amorphous silicon PV modules , 2015 .

[18]  Hongxing Yang,et al.  Comparison of energy performance between PV double skin facades and PV insulating glass units , 2017 .

[19]  Agnelo Marotta Cassula,et al.  Assessment of photovoltaic performance models for system simulation , 2017 .

[20]  Girish Kumar Singh,et al.  Solar power generation by PV (photovoltaic) technology: A review , 2013 .

[21]  A. Allouhi,et al.  Solar irradiance and temperature influence on the photovoltaic cell equivalent-circuit models , 2019, Solar Energy.

[22]  Wei Zhou,et al.  A novel model for photovoltaic array performance prediction , 2007 .

[23]  Hongxing Yang,et al.  Review on life cycle assessment of energy payback and greenhouse gas emission of solar photovoltaic systems , 2013 .

[24]  Hongxing Yang,et al.  Investigation on the energy performance of a novel semi-transparent BIPV system integrated with vacuum glazing , 2018, Building Simulation.

[25]  George Makrides,et al.  Energy yield prediction errors and uncertainties of different photovoltaic models , 2013 .

[26]  Kashif Ishaque,et al.  Simple, fast and accurate two-diode model for photovoltaic modules , 2011 .

[27]  Steven S. Hegedus,et al.  Review of photovoltaic module energy yield (kWh/kW): comparison of crystalline Si and thin film technologies , 2013 .

[28]  S. Vergura,et al.  Explicit empirical model for photovoltaic devices. Experimental validation , 2017 .

[29]  Daniel M. Riley,et al.  Comparison of PV system performance-model predictions with measured PV system performance , 2008, 2008 33rd IEEE Photovoltaic Specialists Conference.

[30]  R Khezzar,et al.  Modeling improvement of the four parameter model for photovoltaic modules , 2014 .

[31]  Dani Rusirawan,et al.  Identification of Model Parameters of the Photovoltaic Solar Cells , 2014 .

[32]  William A. Beckman,et al.  Improvement and validation of a model for photovoltaic array performance , 2006 .

[33]  Hongxing Yang,et al.  Solar photovoltaic system modeling and performance prediction , 2014 .

[34]  F. Chenlo,et al.  Analysis of spectral effects on the energy yield of different PV (photovoltaic) technologies: The case of four specific sites , 2014 .

[35]  T. Fuyuki,et al.  Analysis of multicrystalline silicon solar cells by modified 3-diode equivalent circuit model taking leakage current through periphery into consideration , 2007 .

[36]  Aron Dobos,et al.  An Improved Coefficient Calculator for the California Energy Commission 6 Parameter Photovoltaic Module Model , 2012 .

[37]  Kenji Otani,et al.  Change in I–V characteristics of thin‐film photovoltaic (PV) modules induced by light soaking and thermal annealing effects , 2014 .

[38]  Ulrich Stutenbaeumer,et al.  Equivalent model of monocrystalline, polycrystalline and amorphous silicon solar cells , 1999 .

[39]  Gustavo Nofuentes,et al.  Study on analytical modelling approaches to the performance of thin film PV modules in sunny inland climates , 2014 .

[40]  Marius Paulescu,et al.  New procedure and field-tests to assess photovoltaic module performance , 2014 .

[41]  Tony Sample,et al.  Preconditioning of thin‐film PV module technologies for calibration , 2014 .