A comparison of two minimum quantity lubrication delivery systems

Purpose – The purpose of this paper is to compare the performance of single- and dual-channel minimum quantity lubrication (MQL) for reaming spool bores in an automotive transmission valve body. Design/methodology/approach – Machining experiments are conducted under various parameters for both single- and dual-channel MQL. Comparison metrics include part surface temperature, spindle power consumption and hole quality. Experimental data from traditional through-tool flood coolant are provided as a baseline for spindle power consumption and part quality. Findings – The results show that with proper tooling and machining parameters, dual-channel MQL can perform equivalently or better than flood coolant. Single-channel MQL was not deemed suitable for this machining application. Practical implications – The results of the study show that MQL can be successfully applied for precision reaming of aluminum and can provide guidance in developing an MQL system. Originality/value – Few studies have been performed for...

[1]  Soumitra Paul,et al.  Role of Cryogenic Cooling on Cutting Temperature in Turning Steel , 2002 .

[3]  N. R. Dhar,et al.  Effect of minimum quantity lubrication (MQL) on tool wear and surface roughness in turning AISI-4340 steel , 2006 .

[4]  T. Leyendecker,et al.  Investigations on hard coated reamers in different lubricant free cutting operations , 1997 .

[5]  Yang-Tse Cheng,et al.  The effect of free-machining elements on dry machining of B319 aluminum alloy , 2009 .

[6]  N. R. Dhar,et al.  An experimental investigation on effect of minimum quantity lubrication in machining AISI 1040 steel , 2007 .

[7]  Tien-Chien Jen,et al.  Investigation of heat pipe cooling in drilling applications. Part I: preliminary numerical analysis and verification , 2002 .

[8]  Sheri K. Kurgin,et al.  A characterisation of mist generated from minimum quantity lubrication (MQL) compared to wet machining , 2010 .

[9]  Mark T. North,et al.  Investigation of dry machining with embedded heat pipe cooling by finite element analysis and experiments , 2007 .

[10]  D. O’Sullivan,et al.  Temperature measurement in single point turning , 2001 .

[12]  Andres F. Clarens,et al.  Feasibility of metalworking fluids delivered in supercritical carbon dioxide , 2005 .

[13]  P S Sreejith,et al.  Experimental studies on drilling of aluminium (AA1050) under dry, minimum quantity of lubricant, and flood-lubricated conditions , 2006 .

[14]  T. Emmer,et al.  Environmentally clean metal cutting processes—machining on the way to dry cutting , 1999 .

[15]  Thomas Childs,et al.  Metal Machining: Theory and Applications , 2000 .

[16]  Tojiro Aoyama,et al.  Development of a mixture supply system for machining with minimal quantity lubrication , 2002 .

[17]  A. B. Chattopadhyay,et al.  Tool wear in cryogenic turning of Ti-6Al-4V alloy , 2007 .

[18]  T. Itoh,et al.  Relation between cutting conditions and precision in the reaming of gray iron castings , 1979 .

[19]  Neil Canter,et al.  The tribological challenges of high-speed machining , 2007 .

[20]  Álisson Rocha Machado,et al.  Cooling ability of cutting fluids and measurement of the chip‐tool interface temperatures , 2002 .

[21]  Richard J. Furness,et al.  Minimum Quantity Lubrication (MQL) Machining for Complex Powertrain Components , 2006 .