Cyclic triaxial tests on frozen sand
暂无分享,去创建一个
ABSTRACT Li, J.C., Baladi, G.Y. and Andersland, O.B., 1979. Cyclic triaxial tests on frozen sand. Eng. Geol., 13: 233–246. Strain-controlled cyclic triaxial tests were performed on a one-size silica (Ottawa) sand artificially frozen into 71.1-mm-diameter cylindrical samples. Ice-saturated samples with three different sand contents were tested under the following conditions : axial strains ranging from 3 × 10 −3 to 3 × 10 −2 %, confining pressures from zero to 1.378 MPa, frequencies of 0.05–5.0 cps and temperatures from −1 to −10 °C. Test equipment included (1) an MTS electrohydraulic closed-loop testing system which applies the load to the sample, (2) a triaxial cell completely immersed in a lowtemperature coolant for temperature control, (3) a refrigeration unit for control of the coolant temperature and constant coolant circulation and (4) measuring devices including an LVDT and load cell, together with recording devices such as a digital multimeter, an oscilloscope, a strip-chart recorder and a minicomputer. Test results indicate that the dynamic Young's modulus increases with increasing frequency, confining pressure and sand content, but decreases with increasing strain and temperature. The damping ratio decreases with increasing frequency, sand content and lower temperatures. The influence of confining pressures and axial strain on the damping ratio are less explicit for the ranges considered. The experimental results are compared with data from other sources.