Study of the fluid film vaporization in the interface of a mechanical face seal

Abstract This paper presents numerical simulations of the effect of an increase in feeding temperature on a mechanical seal operating with water. A transient numerical model using the homogeneous fluid theory was developed to analyze the vaporization of the fluid film in a mechanical seal interface. Heat transfer in the contiguous solids and faces deformations are considered. After a validation of the model by comparison with experiments, a parametric study is presented. For moderate temperature rise, the vaporization of the fluid in the contact has no significant effect on the seal performance. However, above a temperature threshold, the mechanical seal can exhibit unstable behavior which can be detrimental for its life expectancy.

[1]  Tao Wang,et al.  A Homogeneous Phase Change Model for Two-Phase Mechanical Seals With Three-Dimensional Face Structures , 2014 .

[2]  Alan O. Lebeck,et al.  Two-Phase Mechanical Face Seal Operation: Experimental And Theoretical Observations , 1982 .

[3]  Tao Wang,et al.  Experimental study of two-phase mechanical face Seals with laser surface texturing ☆ , 2014 .

[4]  P. A. Beatty,et al.  Turbulent Two-Phase Flow in Face Shaft Seals , 1987 .

[5]  F. K. Orcutt.  An Investigation of the Operation and Failure of Mechanical Face Seals , 1969 .

[6]  Kurt M. Becker,et al.  Measurements of convective heat transfer from a horizontal cylinder rotating in a tank of water , 1963 .

[7]  David A. Blasbalg.  The dynamic behavior of two-phase mechanical seals , 1989 .

[8]  A Simple Approach to the ThermoElastoHydroDynamic Behavior of Mechanical Face Seals , 2009 .

[9]  W. F. Hughes,et al.  Centrifugal Inertia Effects in Two-Phase Face Seal Films , 1987 .

[10]  N. H. Chao,et al.  Phase Change in Liquid Face Seals II—Isothermal and Adiabatic Bounds With Real Fluids , 1980 .

[11]  J. A. Yasuna,et al.  A Continuous Boiling Model for Face Seals , 1990 .

[12]  Richard F. Salant,et al.  Numerical study of two-phase mechanical seal stability , 1995 .

[14]  Temperature measurement by infrared thermography in a lubricated contact : radiometric analysis. , 1994 .

[15]  N. Brunetière,et al.  Heat transfer in a mechanical face seal , 2009 .

[16]  Pascal Pezzani.  Propriétés thermodynamiques de l'eau , 1992, Technologies de l'eau.

[17]  G. Wallis.  One Dimensional Two-Phase Flow , 1969 .

[18]  A. O. Lebeck.  A Mixed Friction Hydrostatic Face Seal Model With Phase Change , 1980 .

[19]  I. Etsion,et al.  Vaporization in face seals operating with liquid mixtures , 1997 .

[20]  W. C. Kennedy,et al.  Phase Change in Liquid Face Seals , 1980 .

[21]  J. A. Yasuna,et al.  Squeeze Film Dynamics of Two-Phase Seals , 1992 .

[22]  W. F. Hughes,et al.  Dynamics of two-phase face seals , 1984 .

[23]  I. Etsion,et al.  Phase Change in a Misaligned Mechanical Face Seal , 1996 .