Evolution trend and weakening mechanism of type-I fracture characteristics of granite under coupled thermo-hydro-mechanical and thermal treatments

[1]  Zhenshun Li,et al.  Micro and Macro Evaluation of Tensile Characteristics of Anisotropic Rock Mass after High Temperatures Treatment-A Case Study of Lingshi Gneiss , 2022, SSRN Electronic Journal.

[2]  T. Yin,et al.  Research on the effect of thermal treatment on the crack resistance curve of marble using notched semi-circular bend specimen , 2022, Theoretical and Applied Fracture Mechanics.

[3]  Goh Hui Hwang,et al.  Technological solutions for long-term storage of partially used nuclear waste: A critical review , 2022, Annals of Nuclear Energy.

[4]  Chunde Ma,et al.  Experimental study on mechanical properties and failure modes of pre-existing cracks in sandstone during uniaxial tension/compression testing , 2021 .

[5]  Ang Li,et al.  Influences of Loading Method and Notch Type on Rock Fracture Toughness Measurements: From the Perspectives of T-Stress and Fracture Process Zone , 2021, Rock Mechanics and Rock Engineering.

[6]  Xibing Li,et al.  Effect of microwave heating on fracture behavior of granite: An experimental investigation , 2021 .

[7]  Z. Cui,et al.  An Experimental Investigation of the Influence of Loading Rate on Rock Tensile Strength and Split Fracture Surface Morphology , 2021, Rock Mechanics and Rock Engineering.

[8]  Tao Meng,et al.  Evolution of permeability and microscopic pore structure of sandstone and its weakening mechanism under coupled thermo-hydro-mechanical environment subjected to real-time high temperature , 2020 .

[9]  Tao Meng,et al.  Mode-I fracture toughness and mechanisms of Salt-Rock gypsum interlayers under real-time high-temperature conditions , 2020 .

[10]  M. Karahan,et al.  Influence of Mineralogical and Micro-Structural Changes on the Physical and Strength Properties of Post-thermal-Treatment Clayey Rocks , 2020, Rock Mechanics and Rock Engineering.

[11]  Sulin Zhang,et al.  Experimental study on development characteristics and size effect of rock fracture process zone , 2020 .

[12]  Yong Kang,et al.  Effect of thermal cycling-dependent cracks on physical and mechanical properties of granite for enhanced geothermal system , 2020 .

[13]  L. Wong,et al.  Rock strengthening or weakening upon heating in the mild temperature range? , 2020 .

[14]  Yong Kang,et al.  Experimental investigation of thermal cycling effect on fracture characteristics of granite in a geothermal-energy reservoir , 2020, Engineering Fracture Mechanics.

[15]  M. Saar,et al.  Mode I fracture growth in anisotropic rocks: Theory and experiment , 2020, International Journal of Solids and Structures.

[16]  D. Seyedi,et al.  In Situ Investigation of the THM Behavior of the Callovo-Oxfordian Claystone , 2020, Rock Mechanics and Rock Engineering.

[17]  P. Pan,et al.  Fracture analysis of Beishan granite after high-temperature treatment using digital image correlation , 2020 .

[18]  Long Cheng,et al.  Study on the interaction mechanism between hydraulic fracture and natural karst cave with the extended finite element method , 2019, Engineering Fracture Mechanics.

[19]  Songcai Han,et al.  Effects of non-uniform pore pressure field on hydraulic fracture propagation behaviors , 2019, Engineering Fracture Mechanics.

[20]  Xibing Li,et al.  Experimental investigation on mode I fracture characteristics of granite after cyclic heating and cooling treatments , 2019, Engineering Fracture Mechanics.

[21]  Lizhi Xiao,et al.  Investigation of multiple hydraulic fractures evolution and well performance in lacustrine shale oil reservoirs considering stress heterogeneity , 2019, Engineering Fracture Mechanics.

[22]  Hui Zhou,et al.  Macro- and Microstructural Characteristics of the Tension–Shear and Compression–Shear Fracture of Granite , 2019, Rock Mechanics and Rock Engineering.

[23]  S. Salimzadeh,et al.  The effect of stress distribution on the shape and direction of hydraulic fractures in layered media , 2019, Engineering Fracture Mechanics.

[24]  Tao Meng,et al.  Evolution of the permeability and pore structure of transversely isotropic calcareous sediments subjected to triaxial pressure and high temperature , 2019, Engineering Geology.

[25]  Tao Meng,et al.  Using micro-computed tomography and scanning electron microscopy to assess the morphological evolution and fractal dimension of a salt-gypsum rock subjected to a coupled thermal-hydrological-chemical environment , 2018, Marine and Petroleum Geology.

[26]  Cheng Zhao,et al.  Cracking Processes and Coalescence Modes in Rock-Like Specimens with Two Parallel Pre-existing Cracks , 2018, Rock Mechanics and Rock Engineering.

[27]  O. Heidbach,et al.  Evaluating Micro-Seismic Events Triggered by Reservoir Operations at the Geothermal Site of Groß Schönebeck (Germany) , 2018, Rock Mechanics and Rock Engineering.

[28]  Zhijun Wu,et al.  Mesodamage Characteristics of Rock with a Pre-cut Opening Under Combined Static–Dynamic Loads: A Nuclear Magnetic Resonance (NMR) Investigation , 2018, Rock Mechanics and Rock Engineering.

[29]  Hamidreza M. Nick,et al.  A three-dimensional coupled thermo-hydro-mechanical model for deformable fractured geothermal systems , 2018 .

[30]  Yong Kang,et al.  The influence of temperatures on mixed-mode (I + II) and mode-II fracture toughness of sandstone , 2017 .

[31]  Aldo Steinfeld,et al.  Experimental investigation of the thermal and mechanical stability of rocks for high-temperature thermal-energy storage , 2017 .

[32]  Yong Kang,et al.  The Influence of Temperature on Mode I Fracture Toughness and Fracture Characteristics of Sandstone , 2017, Rock Mechanics and Rock Engineering.

[33]  Meng Tao,et al.  Investigation on the Permeability Evolution of Gypsum Interlayer Under High Temperature and Triaxial Pressure , 2017, Rock Mechanics and Rock Engineering.

[34]  Abdelhafid Khelidj,et al.  Meso-scale investigation of failure in the tensile splitting test: Size effect and fracture energy analysis , 2016 .

[35]  Abbas Taheri,et al.  Pre-Peak and Post-Peak Rock Strain Characteristics During Uniaxial Compression by 3D Digital Image Correlation , 2016, Rock Mechanics and Rock Engineering.

[36]  J. Hudson,et al.  In situ strength and failure mechanisms of migmatitic gneiss and pegmatitic granite at the nuclear waste disposal site in Olkiluoto, Western Finland , 2015 .

[37]  D. Viete,et al.  Thermo-mechanical properties of Bundelkhand granite near Jhansi, India , 2015 .

[38]  G. Gao,et al.  Investigation of the rate dependence of fracture propagation in rocks using digital image correlation (DIC) method , 2015 .

[39]  Zongxing Li,et al.  Macro-fracture mode and micro-fracture mechanism of shale , 2015 .

[40]  Nima Babanouri,et al.  Modeling Spatial Structure of Rock Fracture Surfaces Before and After Shear Test: A Method for Estimating Morphology of Damaged Zones , 2015, Rock Mechanics and Rock Engineering.

[41]  Gang Qi,et al.  Damage and Fracture Investigation of Three-Point Bending Notched Sandstone Beams by DIC and AE Techniques , 2015, Rock Mechanics and Rock Engineering.

[42]  Y. Ju,et al.  Three-point bending test investigation of the fracture behavior of siltstone after thermal treatment , 2014 .

[43]  K. Matsui,et al.  Effects of temperature and confining pressure on mixed-mode (I–II) and mode II fracture toughness of Kimachi sandstone , 2014 .

[44]  Salvador Ivorra,et al.  Temperature influence on the physical and mechanical properties of a porous rock: San Julian's calcarenite , 2013 .

[45]  Y. Obara,et al.  Estimation of Fracture Toughness of Different Kinds of Rocks under Water Vapor Pressure by SCB Test , 2013 .

[46]  Jian Zhao,et al.  Effect of loading rate on fracture toughness and failure micromechanisms in marble , 2013 .

[47]  Y. Obara,et al.  ISRM-Suggested Method for Determining the Mode I Static Fracture Toughness Using Semi-Circular Bend Specimen , 2013, Rock Mechanics and Rock Engineering.

[48]  R. Azzam,et al.  Experimental study on the influence of temperature on the mechanical properties of granite under uni-axial compression and fatigue loading , 2012 .

[49]  Christophe Poinssot,et al.  Long-term Behavior Science: The cornerstone approach for reliably assessing the long-term performance of nuclear waste , 2012 .

[50]  Philip G. Meredith,et al.  Influence of macro-fractures and micro-fractures on permeability and elastic wave velocities in basalt at elevated pressure , 2011 .

[51]  Gye-Chun Cho,et al.  Geological storage of high level nuclear waste , 2011 .

[52]  H. Noferesti,et al.  Role of Crystal Interlocking on the Strength of Brittle Rocks , 2011 .

[53]  Shailendra Kumar,et al.  Effect of softening function on the cohesive crack fracture parameters of concrete CT specimen , 2009 .

[54]  Qian Du,et al.  An improved box-counting method for image fractal dimension estimation , 2009, Pattern Recognit..

[55]  C. A. Tang,et al.  Time-dependent strength degradation of granite , 2009 .

[56]  G. Grasselli,et al.  Fracture Toughness and Fracture Roughness Interrelationship in Thermally treated Westerly Granite , 2009 .

[57]  Heping Xie,et al.  Mechanical characteristics and microcosmic mechanisms of granite under temperature loads , 2008 .

[58]  E. Hamdi,et al.  A Fractal Description of Simulated 3D Discontinuity Networks , 2008 .

[59]  O. T. Bruhns,et al.  Simulating excavation damaged zone around a circular opening under hydromechanical conditions , 2008 .

[60]  Andrew Deeks,et al.  Fully-automatic modelling of cohesive crack growth using a finite element-scaled boundary finite element coupled method , 2007 .

[61]  Lanhe Yang.  Theoretical Analysis of the Coupling Effect for the Seepage Field, Stress Field, and Temperature Field in Underground Coal Gasification , 2005 .

[62]  D. D. Bruyn,et al.  The second phase of ATLAS: the continuation of a running THM test in the HADES underground research facility at Mol , 2002 .

[63]  Z. X. Zhang,et al.  An empirical relation between mode I fracture toughness and the tensile strength of rock , 2002 .

[64]  Man-Sung Yim,et al.  Materials issues in nuclear-waste management , 2000 .

[65]  Fergus G. F. Gibb,et al.  A new scheme for the very deep geological disposal of high‐level radioactive waste , 2000, Journal of the Geological Society.

[66]  C. Pater,et al.  Analysis of Hydraulic Fracture Closure in Laboratory Experiments , 2000 .

[67]  V. Palchik,et al.  The influence of grain size and porosity on crack initiation stress and critical flaw length in dolomites , 1997 .

[68]  N. Barton,et al.  Joint aperture and roughness in the prediction of flow and groutability of rock masses , 1997 .

[69]  P. Papanastasiou.  The influence of plasticity in hydraulic fracturing , 1997 .

[70]  D. H. Lee,et al.  High-temperature Brazilian test for tensile strength of metamorphic limestone , 1996 .

[71]  M. Xie,et al.  Energy-Based Cohesive Crack Propagation Modeling , 1995 .

[72]  W. J. Weber,et al.  Radiation effects in nuclear waste forms for high-level radioactive waste , 1995 .

[73]  F. Homand-Etienne,et al.  Thermally induced microcracking in granites: characterization and analysis , 1989 .

[74]  L. Hench.  International collaboration in nuclear waste solidification , 1986 .