Rate effect on mechanical properties of hydraulic concrete flexural-tensile specimens under low loading rates using acoustic emission technique.

Acoustic emission (AE) waveform is generated by dislocation, microcracking and other irreversible changes in a concrete material. Based on the AE technique (AET), this paper focuses on strain rate effect on physical mechanisms of hydraulic concrete specimens during the entire fracture process of three point bending (TPB) flexural tests at quasi-static levels. More emphasis is placed on the influence of strain rate on AE hit rate and AE source location around peak stress. Under low strain rates, namely 0.77×10(-7)s(-1), 1×10(-7)s(-1) to 1×10(-6)s(-1) respectively, the results show that the tensile strength increases as the strain rate increases while the peak AE hit rate decreases. Meanwhile, the specimen under a relatively higher strain rate shows a relatively wider intrinsic process zone in a more diffuser manner, lots of distributed microcracks relatively decrease stress intensity, thus delay both microcracking localization and macrocrack propagation. These phenomena can be attributed to Stéfan effect. In addition, further tests, namely the combination of AE monitoring and strain measuring systems was designed to understand the correlation between AE event activity and microfracture (i.e., microcracking and microcracking localization). The relative variation trend of cumulative AE events accords well with that of the load-deformation curve.

[1]  Giuseppe Lacidogna,et al.  Damage analysis of reinforced concrete buildings by the acoustic emission technique , 2011 .

[2]  Joseph F Labuz,et al.  Acoustic emission at failure in quasi-brittle materials , 2001 .

[3]  Surendra P. Shah,et al.  The influence of microcracking on the mechanical behavior of cement based materials , 1995 .

[4]  L. Tham,et al.  On Tension Failure of 2-D Rock Specimens and Associated Acoustic Emission , 2005 .

[5]  M. Ohtsu,et al.  Quantitative damage estimation of concrete by acoustic emission , 2001 .

[6]  B. Prasad,et al.  An experimental study on acoustic emission energy as a quantitative measure of size independent specific fracture energy of concrete beams , 2011 .

[7]  B. Prasad,et al.  Relationship between AE Energy and Fracture Energy of Plain Concrete Beams : Experimental Study , 2008 .

[8]  Timothy P. Dolen,et al.  Dynamic properties of mass concrete obtained from dam cores , 2000 .

[9]  Joseph F Labuz,et al.  Measurement of the intrinsic process zone in rock using acoustic emission , 1998 .

[10]  Sotirios J. Vahaviolos,et al.  Acoustic emission : standards and technology update , 1999 .

[11]  Pathegama Gamage Ranjith,et al.  A study of the effect of displacement rate and moisture content on the mechanical properties of concrete : Use of acoustic emission , 2008 .

[12]  Dongming Yan,et al.  Dynamic properties of concrete in direct tension , 2006 .

[13]  Jochen H Kurz,et al.  Strategies for reliable automatic onset time picking of acoustic emissions and of ultrasound signals in concrete. , 2005, Ultrasonics.

[14]  L. Javier Malvar,et al.  Review of Strain Rate Effects for Concrete in Tension , 1998 .

[15]  Bing Chen,et al.  Damage in carbon fiber-reinforced concrete, monitored by both electrical resistance measurement and acoustic emission analysis , 2008 .

[16]  G. Ruiz,et al.  Rate effect on the mechanical properties of eight types of high-strength concrete and comparison with FIB MC2010 , 2012 .

[17]  Bing Chen,et al.  Experimental study on AE characteristics of three-point-bending concrete beams , 2004 .

[18]  Giuseppe Lacidogna,et al.  Structural damage diagnosis and life-time assessment by acoustic emission monitoring , 2007 .

[19]  G. Ruiz,et al.  Effect of loading rate on crack velocities in HSC , 2010 .

[20]  B. Karihaloo,et al.  Verification of the applicability of lattice model to concrete fracture by AE study , 2010 .

[21]  Chunlin Li,et al.  Deformation of brittle rocks under compression - with particular reference to microcracks , 1993 .

[22]  E. Landis.  Micro–macro fracture relationships and acoustic emissions in concrete , 1999 .

[23]  Hyun-Do Yun,et al.  Acoustic emission activities and damage evaluation of reinforced concrete beams strengthened with CFRP sheets , 2010 .

[24]  Rena C. Yu,et al.  Fracture behaviour of high-strength concrete at a wide range of loading rates , 2009 .

[25]  F. Toutlemonde,et al.  Effect of loading rate on the tensile behaviour of concrete: description of the physical mechanisms , 1996 .