Crack propagation and defect formation at polymer interfaces investigated by ultra-small angle X-ray scattering

The double cantilever beam test (DCB) was used to estimate the fracture toughness of poly(methyl-methacrylate) (PMMA). With the help of given neutron reflectometry (NR) results for PMMA a correlation between fracture toughness and interface width was established. It displays a three regime behaviour similar to polystyrene (PS). For the first time, deformation and defect structures in the vicinity of the crack tip were investigated by scanning ultra-small angle X-ray scattering (S-USAX) where a beam from a synchrotron source is scanned over the sample. It is concluded that crack propagation during the DCB measurement is connected with large deformations and defect formation, where the plastic deformation zone extends over a large size (>400 μm). Following a model for scattering from diffuse boundaries it was concluded that the diffusiveness increases from the outer edges to the centre of the plastic zone. S-USAX thus provides details of sample failure at a microscopic level as well as information about the structure of the defect boundaries and their distribution across the plastic zone.

[1]  E. Kramer,et al.  Model for the fracture energy of glassy polymer–polymer interfaces , 2002 .

[2]  M. Robbins,et al.  Simulations of Crazing in Polymer Glasses: Effect of Chain Length and Surface Tension , 2001 .

[3]  H. Brown.  Relation between the width of an interface between two polymers and its toughness , 2001 .

[4]  T. Narayanan,et al.  Long-range density fluctuations in orthoterphenyl as studied by means of ultrasmall-angle x-ray scattering. , 2000, Physical review. E, Statistical physics, plasmas, fluids, and related interdisciplinary topics.

[5]  M. Stamm,et al.  Dewetting of Thin Polymer-Blend Films Examined with GISAS , 2000 .

[6]  David J. Lohse,et al.  Chain dimensions and entanglement spacings in dense macromolecular systems , 1999 .

[7]  M. Stamm,et al.  Mechanical Properties of Homopolymer Interfaces: Transition from Simple Pullout to Crazing with Increasing Interfacial Width , 1999 .

[8]  G. Salomons,et al.  Small‐angle X‐ray scattering analysis of craze‐fibril structures , 1999 .

[9]  A. Crosby,et al.  Axisymmetric adhesion tests of soft materials , 1998 .

[10]  M. Stamm,et al.  Direct Correlation between Interfacial Width and Adhesion in Glassy Polymers , 1998 .

[11]  E. Kramer,et al.  Fracture Toughness and Failure Mechanisms of Epoxy/Rubber-Modified Polystyrene (HIPS) Interfaces Reinforced by Grafted Chains , 1996 .

[12]  M. Stamm,et al.  Initial Stages of Interdiffusion of PMMA across an Interface , 1996 .

[13]  L. Léger,et al.  Effects of the Formation of Copolymer on the Interfacial Adhesion between Semicrystalline Polymers , 1996 .

[14]  E. Kramer,et al.  Effect of End-Anchored Chains on the Adhesion at a Thermoset-Thermoplastic Interface , 1995 .

[15]  H. Brown,et al.  Molecular Weight Effects in Chain Pullout , 1994 .

[16]  F. Brochard-Wyart,et al.  Dewetting and slippage of microscopic polymer films , 1994 .

[17]  J. Washiyama,et al.  Fracture mechanisms of polymer interfaces reinforced with block copolymers: transition from chain pullout to crazing , 1993 .

[18]  J. Washiyama,et al.  Transmission electron microscopic fracture studies of polymer interfaces , 1992 .

[19]  A. Ruina,et al.  Micromechanics of crack growth into a craze in a polymer glass , 1992 .

[20]  E. Kramer,et al.  Failure mechanisms of polymer interfaces reinforced with block copolymers , 1992 .

[21]  Reiter,et al.  Dewetting of thin polymer films. , 1992, Physical review letters.

[22]  Brochard-Wyart,et al.  Dynamics of dewetting. , 1991, Physical review letters.

[23]  D. Avnir,et al.  Small‐angle x‐ray scattering from the surfaces of reversed‐phase silicas: Power‐law scattering exponents of magnitudes greater than four , 1991 .

[24]  V. Deline,et al.  Characteristics of the surface-induced orientation for symmetric diblock PS/PMMA copolymers , 1989 .

[25]  R. Wool,et al.  Welding of polymer interfaces , 1989 .

[26]  Russell,et al.  Neutron reflectivity studies of the surface-induced ordering of diblock copolymer films. , 1989, Physical review letters.

[27]  A. Karim,et al.  Specular reflectivity of neutrons by thin polymer films , 1988 .

[28]  J. Koberstein,et al.  The determination of diffuse‐boundary thicknesses of polymers by small‐angle X‐ray scattering , 1980 .

[29]  E. W. Fischer,et al.  Röntgenkleinwinkel-Untersuchungen zur Struktur der Crazes (Fließzonen) in Polycarbonat und Polymethlmethacrylat , 1979 .

[30]  Hugh R. Brown,et al.  Adhesion and Fracture of Interfaces Between Immiscible Polymers: from the Molecular to the Continuum Scal , 2001 .

[31]  W. Press,et al.  X-ray and neutron reflectivity , 1998 .

[32]  E. Kramer,et al.  Strengthening polymer interfaces , 1994 .

[33]  E. Kramer,et al.  Analysis of a mixed mode fracture specimen: the asymmetric double cantilever beam , 1993, Journal of Materials Science.