An investigation into the modeling of railway fastening

Abstract In this paper, the influence of modeling the fastening with solid railpads on the vertical dynamics of railway tracks with monoblock sleepers is investigated. A 3D finite element (FE) model is presented with four different fastening representations: (1) commonly used spring-damper pair, (2) area covering spring-damper pairs, (3) solid railpad connected to the rail, and (4) solid railpad in frictional contact with the rail and fixed to the support by preloaded springs, which represent the clamps. The response of the four models to hammer excitation is simulated in the time domain, and the calculated response is transformed into the frequency domain to analyze how the models capture the seven main characteristics of tracks with monoblock sleepers. The numerical results show that the model with solid railpads and clamps reproduce the seven characteristics at a maximum frequency difference of 6%, while the conventional model with spring-damper pairs reaches only a 27%. In the improvement of the fit from multiple spring-damper railpad models to solid railpad models, the two key aspects identified are the Poisson׳s effect and the damping of the ballast. Additionally, the railpad type investigated showed a frequency-independent behavior, at least with acceptable error. In view of the close fit, the models with solid railpads can be used for track and fastening design and to derive track parameters to, for instance, study the deterioration of tracks.

[1]  T. X. Wu,et al.  a Double Timoshenko Beam Model for Vertical Vibration Analysis of Railway Track at High Frequencies , 1999 .

[2]  Nirmal Kumar Mandal,et al.  On the low cycle fatigue failure of insulated rail joints (IRJs) , 2014 .

[3]  Patrick Guillaume,et al.  Measurements of the dynamic railpad properties , 2006 .

[4]  Jens C. O. Nielsen,et al.  Prediction of dynamic train–track interaction and subsequent material deterioration in the presence of insulated rail joints , 2006 .

[5]  K. Knothe,et al.  An extended linear model for the prediction of short pitch corrugation , 1996 .

[6]  David Thompson,et al.  Developments of the indirect method for measuring the high frequency dynamic stiffness of resilient elements , 1998 .

[7]  R. Courant,et al.  Über die partiellen Differenzengleichungen der mathematischen Physik , 1928 .

[8]  Jens C. O. Nielsen,et al.  Rail corrugation in The Netherlands—measurements and simulations , 2002 .

[9]  Nirmal Kumar Mandal,et al.  Impact forces at dipped rail joints , 2016 .

[10]  Klaus Knothe,et al.  Receptance behaviour of railway track and subgrade , 1998 .

[11]  A. P. De Man,et al.  Dynatrack: A survey of dynamic railway track properties and their quality , 2002 .

[12]  Zili Li,et al.  Influence of the Fastening Modeling on the Vehicle-Track Interaction at Singular Rail Surface Defects , 2014 .

[13]  A. Igeland,et al.  Railhead Corrugation Growth Explained by Dynamic Interaction between Track and Bogie Wheelsets , 1996 .

[14]  David Thompson,et al.  Track Dynamic Behaviour at High Frequencies. Part 1: Theoretical Models and Laboratory Measurements , 1995 .

[15]  Zili Li,et al.  Identification of characteristic frequencies of damaged railway tracks using field hammer test measurements , 2015 .

[16]  D Lyon,et al.  THE EFFECT OF TRACK AND VEHICLE PARAMETERS ON WHEEL/RAIL VERTICAL DYNAMIC FORCES , 1974 .

[17]  Sayed Abas Ali,et al.  RAILWAY NOISE LEVELS, ANNOYANCE AND COUNTERMEASURES IN ASSIUT, EGYPT , 2005 .

[18]  Michel Villot,et al.  Modeling the influence of structural modifications on the response of a building to railway vibration , 2011 .

[19]  H. P. Yin,et al.  Numerical investigation of nonlinear properties of a rubber absorber in rail fastening systems , 2013 .

[20]  Jorge Ambrósio,et al.  Influence of track conditions and wheel wear state on the loads imposed on the infrastructure by railway vehicles , 2011 .

[21]  K Gylltoft,et al.  Infuence of cracked sleepers on the global track response: Coupling of a linear track model and nonlinear finite element analyses , 2002 .

[22]  J. N. Varandas,et al.  Dynamic behaviour of railway tracks on transitions zones , 2011 .

[23]  Franck Jourdan,et al.  A contact-area model for rail-pads connections in 2-D simulations: sensitivity analysis of train-induced vibrations , 2013 .

[24]  L. Gry,et al.  DYNAMIC MODELLING OF RAILWAY TRACK BASED ON WAVE PROPAGATION , 1996 .

[25]  M Fermér,et al.  Vertical Interaction between Train and Track with Soft and Stiff Railpads—Full-Scale Experiments and Theory , 1995 .

[26]  David J. Benson,et al.  A single surface contact algorithm for the post-buckling analysis of shell structures , 1990 .

[27]  C. Esveld,et al.  An investigation into the causes of squats—Correlation analysis and numerical modeling , 2008 .

[28]  Javad Sadeghi,et al.  Comparisons of the mechanical properties of timber, steel and concrete sleepers , 2010 .

[29]  Wu,et al.  The vibration behavior of railway track at high frequencies under multiple preloads and wheel interactions , 2000, The Journal of the Acoustical Society of America.

[30]  Rolf Dollevoet,et al.  An investigation into the vertical dynamics of tracks with monoblock sleepers with a 3D finite-element model , 2016 .

[31]  J Kalousek,et al.  Rail Corrugation: Characteristics, Causes and Treatments , 1993 .

[32]  Arnold D. Kerr,et al.  Analysis and tests of boned insulted rail joints subjected to vertical wheel loads , 1999 .

[33]  Sakdirat Kaewunruen,et al.  Field trials for dynamic characteristics of railway track and its components using impact excitation technique , 2007 .

[34]  Xuesong Jin,et al.  The effect of ring dampers on noise radiation from railway wheels , 2012 .

[35]  H. Ilias.  THE INFLUENCE OF RAILPAD STIFFNESS ON WHEELSET/TRACK INTERACTION AND CORRUGATION GROWTH , 1999 .

[36]  Jens C. O. Nielsen,et al.  Numerical prediction of rail roughness growth on tangent railway tracks , 2003 .

[37]  Javad Sadeghi.  Field Investigation on Vibration Behavior of Railway Track Systems , 2010 .

[38]  Reidun Ursin,et al.  A field study of effects of road traffic and railway noise on polysomnographic sleep parameters. , 2011, The Journal of the Acoustical Society of America.

[39]  Nirmal Kumar Mandal,et al.  Sub-modelling for the ratchetting failure of insulated rail joints , 2013 .

[40]  K. L. Johnson,et al.  The Dynamic Response of Railway Track to High Frequency Vertical Excitation , 1982 .