Development of highly effective cryogenic printed circuit heat exchanger (PCHE) with low axial conduction

Abstract This paper presents the results of an experimental investigation of the thermal and hydraulic performance of a printed circuit heat exchanger (PCHE) for use in the cryogenic temperature region. Compact PCHEs with multiple corrugated, longitudinal flow microchannels were fabricated using chemical etching and diffusion bonding to evaluate their thermal and hydraulic performance. The testing of the PCHEs was conducted with helium gas at cryogenic temperatures. The pressure drop and thermal effectiveness values obtained from the measured pressures and temperatures are discussed. The thermal performance was predominantly affected by the axial conduction heat transfer in the low Reynolds number ranges of theses experiments. A simple performance calculation model is presented, and the effectiveness calculated from the model is compared with the experimental data. The design of the cryogenic PCHE was then modified to reduce axial conduction losses.

[1]  Jan Fokkens,et al.  Promising designs of compact heat exchangers for modular HTRs using the Brayton cycle , 2008 .

[2]  Miko Elwenspoek,et al.  Pressure drop of laminar gas flows in a microchannel containing various pillar matrices , 2007 .

[3]  Konstantin Nikitin,et al.  New printed circuit heat exchanger with S-shaped fins for hot water supplier , 2006 .

[4]  Ashesh Tiwari,et al.  Second law analysis of counter flow cryogenic heat exchangers in presence of ambient heat-in-leak and longitudinal conduction through wall , 2007 .

[5]  Gadhiraju Venkatarathnam,et al.  Performance degradation due to longitudinal heat conduction in very high NTU counterflow heat exchangers , 1998 .

[6]  Carlton Gamer.  Colorado Springs, Colorado , 1973 .

[7]  Y. Kato,et al.  Printed circuit heat exchanger thermal–hydraulic performance in supercritical CO2 experimental loop , 2006 .

[8]  T. T. Veenstra,et al.  Optimization of counterflow heat exchanger geometry through minimization of entropy generation , 2005 .

[9]  Jae Eun Cha,et al.  Numerical investigation on thermal–hydraulic performance of new printed circuit heat exchanger model ☆ , 2008 .

[10]  M. McLinden,et al.  NIST Standard Reference Database 23: Reference Fluid Thermodynamic and Transport Properties-REFPROP, Version 8.0 , 2007 .

[11]  G. Peterson,et al.  Convective heat transfer and flow friction for water flow in microchannel structures , 1996 .

[12]  S. Sarangi,et al.  Performance of Cryogenic Heat Exchangers with Heat Leak from the Surroundings , 1984 .

[13]  Gregory Nellis,et al.  A heat exchanger model that includes axial conduction, parasitic heat loads, and property variations , 2003 .

[14]  David Reay,et al.  Compact Heat Exchangers: Selection, Design and Operation , 2001 .

[15]  Performance of a counterflow heat exchanger with heat loss through the wall at the cold end , 1999 .

[16]  Yasuyoshi Kato,et al.  High performance printed circuit heat exchanger , 2007 .