Adhesion Strength of Settled Spores of the Green Alga Enteromorpha

Strengths of attachment of spores of the green fouling alga Enteromorpha to glass have been measured using a modified water jet apparatus. Surface pressures of ∼250 kPa were required to quantitatively remove attached spores after 4 h contact with a surface. The development of adhesive and cohesive strength is highly time-dependent; after 8 h in contact with a surface spores did not detach, even at pressures in excess of 250 kPa. Spores settled in groups are more resistant to detachment than single spores, which suggests that the adaptive value of gregarious settlement behaviour may lie in the greater resistance of groups to detachment forces in a naturally turbulent environment. The interfacial forces exerted as water impinges on the surface and the derivation of adhesion strength values in terms of wall shear stress are discussed and compared with those obtained by other methods. A surface pressure of 250 kPa approximates to 325 Pa wall shear stress. Calculation using the power-law formula predicts that detachment forces of this magnitude are unlikely to be realized at operating speeds for most vessels and that most Enteromorpha spores would not detach from untreated hulls.

[1]  M. Callow,et al.  Marine biofouling: a sticky problem. , 2002, Biologist.

[2]  Maureen E. Callow,et al.  Microtopographic Cues for Settlement of Zoospores of the Green Fouling Alga Enteromorpha , 2002 .

[3]  J. Callow,et al.  Brefeldin A affects adhesion of zoospores of the green alga Enteromorpha. , 2001, Journal of experimental botany.

[4]  M. Schultz,et al.  Variation in adhesion strength of Balanus eburneus, crassostrea virginica and hydroides dianthus to fouling‐release coatings , 2001 .

[5]  Richard Wetherbee,et al.  Cellular and molecular approaches to understanding primary adhesion in Enteromorpha: an overview , 2000 .

[6]  P. Mulvaney,et al.  The application of atomic force microscopy to topographical studies and force measurements on the secreted adhesive of the green alga Enteromorpha , 2000, Planta.

[7]  Maureen E. Callow,et al.  A turbulent channel flow apparatus for the determination of the adhesion strength of microfouling organisms , 2000 .

[8]  Antonio Terlizzi,et al.  Biological succession on silicone fouling‐release surfaces: Long‐term exposure tests in the harbour of ischia, Italy , 2000 .

[9]  Maureen E. Callow,et al.  Use of Self-Assembled Monolayers of Different Wettabilities To Study Surface Selection and Primary Adhesion Processes of Green Algal (Enteromorpha) Zoospores , 2000, Applied and Environmental Microbiology.

[10]  M. Stanley,et al.  Monoclonal antibodies to adhesive cell coat glycoproteins secreted by zoospores of the green alga Enteromorpha , 1999, Planta.

[11]  L. Walters,et al.  Endoscopic observations of invertebrate larval substratum exploration and settlement , 1999 .

[12]  M. Schultz,et al.  Hydrodynamic forces on barnacles: Implications on detachment from fouling‐release surfaces , 1999 .

[13]  Richard Wetherbee,et al.  PRIMARY ADHESION OF ENTEROMORPHA (CHLOROPHYTA, ULVALES) PROPAGULES: QUANTITATIVE SETTLEMENT STUDIES AND VIDEO MICROSCOPY 1 , 1997 .

[14]  M. Schultz,et al.  The testing and evaluation of non-toxic antifouling coatings. , 1996, Biofouling.

[15]  K. Becker Attachment strength and colonization patterns of two macrofouling species on substrata with different surface tension (in situ studies) , 1993 .

[16]  J. Schetz Boundary Layer Analysis , 1992 .

[17]  M. Hadfield Settlement and recruitment of marine invertebrates: a perspective and some proposals , 1986 .

[18]  Nallamuthu Rajaratnam,et al.  Impinging Circular Turbulent Jets , 1974 .