Solar Still Efficiency Enhancement by Using Graphene Oxide/Paraffin Nano-PCM

Solar-driven water desalination technologies are rapidly developing with various links to other renewable sources. However, the efficiency of such systems severely depends on the design parameters. The present study focused on using graphene oxide (GO) with the Φ = 0.2, 0.4 and 0.6 wt.% dispersed in paraffin, as phase-change materials (PCMs), to improve the productivity of a solar still for desalination applications. The outcomes showed that by adding more graphene oxide to paraffin, the melting temperature got reduced. Solar still with GO/paraffin showed 25% productivity improvement in comparison with the solar still with only PCM. The obtained Nusselt number during the melting time also represented that free convection heat transfer into the melted region of the solar still has been enhanced by adding dispersed GO to the PCM, compared to the base paraffin. Also, increasing the hot wall temperature augments the Nusselt number. Finally, an empirical equation was derived to correlate the average Nusselt number as a function of Rayleigh number (Ra), the Stefan number (Ste), the subcooling factor (Sb), and the Fourier number (Fo). The obtained correlation depicted that Nusselt number enhancement has a reverse relation with Fourier number.

[1]  Saman Rashidi,et al.  Volume of fluid model to simulate the nanofluid flow and entropy generation in a single slope solar still , 2018 .

[2]  Nadia Zari,et al.  Exergy analysis of solar desalination still combined with heat storage system using phase change material (PCM) , 2016 .

[3]  Carlo Roselli,et al.  Desiccant-Based Air Handling Unit Alternatively Equipped with Three Hygroscopic Materials and Driven by Solar Energy , 2019, Energies.

[4]  Halime Paksoy,et al.  Improving thermal conductivity phase change materials—A study of paraffin nanomagnetite composites , 2015 .

[5]  N. Pu,et al.  Improving the thermal conductivity and shape-stabilization of phase change materials using nanographite additives , 2013 .

[6]  Mohammad Reza Safaei,et al.  Diurnal thermal evaluation of an evacuated tube solar collector (ETSC) charged with graphene nanoplatelets-methanol nano-suspension , 2019, Renewable Energy.

[7]  Rahman Saidur,et al.  A review on supercooling of Phase Change Materials in thermal energy storage systems , 2017 .

[8]  Mohammad Behshad Shafii,et al.  Experimental investigation of a solar still equipped with an external heat storage system using phase change materials and heat pipes , 2017 .

[9]  M. Sheikholeslami.  Numerical simulation for solidification in a LHTESS by means of nano-enhanced PCM , 2018 .

[10]  D. Das,et al.  Numerical study of fluid dynamic and heat transfer performance of Al2O3 and CuO nanofluids in the flat tubes of a radiator , 2010 .

[11]  A. Shahsavar,et al.  A novel comprehensive experimental study concerned synthesizes and prepare liquid paraffin-Fe3O4 mixture to develop models for both thermal conductivity & viscosity: A new approach of GMDH type of neural network , 2019, International Journal of Heat and Mass Transfer.

[12]  Emmanuel C. Nsofor,et al.  Solidification of a PCM with nanoparticles in triplex-tube thermal energy storage system , 2016 .

[13]  S. Jegadheeswaran,et al.  Performance investigation on fin type solar still with paraffin wax as energy storage media , 2018, Journal of Thermal Analysis and Calorimetry.

[14]  Iskander Tlili,et al.  Potential of Solar Collectors for Clean Thermal Energy Production in Smart Cities using Nanofluids: Experimental Assessment and Efficiency Improvement , 2019, Applied Sciences.

[15]  Feifei Peng,et al.  Synthesis, characterization and thermal properties of paraffin microcapsules modified with nano-Al2O3 , 2015 .

[16]  M. Shahedi,et al.  Thermal behavior of paraffin-nano-Al2O3 stabilized by sodium stearoyl lactylate as a stable phase change material with high thermal conductivity , 2016 .

[17]  K. Sampathkumar,et al.  Utilization of solar water heater in a single basin solar still—An experimental study , 2012 .

[18]  Akash Kumar Shukla,et al.  Design, simulation and economic analysis of standalone roof top solar PV system in India , 2016 .

[19]  S. Mahmud,et al.  Melting of nano-PCM inside a cylindrical thermal energy storage system: Numerical study with experimental verification , 2018, Energy Conversion and Management.

[20]  H. Masjuki,et al.  Theoretical analysis to determine the efficiency of a CuO-water nanofluid based-flat plate solar collector for domestic solar water heating system in Myanmar , 2017 .

[21]  A. Sharma,et al.  Review on thermal energy storage with phase change materials and applications , 2009 .

[22]  Min Li.  A nano-graphite/paraffin phase change material with high thermal conductivity , 2013 .

[23]  R. Ellahi,et al.  Convection of heat and thermodynamic irreversibilities in two-phase, turbulent nanofluid flows in solar heaters by corrugated absorber plates , 2018, Advanced Powder Technology.

[24]  J. Kenny,et al.  Effect of nanoparticles on heat capacity of nanofluids based on molten salts as PCM for thermal energy storage , 2013, Nanoscale Research Letters.

[25]  M. Sheikholeslami.  Numerical modeling of nano enhanced PCM solidification in an enclosure with metallic fin , 2018, Journal of Molecular Liquids.

[26]  Arun S. Mujumdar,et al.  Numerical study on melting of paraffin wax with Al2O3 in a square enclosure , 2012 .

[27]  Yu Chen,et al.  Numerical Simulation and Optimization of the Melting Process of Phase Change Material inside Horizontal Annulus , 2017 .

[28]  M. Udayakumar,et al.  Experimental study of enhanced heat transfer by addition of CuO nanoparticle , 2012 .

[29]  G. Song,et al.  The experimental exploration of nano-Si3N4/paraffin on thermal behavior of phase change materials , 2014 .

[30]  Chi-Ming Lai,et al.  Thermal Performance of Microencapsulated Phase Change Material (mPCM) in Roof Modules during Daily Operation , 2018 .

[31]  Mohammad Hossein Ahmadi,et al.  Application of Nanofluids in Thermal Performance Enhancement of Parabolic Trough Solar Collector: State-of-the-Art , 2019, Applied Sciences.

[32]  Ronald J. Warzoha,et al.  Temperature-dependent thermal properties of a paraffin phase change material embedded with herringbone style graphite nanofibers , 2015 .

[33]  Saerom Kim,et al.  Thermo-Fluid Dynamic Effects of the Radial Location of the Baffle Installed in a Solar Updraft Tower , 2019 .

[34]  Nasrudin Abd Rahim,et al.  Novel approaches and recent developments on potential applications of phase change materials in solar energy , 2018 .

[35]  M. Abdollahzadeh,et al.  Enhancement of phase change material (PCM) based latent heat storage system with nano fluid and wavy surface , 2015 .

[36]  G. Goudarzi,et al.  Estimation of Short-term Mortality and Morbidity Attributed to Fine Particulate Matter in the Ambient Air of Eight Iranian Cities , 2018, Annals of global health.

[37]  Ching-Jenq Ho,et al.  An experimental study on melting heat transfer of paraffin dispersed with Al2O3 nanoparticles in a vertical enclosure , 2013 .

[38]  K. Cen,et al.  Effects of various carbon nanofillers on the thermal conductivity and energy storage properties of paraffin-based nanocomposite phase change materials , 2013 .

[39]  Nasiru I. Ibrahim,et al.  A review on current status and challenges of inorganic phase change materials for thermal energy storage systems , 2017 .

[40]  Ruiqi Wang,et al.  Comparative Analysis of Small-Scale Organic Rankine Cycle Systems for Solar Energy Utilisation , 2019, Energies.

[41]  A. E. Kabeel,et al.  Improving the performance of solar still by using PCM as a thermal storage medium under Egyptian conditions , 2016 .

[42]  Jung-Hyun Kim,et al.  Magnetic nanoparticle-embedded PCM nanocapsules based on paraffin core and polyurea shell , 2014 .

[43]  L. Suganthi,et al.  Nanoparticles Enhanced Phase Change Material (NPCM) as Heat Storage in Solar Still Application for Productivity Enhancement , 2017 .