Direct active and reactive power control of DFIG for wind energy generation

This paper presents a new direct power control (DPC) strategy for a doubly fed induction generator (DFIG)-based wind energy generation system. The strategy is based on the direct control of stator active and reactive power by selecting appropriate voltage vectors on the rotor side. It is found that the initial rotor flux has no impact on the changes of the stator active and reactive power. The proposed method only utilizes the estimated stator flux so as to remove the difficulties associated with rotor flux estimation. The principles of this method are described in detail in this paper. The only machine parameter required by the proposed DPC method is the stator resistance whose impact on the system performance is found to be negligible. Simulation results on a 2 MW DFIG system are provided to demonstrate the effectiveness and robustness of the proposed control strategy during variations of active and reactive power, rotor speed, machine parameters, and converter dc link voltage

[1]  Adrian David Cheok,et al.  A new torque and flux control method for switched reluctance motor drives , 2002 .

[2]  Lie Xu,et al.  A flying capacitor multilevel PWM converter based UPFC , 2001, 2001 IEEE 32nd Annual Power Electronics Specialists Conference (IEEE Cat. No.01CH37230).

[3]  Aleksandar M. Stankovic,et al.  Analysis and design of direct power control (DPC) for a three phase synchronous rectifier via output regulation subspaces , 2003 .

[4]  Jon Clare,et al.  Doubly fed induction generator using back-to-back PWM converters and its application to variable-speed wind-energy generation , 1996 .

[5]  Marian P. Kazmierkowski,et al.  Direct torque control of PWM inverter-fed AC motors - a survey , 2004, IEEE Transactions on Industrial Electronics.

[6]  Toshihiko Noguchi,et al.  A New Quick-Response and High-Efficiency Control Strategy of an Induction Motor , 1986, IEEE Transactions on Industry Applications.

[7]  Yoshihiro Murai,et al.  New PWM Method for Fully Digitized Inverters , 1987, IEEE Transactions on Industry Applications.

[8]  R. W. De Doncker,et al.  Doubly fed induction generator systems for wind turbines , 2002 .

[9]  中川 博人,et al.  Controller for a wound-rotor induction machine , 1986 .

[10]  L.M. Tolbert,et al.  Direct torque control of induction machines using space vector modulation , 1991, Conference Record of the 1991 IEEE Industry Applications Society Annual Meeting.

[11]  K. W. Lim,et al.  Analysis of direct torque control in permanent magnet synchronous motor drives , 1997 .

[12]  H. van der Broeck,et al.  Analysis and Realization of a Pulse Width Modulator Based on Voltage Space Vectors , 1986, 1986 Annual Meeting Industry Applications Society.

[13]  Vassilios G. Agelidis,et al.  A flying capacitor multilevel converter based UPFC , 2002 .

[14]  M. P. Kazmierkowski,et al.  Improved direct torque and flux vector control of PWM inverter-fed induction motor drives , 1995, IEEE Trans. Ind. Electron..

[15]  Peter Vas,et al.  Sensorless vector and direct torque control , 1998 .

[16]  Mariusz Malinowski,et al.  Virtual flux based direct power control of three-phase PWM rectifiers , 2000, Conference Record of the 2000 IEEE Industry Applications Conference. Thirty-Fifth IAS Annual Meeting and World Conference on Industrial Applications of Electrical Energy (Cat. No.00CH37129).

[17]  A.F. Payam,et al.  Robust Speed Sensorless Control of Doubly-Fed Induction Machine Based on Input-Output Feedback Linearization Control Using a Sliding-Mode Observer , 2006, 2006 International Conference on Power Electronic, Drives and Energy Systems.

[18]  Hirofumi Akagi,et al.  Control and performance of a doubly-fed induction machine intended for a flywheel energy storage system , 2002 .

[19]  Abdelkrim Benchaib,et al.  Analysis of a robust DC-bus voltage control system for a VSC transmission scheme , 2001 .

[20]  Toshihiko Noguchi,et al.  Direct power control of PWM converter without power source voltage sensors , 1996, IAS '96. Conference Record of the 1996 IEEE Industry Applications Conference Thirty-First IAS Annual Meeting.

[21]  M. Depenbrock,et al.  Direct self control of inverter-fed induction machine, a basis for speed control without speed-measurement , 1989, Conference Record of the IEEE Industry Applications Society Annual Meeting,.

[22]  M. Depenbrock,et al.  Direct self-control (DSC) of inverter-fed induction machine , 1988 .