Surface Activated Bonding --- High Density Packaging Solution for Advanced Microelectronic System

Surface activated bonding (SAB) was a recently developed high density interconnection method for advanced microelectronic system. SAB bonding was proposed based on the simple principle that two surface activated materials could be easily bonded together at the room temperature or low temperature. The surfaces were activated by fast atom beam or plasma irradiation source which has been proved helpful to remove the oxide and organic layer covering on the material surface. Chip-on-chip (COC), as an important application of SAB flip chip method, will be discussed in this paper. To investigate the SAB bonding feasibility, some electrically plated Au micro-bumps which have a size of 4Ox4Ox3Qim33 were prepared on the silicon chip and bonded with Au, Al or Cu pads with a thickness of about 0.3pim on another silicon chip. Electrical measurement, shear test and thermal aging (423K) data demonstrated the fine performance for SAB interconnection. It was found even the bonded chip-chip system was die separated, SAB achieved Au bump-metal pad interconnection was remained well. As bonding is carried out at the room temperature or low temperature and the material is surface activated before, no intermediate layer or impurity particle will exist at the as-bonded interface.

[1]  Y. L. Low,et al.  Electrical performance of chip-on-chip modules , 1999 .

[2]  T. Itoh,et al.  New Au-Al interconnect technology and its reliability by surface activated bonding , 2003, Fifth International Conference onElectronic Packaging Technology Proceedings, 2003. ICEPT2003..

[3]  R.R. Tummala,et al.  Next-generation microvia and global wiring technologies for SOP , 2004, IEEE Transactions on Advanced Packaging.

[4]  Y.L. Low,et al.  Electrical performance of chip-on-chip modules , 1998, IEEE 7th Topical Meeting on Electrical Performance of Electronic Packaging (Cat. No.98TH8370).

[5]  Kazumasa Tanida,et al.  Micro Cu Bump Interconnection on 3D Chip Stacking Technology , 2004 .

[6]  T. Itoh,et al.  Surface activated bonding for new flip chip and bumpless interconnect systems , 2002, 52nd Electronic Components and Technology Conference 2002. (Cat. No.02CH37345).

[7]  T. Itoh,et al.  Reliability and microstructure of Au-Al and Au-Cu direct bonding fabricated by the Surface Activated Bonding , 2002, Electronic Components and Technology Conference.