Performance assessment of carbonation process integrated with coal fired power plant to reduce CO2 (carbon dioxide) emissions

This paper presents a novel approach to recover energy from mineral carbonation process, one of the CCS (carbon capture and storage) technologies, to reduce its additional energy demand and reports the feasibility of integrating a carbonation process with an existing power plant for reducing CO2 (carbon dioxide) emission. A thermodynamic mass and energy flow model of the carbonation process is developed using Matlab/Simulink software for a range of carbonation temperatures using two naturally available feedstocks, namely serpentine and olivine. The CO2 emissions are reduced if a carbonation system is implemented in the power plant, though the power generation efficiency and net power output are reduced too due to the large amount of extra energy required for the grinding of feedstock and the compression of CO2. The existing power plant efficiency was found to be 36.1%. If a carbonation system is incorporated, the plant efficiency reduces to 22% and 24% using serpentine and olivine feedstocks respectively. However, a significant amount of heat energy can be recovered from exothermic reaction of carbonation and carbonated products. The power plant efficiency can be increased to 35% and 34% again, respectively, when energy from carbonation reaction and carbonated products can be recovered appropriately.

[1]  Hartmut Spliethoff,et al.  Assessment of oxy-fuel, pre- and post-combustion-based carbon capture for future IGCC plants , 2012 .

[2]  R. Baciocchi,et al.  Gas–solid carbonation kinetics of Air Pollution Control residues for CO2 storage , 2009 .

[3]  E. Rubin,et al.  A technical and economic assessment of ammonia-based post-combustion CO2 capture at coal-fired power plants , 2011 .

[4]  Yann Le Moullec,et al.  Assessment of carbon capture thermodynamic limitation on coal-fired power plant efficiency , 2012 .

[5]  Mohammad. Rasul,et al.  Energy recovery opportunities from mineral carbonation process in coal fired power plant , 2013 .

[6]  Ibrahim Dincer,et al.  Exergy analysis of a thermal power plant with measured boiler and turbine losses , 2010 .

[7]  Amornvadee Veawab,et al.  Integration of CO2 capture unit using single- and blended-amines into supercritical coal-fired power plants: Implications for emission and energy management , 2007 .

[8]  Paul Feron,et al.  Exploring the potential for improvement of the energy performance of coal fired power plants with post-combustion capture of carbon dioxide , 2010 .

[9]  P. James.  The future of coal , 1982 .

[10]  Dan Zhang,et al.  Techno-economic analysis of a 300 MWe coal-fired power plant retrofitted with post-combustion CO2 capture , 2012 .

[11]  Jeremy K. Leggett,et al.  Global warming: The Greenpeace report , 1990 .

[12]  Jon Gibbins,et al.  On the integration of CO2 capture with coal-fired power plants: A methodology to assess and optimise solvent-based post-combustion capture systems , 2011 .

[13]  Dalia Patiño-Echeverri,et al.  Expert assessments of retrofitting coal-fired power plants with carbon dioxide capture technologies , 2011 .

[14]  G. Versteeg,et al.  CO2 capture from power plants. Part I: A parametric study of the technical performance based on monoethanolamine , 2007 .

[15]  Li Zheng,et al.  How polygeneration schemes may develop under an advanced clean fossil fuel strategy under a joint sino-European initiative , 2009 .

[16]  G. E. Rush,et al.  Mineral carbonation: energy costs of pretreatment options and insights gained from flow loop reaction studies , 2004 .

[17]  Alexandre Szklo,et al.  Integrated gasification combined cycle and carbon capture: A risky option to mitigate CO2 emissions of coal-fired power plants , 2011 .

[18]  Haiwen Liang,et al.  Economic analysis of amine based carbon dioxide capture system with bi-pressure stripper in supercritical coal-fired power plant , 2011 .

[19]  Don W. Green,et al.  Perry's Chemical Engineers' Handbook , 2007 .

[20]  Bin Huang,et al.  Industrial test and techno-economic analysis of CO2 capture in Huaneng Beijing coal-fired power station , 2010 .

[21]  Wouter J. J. Huijgen,et al.  Carbon dioxide sequestration by mineral carbonation , 2007 .

[22]  Paul Feron,et al.  Impact of liquid absorption process development on the costs of post-combustion capture in Australian coal-fired power stations , 2011 .

[23]  Geoff F Brent,et al.  CO2 Sequestration by Mineral Carbonation in the Australian Context , 2008 .

[24]  Marc A. Rosen,et al.  Viewpoint article Can exergy help us understand and address environmental concerns , 2002 .

[25]  M. J. Moran,et al.  Fundamentals of Engineering Thermodynamics , 2014 .

[26]  Meihong Wang,et al.  Hybrid coal-fired power plants with CO2 capture: A technical and economic evaluation based on computational simulations , 2012 .

[27]  Giampaolo Manfrida,et al.  The environmental impact of post-combustion CO2 capture with MEA, with aqueous ammonia, and with an aqueous ammonia-ethanol mixture for a coal-fired power plant , 2011 .

[28]  Amitava Datta,et al.  Exergy-based performance analysis for proper O&M decisions in a steam power plant , 2010 .