Stop Criteria for Flexure for Proof Load Testing of Reinforced Concrete Structures

Existing bridges with large uncertainties can be assessed with a proof load test. In a proof load test, a load representative of the factored live load is applied to the bridge at the critical position. If the bridge can carry this load without distress, the proof load test shows experimentally that the bridge fulfills the requirements of the code. Because large loads are applied during proof load tests, the structure or element that is tested needs to be carefully monitored during the test. The monitored structural responses are interpreted in terms of stop criteria. Existing stop criteria for flexure in reinforced concrete can be extended with theoretical considerations. These proposed stop criteria are then verified with experimental results: reinforced concrete beams failing in flexure and tested in the laboratory, a collapse test on an existing reinforced concrete slab bridge that reached flexural distress, and the pilot proof load tests that were carried out in the Netherlands and in which no distress was observed. The tests in which failure was obtained are used to evaluate the margin of safety provided by the proposed stop criteria. The available pilot proof load tests are analyzed to see if the proposed stop criteria are not overly conservative. The result of this comparison is that the stop criteria are never exceeded. Therefore, the proposed stop criteria can be used for proof load tests for the failure mode of bending moment in reinforced concrete structures.

[1]  DA Dick Hordijk,et al.  Ruytenschildt Bridge: Field and laboratory testing , 2016 .

[2]  DA Dick Hordijk,et al.  Determination of Loading Protocol and Stop Criteria for Proof Loading with Beam Tests , 2018 .

[3]  A. de Boer,et al.  Beam Experiments on Acceptance Criteria for Bridge Load Tests , 2017 .

[4]  A. de Boer,et al.  Development of Stop Criteria for Proof Loading , 2016 .

[5]  Eva O. L. Lantsoght,et al.  Levels of approximation for the shear assessment of reinforced concrete slab bridges , 2017 .

[6]  H Gesund,et al.  ANOTHER LOOK AT CRACKING AND CRACK CONTROL IN REINFORCED CONCRETE. DISCUSSION AND CLOSURE , 2000 .

[7]  Ane de Boer,et al.  Required proof load magnitude for probabilistic field assessment of viaduct De Beek , 2017 .

[8]  DA Dick Hordijk,et al.  Probabilistic prediction of the failure mode of the Ruytenschildt Bridge , 2016 .

[9]  L Frýba,et al.  Load tests and modal analysis of bridges , 2001 .

[10]  Cor van der Veen,et al.  Proof load testing of reinforced concrete slab bridges in the Netherlands , 2017 .

[11]  DA Dick Hordijk,et al.  Development of recommendations for proof load testing of reinforced concrete slab bridges , 2017 .

[12]  Ane de Boer,et al.  Collapse test and moment capacity of the Ruytenschildt reinforced concrete slab bridge , 2017 .

[13]  Michael Havbro Faber,et al.  Proof load testing for bridge assessment and upgrading , 2000 .

[14]  Cor van der Veen,et al.  Pilot Proof-Load Test on Viaduct De Beek: Case Study , 2017 .

[15]  Robert J. Frosch,et al.  Another Look at Cracking and Crack Control in Reinforced Concrete , 1999 .

[16]  David V. Jáuregui,et al.  Load Rating a Prestressed Concrete Double T-Beam Bridge without Plans by Field Testing , 2015 .

[17]  Tadeusz Uhl,et al.  Structure's Condition Monitoring Based on Optical Measurements , 2012 .

[18]  Pinar Okumus,et al.  Evaluation of Concrete Bridge Behavior through Load Testing: International Perspectives , 2018 .

[19]  Philip Skov Halding,et al.  High Magnitude Loading of Concrete Bridges , 2018 .

[20]  Marek Wazowski,et al.  Bridge Load Tests in Poland Today and Tomorrow – The Standard and the New Ways in Measuring and Research to Ensure Transport Safety , 2017 .

[21]  Ane de Boer,et al.  Towards standardisation of proof load testing: pilot test on viaduct Zijlweg , 2018 .

[22]  DA Dick Hordijk,et al.  State-of-the-art on load testing of concrete bridges , 2017 .

[23]  P. Schwesinger,et al.  Das Belastungsfahrzeug BELFA fuer die experimentelle Tragsicherheitsbewertung von Massivbruecken und Abwasserkanaelen , 2001 .

[24]  Xin Chen.  Critical Proof Load for Proof Load Testing of Concrete Bridges based on Scripted FEM Analysis , 2017 .

[25]  E.O.L. Lantsoght,et al.  Monitoring crack width and strain during proof load testing , 2018, Maintenance, Safety, Risk, Management and Life-Cycle Performance of Bridges.

[26]  Alojz Kopácik.  LOADING TESTS OF HIGHWAY BRIDGES IN SLOVAKIA , 2003 .

[27]  A. de Boer,et al.  Shear and Moment Capacity of the Ruytenschildt Bridge , 2016 .