A New Approach to Optimization of Cogeneration Systems Using Genetic Algorithm

Application of Cogeneration systems based gas turbine for heat and power production is increasing. Because of finite natural energy resources and increasing energy demand the cost effective design of energy systems is essential. CGAM problem as a cogeneration system is considered here for analyzing. Two new approaches are considered, first in thermodynamic model of gas turbine and cogeneration system considering blade cooling of gas turbine and second using genetic algorithm for optimization. The problem has been optimized from thermodynamic and Thermoeconomic view point. Results show that Turbine Inlet Temperature (TIT) in thermodynamic optimum condition is higher than thermoeconomic one, while blade cooling technology must be better for optimum thermodynamic condition. Heat recovery of recuperator is lower in thermoeconomic case; also, stack temperature is higher relative to thermodynamic case. The sensitivity of the optimal solution to the decision variables is studied. It has been shown that while for both thermodynamic and thermoeconomic optimum condition, pressure ratio, blade cooling technology factor and pinch-point temperature difference (only for thermoeconomic case) has the lowest effect, turbomachinary efficiencies (epically compressor polytropic efficiency) have the major effect on performance of cycle. Finally; a new product known as Mercury 50 gas turbine is studied for a cogeneration system and it has been optimized thermoeconomicly. Results show good agreement with manufacturer data.Copyright © 2006 by ASME

[1]  George Tsatsaronis,et al.  Exergoeconomic evaluation and optimization of energy systems — application to the CGAM problem , 1994 .

[2]  H. Auracher.  Thermal design and optimization , 1996 .

[3]  R. W. Foster-Pegg,et al.  Capital cost of gas-turbine heat-recovery boilers , 1986 .

[4]  M. A. El-Masri.  Exergy Analysis of Combined Cycles: Part 1—Air-Cooled Brayton-Cycle Gas Turbines , 1987 .

[5]  Hiwa Khaledi,et al.  Effect of Inlet Air Cooling by Absorption Chiller on Gas Turbine and Combined Cycle Performance , 2005 .

[6]  M. El-Masri.  On Thermodynamics of Gas-Turbine Cycles: Part 2—A Model for Expansion in Cooled Turbines , 1986 .

[7]  Kristin Jordal.  Modeling and Performance of Gas Turbine Cycles with Various Means of Blade Cooling , 2001 .

[8]  Olav Bolland,et al.  Comparative Evaluation of Combined Cycles and Gas Turbine Systems With Water Injection, Steam Injection, and Recuperation , 1995 .

[9]  Christos A. Frangopoulos,et al.  Application of the thermoeconomic functional approach to the CGAM problem , 1994 .

[10]  Alberto Traverso,et al.  WIDGET-TEMP: A Novel Web-Based Approach for Thermoeconomic Analysis and Optimization of Conventional and Innovative Cycles , 2004 .

[11]  Kristin Jordal,et al.  Aspects of Cooled Gas Turbine Modeling for the Semi-Closed O2/CO2 Cycle With CO2 Capture , 2004 .

[12]  George Tsatsaronis,et al.  Iterative exergoeconomic evaluation and improvement of thermal power plants using fuzzy inference systems , 2002 .

[13]  M. El-Masri.  On Thermodynamics of Gas-Turbine Cycles: Part 3—Thermodynamic Potential and Limitations of Cooled Reheat-Gas-Turbine Combined Cycles , 1986 .

[14]  J. B. Young,et al.  The effect of turbine blade cooling on the cycle efficiency of gas turbine power cycles , 2005 .

[15]  G. T. Polley,et al.  Maximize Fuel Efficiency of Cogeneration Systems , 2000 .

[16]  M. A. El-Masri,et al.  GASCAN ― an interactive code for thermal analysis of gas turbine systems , 1988 .