Effect of nanofluids on the thermal performance of a flat micro heat pipe with a rectangular grooved wick

Abstract In this paper, the effect of water-based Al2O3 nanofluids as working fluid on the thermal performance of a flat micro-heat pipe with a rectangular grooved wick is investigated. For the purpose, the axial variations of the wall temperature, the evaporation and condensation rates are considered by solving the one-dimensional conduction equation for the wall and the augmented Young–Laplace equation for the phase change process. In particular, the thermophysical properties of nanofluids as well as the surface characteristics formed by nanoparticles such as a thin porous coating are considered. From the comparison of the thermal performance using both DI water and nanofluids, it is found that the thin porous coating layer formed by nanoparticles suspended in nanofluids is a key effect of the heat transfer enhancement for the heat pipe using nanofluids. Also, the effects of the volume fraction and the size of nanoparticles on the thermal performance are studied. The results shows the feasibility of enhancing the thermal performance up to 100% although water-based Al2O3 nanofluids with the concentration less than 1.0% is used as working fluid. Finally, it is shown that the thermal resistance of the nanofluid heat pipe tends to decrease with increasing the nanoparticle size, which corresponds to the previous experimental results.

[1]  Zhen-hua Liu,et al.  Heat transfer performance of a horizontal micro-grooved heat pipe using CuO nanofluid , 2008 .

[2]  V. Stepanov,et al.  Wetting contact angles of certain systems , 1977 .

[3]  K. Vafai,et al.  Analysis of cylindrical heat pipes incorporating the effects of liquid–vapor coupling and non-Darcian transport—a closed form solution , 1999 .

[4]  P. Wayner.  The effect of interfacial mass transport on flow in thin liquid films , 1991 .

[5]  Seok Pil Jang,et al.  Flow and convective heat transfer characteristics of water-based Al2O3 nanofluids in fully developed laminar flow regime , 2009 .

[6]  K. Hwang,et al.  Particle concentration and tube size dependence of viscosities of Al2O3-water nanofluids flowing through micro- and minitubes , 2007 .

[7]  Xue-Fei Yang,et al.  Effect of nanoparticles in nanofluid on thermal performance in a miniature thermosyphon , 2007 .

[8]  A. Faghri,et al.  Thermal Analysis of a Micro Heat Pipe , 1994 .

[9]  M. Kaviany.  Principles of heat transfer in porous media , 1991 .

[10]  Soon-Heung Chang,et al.  Boiling heat transfer performance and phenomena of Al2O 3-water nano-fluids from a plain surface in a pool , 2004 .

[11]  J. Smith,et al.  Introduction to chemical engineering thermodynamics , 1949 .

[12]  W. Roetzel,et al.  TEMPERATURE DEPENDENCE OF THERMAL CONDUCTIVITY ENHANCEMENT FOR NANOFLUIDS , 2003 .

[13]  S. Chi.  Heat pipe theory and practice , 1976 .

[14]  Stephen U. S. Choi.  Enhancing thermal conductivity of fluids with nano-particles , 1995 .

[15]  P. Wayner,et al.  The interline heat-transfer coefficient of an evaporating wetting film , 1976 .

[16]  Shung-Wen Kang,et al.  Experimental investigation of nanofluids on sintered heat pipe thermal performance , 2009 .

[17]  S. Kim,et al.  Analytical and experimental investigation on the operational characteristics and the thermal optimization of a miniature heat pipe with a grooved wick structure , 2003 .

[18]  Suresh V. Garimella,et al.  A mathematical model for analyzing the thermal characteristics of a flat micro heat pipe with a grooved wick , 2008 .

[19]  J. Eastman,et al.  Measuring Thermal Conductivity of Fluids Containing Oxide Nanoparticles , 1999 .

[20]  Amir Faghri,et al.  Heat Pipe Science And Technology , 1995 .

[21]  G. Pandraud,et al.  Prediction of the temperature field in flat plate heat pipes with micro-grooves – Experimental validation , 2008 .

[22]  C. Chon,et al.  Effect of nanoparticle sizes and number densities on the evaporation and dryout characteristics for strongly pinned nanofluid droplets. , 2007, Langmuir : the ACS journal of surfaces and colloids.

[23]  Zhen-hua Liu,et al.  Boiling heat transfer characteristics of nanofluids in a flat heat pipe evaporator with micro-grooved heating surface , 2007 .

[24]  Stephen U. S. Choi,et al.  Effects of Various Parameters on Nanofluid Thermal Conductivity , 2007 .

[25]  Amir Faghri,et al.  Flat Miniature Heat Pipes With Micro Capillary Grooves , 1999 .

[26]  I. Catton,et al.  Enhanced evaporation heat transfer in triangular grooves covered with a thin fine porous layer , 2001 .

[27]  Yulong Ding,et al.  Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditions , 2004 .

[28]  Qingsong Yu,et al.  Effect of nanofluid on the heat transport capability in an oscillating heat pipe , 2006 .

[29]  Ping-Hei Chen,et al.  Effect of structural character of gold nanoparticles in nanofluid on heat pipe thermal performance , 2004 .

[30]  C. A. Busse,et al.  Analysis of the heat transfer coefficient of grooved heat pipe evaporator walls , 1992 .