Static VAR Compensator-Based Voltage Regulation for Variable-Speed Prime Mover Coupled Single-Phase Self-Excited Induction Generator

In this paper, the single-phase static VAR compensator (SVC) is applied to regulate and stabilize smoothly the generated output voltage of the single-phase self-excited induction generator (single-phase SEIG) driven by a variable-speed prime mover (VSPM) under the conditions of inductive load variations and prime mover speed changes. The conventional fixed gain PI controller-based feedback control scheme is employed to adjust the equivalent capacitance of the single-phase SVC composed of the fixed excitation capacitor (FC) in parallel with the thyristor switched capacitor (TSC) and the thyristor controlled reactor TCR. A PI closed-loop feedback voltage control scheme based on the SVC for the single-phase SEIG coupled by a VSPM prototype set-up is established. The closed-loop feedback output voltage responses in the single-phase SEIG coupled by a VSPM with different inductive load variations using the single-phase SVC with the PI controller are considered and discussed herein. Based on the SVC with the PI controller closed-loop feedback voltage regulation scheme, the experimental results for the single-phase SEIG driven by a VSPM are illustrated and proved its practical effectiveness in terms of the fast response and the high performances.

[1]  Muammer Ermis,et al.  Various induction generator schemes for wind-electricity generation , 1992 .

[2]  Li Wang,et al.  Effects of long-shunt and short-shunt connections on voltage variations of a self-excited induction generator , 1997 .

[3]  A. Koyanagi,et al.  Study on maximum power point tracking of wind turbine generator using a flywheel , 2002, Proceedings of the Power Conversion Conference-Osaka 2002 (Cat. No.02TH8579).

[4]  Olorunfemi Ojo,et al.  An analysis of single-phase self-excited induction generators: model development and steady-state calculations , 1995 .

[5]  R. Bonert,et al.  A technique for the steady-state analysis of a self-excited induction generator with variable speed , 1993 .

[6]  G. Bortolotto,et al.  Voltage-frequency control of a self-excited induction generator , 1999 .

[7]  Eduard Muljadi,et al.  Zero sequence method for energy recovery from a variable-speed wind turbine generator , 2001 .

[8]  M. I. Valla,et al.  Induction Generator Controller Based on the Instantaneous Reactive Power Theory , 2002, IEEE Power Engineering Review.

[9]  Bhim Singh,et al.  A NEW TECHNIQUE FOR THE ANALYSIS OF SELF EXCITED INDUCTION GENERATOR , 1995 .

[10]  T. F. Chan ANALYSIS OF A SINGLE-PHASE SELF-EXCITED INDUCTION GENERATOR , 1995 .

[11]  Bhim Singh,et al.  A step towards improvements in the characteristics of self excited induction generator , 1993 .

[12]  Abdulrahman I. Alolah,et al.  Capacitance requirement for isolated self-exicted induction generator , 1990 .

[13]  C. F. Christiansen,et al.  Dynamical sliding mode power control of wind driven induction generators , 2000 .

[14]  V. T. Ranganathan,et al.  Variable-Speed Wind Power Generation Using a Doubly Fed Wound Rotor Induction Machine: A Comparison with Alternative Schemes , 2002 .

[15]  N. Malik,et al.  Steady State Analysis and Performance of an Isolated Self-Excited Induction Generator , 1986, IEEE Transactions on Energy Conversion.

[16]  C. W. Taylor,et al.  Static var compensator models for power flow and dynamic performance simulation , 1994 .

[17]  Chandan Chakraborty,et al.  Excitation requirements for stand alone three-phase induction generator , 1996, Proceedings of International Conference on Power Electronics, Drives and Energy Systems for Industrial Growth.