Investigation into Heat Treatment and Residual Stress in Laser Clad AA7075 Powder on AA7075 Substrate

[1]  Aitzol Lamikiz,et al.  Evaluation of the mechanical properties of Inconel 718 components built by laser cladding , 2011 .

[2]  J. Hosson,et al.  Microstructural characterization of AISI 431 martensitic stainless steel laser-deposited coatings , 2011 .

[3]  Sheng-Hui Wang,et al.  On the development of microstructures and residual stresses during laser cladding and post-heat treatments , 2011, Journal of Materials Science.

[4]  R. Rogge,et al.  Experimental study of residual stresses in laser clad AISI P20 tool steel on pre-hardened wrought P20 substrate , 2010 .

[5]  P. Prangnell,et al.  Control of weld composition when arc welding high strength aluminium alloys using multiple filler wires , 2010 .

[6]  Alexander M. Korsunsky,et al.  Analysis of residual strain and stress states due to heat treatment and thermal processing , 2009 .

[7]  M. Brandt,et al.  Extended service life and reliability for steam turbine components , 2009 .

[8]  V. Linton,et al.  Influence of time on residual stresses in friction stir welds in agehardenable 7xxx aluminium alloys , 2008 .

[9]  Philip J. Withers,et al.  The variation of the unstrained lattice parameter in an AA7010 friction stir weld , 2007 .

[10]  Philip J. Withers,et al.  Dissimilar friction stir welds in AA5083-AA6082: The effect of process parameters on residual stress , 2006 .

[11]  V. Ocelík,et al.  Residual stress analysis in Co-based laser clad layers by laboratory X-rays and synchrotron diffraction techniques , 2006 .

[12]  D. Tanner,et al.  Residual stress magnitudes and related properties in quenched aluminium alloys , 2006 .

[13]  M. Brandt,et al.  Residual stresses in Al7075 alloy plate laser clad with Al-12Si alloy powder , 2006 .

[14]  P. Withers,et al.  Introduction to the Characterization of Residual Stress by Neutron Diffraction , 2005 .

[15]  M. Brandt,et al.  Effects of process parameters on the quality of laser cladding of 7075-T6 aluminium alloy with Al-Si powder , 2004 .

[16]  M. Brandt,et al.  Control of dilution during laser cladding of Al7075 substrates with Al-12Si aluminium alloy powder , 2004 .

[17]  M. Brandt,et al.  Challenges of laser cladding Al7075 Alloy with Al-12Si alloy powder , 2004 .

[18]  Steffen Nowotny,et al.  Laser cladding of the titanium alloy TI6242 to restore damaged blades , 2004 .

[19]  A. Deschamps,et al.  Characterisation and modelling of precipitate evolution in an Al–Zn–Mg alloy during non-isothermal heat treatments , 2003 .

[20]  Rajiv S. Mishra,et al.  Microstructural investigation of friction stir welded 7050-T651 aluminium , 2003 .

[21]  W. Kurz,et al.  Analysis of the laser-cladding process for stellite on steel , 1997 .

[22]  M. Rappaz,et al.  A simple but realistic model for laser cladding , 1994 .