The influence of cellulose nanocrystals on the microstructure of cement paste

Abstract This paper reports the influence of raw and sonicated cellulose nanocrystals (CNCs) on the microstructure of cement paste. A novel centrifugation method is designed to measure the concentrations of the adsorbed CNCs (aCNCs) on the cement surface, and the free CNCs (fCNCs) which are mobile in water. It is found that, the majority of the CNCs (>94%) are aCNCs. More importantly, sonication does not significantly reduce the amount of aCNCs (reduction of less than 2%). We surmise that, after sonication, the aCNCs are primarily dispersed over the cement surface, instead of becoming fCNCs via sonication. Isothermal calorimetry and energy-dispersive X-ray spectroscopy (EDX) results support this theory. The water desorption tests show that the total porosities of cement pastes with raw and sonicated CNCs are 14.8% and 14.4%, which showed a reduction from 16% for the plain cement paste. The porosity reduction is a result of an increase in the degree of hydration. The advantage of sonicated CNCs is they are dispersed, avoiding therefore agglomerates that can lead to pores, voids, and air entrapment. The nanoindentation results show that the reduced indentation modulus on the interfacial regions between cement particles and the low density CSH is increased when CNCs are used.

[1]  J. Olek,et al.  Nanomechanical Characterization of the Carbonated Wollastonite System , 2015 .

[2]  R. M. Taib.  Cellulose fiber reinforced thermoplastic composites: Processing and Product Charateristics , 1998 .

[3]  Kristiina Oksman,et al.  Optimization of the isolation of nanocrystals from microcrystalline cellulose by acid hydrolysis , 2006 .

[4]  J. Weiss,et al.  Internal Curing: Discussion of the Role of Pore Solution on Relative Humidity Measurements and Desorption of Lightweight Aggregate (LWA) , 2010, SP-270: Advances in the Material Science of Concrete.

[5]  D. Gray,et al.  Effect of microcrystallite preparation conditions on the formation of colloid crystals of cellulose , 1998 .

[6]  Zi-kui Liu,et al.  Anisotropy and temperature dependence of structural, thermodynamic, and elastic properties of crystalline cellulose Iβ: a first-principles investigation , 2014 .

[7]  H. Taylor,et al.  The C-S-H gel of Portland cement mortars: Part I. The interpretation of energy-dispersive X-ray microanalyses from scanning electron microscopy, with some observations on C-S-H, AFm and AFt phase compositions , 2003 .

[8]  Ashlie Martini,et al.  Cellulose nanomaterials review: structure, properties and nanocomposites. , 2011, Chemical Society reviews.

[9]  P. Trtik,et al.  Micro-mechanical properties of cement paste measured by depth-sensing nanoindentation: a preliminary correlation of physical properties with phase type , 2004 .

[10]  S. Diamond.  Identification of hydrated cement constituents using a scanning electron microscope energy dispersive X-ray spectrometer combination , 1972 .

[11]  Jianzhuang Xiao,et al.  Interfacial transition zones in recycled aggregate concrete with different mixing approaches , 2012 .

[12]  Robert J. Moon,et al.  The influence of cellulose nanocrystal additions on the performance of cement paste , 2015 .

[13]  F. Ulm,et al.  The effect of two types of C-S-H on the elasticity of cement-based materials: Results from nanoindentation and micromechanical modeling , 2004 .

[14]  G. Pharr,et al.  An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments , 1992 .

[15]  M. Bradbury,et al.  Diffusion and adsorption studies on hardened cement paste and the effect of carbonation on diffusion rates , 1992 .

[16]  P. Helene,et al.  Efficacy of surface hydrophobic agents in reducing water and chloride ion penetration in concrete , 2007 .

[17]  D. Cocke,et al.  An investigation of mercury solidification and stabilization in portland cement using X-ray photoelectron spectroscopy and energy dispersive spectroscopy , 1990 .

[18]  W. Jason Weiss,et al.  The Influence of Pore Solutions Properties on Drying in Cementitious Materials , 2014 .

[19]  François Toutlemonde,et al.  The nano-mechanical signature of Ultra High Performance Concrete by statistical nanoindentation techniques , 2008 .

[20]  김기범.  나의 Concrete 연구실 , 2011 .

[21]  P. Zavattieri,et al.  Anisotropy of the elastic properties of crystalline cellulose Iβ from first principles density functional theory with Van der Waals interactions , 2013, Cellulose.

[22]  P. Zavattieri,et al.  The relationship between cellulose nanocrystal dispersion and strength , 2016 .

[23]  Gaurav Sant,et al.  Interactions between shrinkage reducing admixtures (SRA) and cement paste's pore solution , 2008 .

[24]  S. Pihlajavaara,et al.  Effect of carbonation on microstructural properties of cement stone , 1974 .