Investigation of bluff-body micro-flameless combustion

Abstract Characteristics of lean premixed conventional micro-combustion and lean non-premixed flameless regime of methane/air are investigated in this paper by solving three-dimensional governing equations. At moderate equivalence ratio ( ∅  = 0.5), standard k – e and the eddy-dissipation concept are employed to simulate temperature distribution and combustion stability of these models. The effect of bluff-body on the temperature distribution of both conventional and flameless mode is developed. The results show that in the premixed conventional micro-combustion the stability of the flame is increased when a triangular bluff-body is applied. Moreover, micro-flameless combustion is more stable when bluff-body is used. Micro-flameless mode with bluff-body and 7% O 2 concentration (when N 2 is used as diluent) illustrated better performance than other cases. The maximum temperature in premixed conventional micro-combustion and micro-flameless combustion was recorded 2200 K and 1520 K respectively. Indeed, the flue gas temperature of conventional mode and flameless combustion was 1300 K and 1500 K respectively. The fluctuation of temperature in the conventional micro-combustor wall has negative effects on the combustor and reduces the lifetime of micro-combustor. However, in the micro-flameless mode, the wall temperature is moderate and uniform. The rate of fuel–oxidizer consumption in micro-flameless mode takes longer time and the period of cylinders recharging is prolonged.

[1]  Jianzhong Liu,et al.  Improvement of micro-combustion stability through electrical heating , 2009 .

[2]  Raymond J. Stalker,et al.  Release of chemical energy by combustion in a supersonic mixing layer of hydrogen and air , 2002 .

[3]  Bassam B. Dally,et al.  Effect of fuel mixture on moderate and intense low oxygen dilution combustion , 2004 .

[4]  Mazlan Abdul Wahid,et al.  Biogas Flameless Combustion: A Review , 2013 .

[5]  S. E. Hosseini,et al.  Numerical investigation of biogas flameless combustion , 2014 .

[6]  Pedro J. Coelho,et al.  Assessment of the Performance of Several Turbulence and Combustion Models in the Numerical Simulation of a Flameless Combustor , 2013 .

[7]  Uwe Schnell,et al.  Comparison of Different Global Reaction Mechanisms for MILD Combustion of Natural Gas , 2008 .

[8]  Yi Liu,et al.  A numerical investigation on combustion characteristics of H2/air mixture in a micro-combustor with wall cavities , 2014 .

[9]  J. Wunning,et al.  Flameless oxidation to reduce thermal no-formation , 1997 .

[10]  A. Fan,et al.  Effect of bluff body shape on the blow-off limit of hydrogen/air flame in a planar micro-combustor , 2014 .

[11]  Mazlan Abdul Wahid,et al.  Biogas utilization: experimental investigation on biogas flameless combustion in lab-scale furnace , 2013 .

[12]  Wenming Yang,et al.  Development of micro power generators – A review , 2011 .

[13]  R. Weber,et al.  On the (MILD) combustion of gaseous, liquid, and solid fuels in high temperature preheated air , 2005 .

[14]  Wei Liu,et al.  Regime diagrams and characteristics of flame patterns in radial microchannels with temperature gradients , 2008 .

[15]  Wenming Yang,et al.  Microscale combustion research for application to micro thermophotovoltaic systems , 2003 .

[16]  K. Maruta,et al.  Microscale combustion: Technology development and fundamental research , 2011 .

[17]  Premixed flame extinction in narrow channels with and without heat recirculation , 2012 .

[18]  Mazlan Abdul Wahid,et al.  Effect of diluted and preheated oxidizer on the emission of methane flameless combustion , 2012 .

[19]  Konstantinos Boulouchos,et al.  Hetero-/homogeneous combustion and stability maps in methane-fueled catalytic microreactors☆ , 2007 .

[20]  Mazlan Abdul Wahid,et al.  High temperature air combustion: sustainable technology to low No x formation , 2012 .

[21]  C. Shu,et al.  Development of microthermophotovoltaic system , 2002 .

[22]  C. Westbrook,et al.  Simplified Reaction Mechanisms for the Oxidation of Hydrocarbon Fuels in Flames , 1981 .

[23]  Christopher P. Cadou,et al.  Effect of structural conduction and heat loss on combustion in micro-channels , 2006 .

[24]  G. Gauba,et al.  Combustors for micro-gas turbine engines , 1998 .

[25]  Sejin Kwon,et al.  Effects of thermal and chemical surface–flame interaction on flame quenching , 2006 .

[26]  D. Wilcox.  Turbulence modeling for CFD , 1993 .

[27]  Bhupendra Khandelwal,et al.  Experimental investigations on a new active swirl based microcombustor for an integrated micro-reformer system , 2011 .

[28]  Wenming Yang,et al.  Combustion in micro-cylindrical combustors with and without a backward facing step , 2002 .

[29]  A. Gupta,et al.  Thermal Characteristics of Gaseous Fuel Flames Using High Temperature Air , 2004 .

[30]  Sudarshan Kumar,et al.  Thermal performance of a micro combustor with heat recirculation , 2013 .

[31]  Mazlan Abdul Wahid,et al.  Pollutant reduction and energy saving in industrial sectors by applying high temperature air combustion method , 2012 .

[32]  Wenming Yang,et al.  A numerical study on premixed micro-combustion of CH4–air mixture: Effects of combustor size, geometry and boundary conditions on flame temperature , 2009 .

[33]  Wenming Yang,et al.  Study on premixed combustion in cylindrical micro combustors: Transient flame behavior and wall heat flux , 2009 .

[34]  Paul D. Ronney,et al.  Numerical modeling of non-adiabatic heat-recirculating combustors , 2007 .

[35]  Numerical study of methane and air combustion inside a small tube with an axial temperature gradient at the wall , 2010 .

[36]  Bassam B. Dally,et al.  Modeling turbulent reacting jets issuing into a hot and diluted coflow , 2005 .

[37]  S. E. Hosseini,et al.  Effects of bluff body shape on the flame stability in premixed micro-combustion of hydrogen-air mixture , 2014 .

[38]  D. G. Norton,et al.  A CFD study of propane/air microflame stability , 2004 .

[39]  Leonardo Tognotti,et al.  A novel methodology for chemical time scale evaluation with detailed chemical reaction kinetics , 2013 .

[40]  Roles of thermal and radical quenching in emissions of wall‐stabilized hydrogen flames , 1998 .

[41]  P. Ronney.  Analysis of non-adiabatic heat-recirculating combustors , 2003 .

[42]  Takuya Kataoka,et al.  Characteristics of combustion in a narrow channel with a temperature gradient , 2005 .

[43]  Jl L. Xu,et al.  Thermal performance of a micro-combustor for micro-gas turbine system , 2007 .

[44]  George A. Boyarko,et al.  Catalyzed combustion of hydrogen–oxygen in platinum tubes for micro-propulsion applications , 2005 .

[45]  Gianpiero Colangelo,et al.  Experimental study of a burner with high temperature heat recovery system for TPV applications , 2006 .

[46]  Wenming Yang,et al.  Development of micro-thermophotovoltaic power generator with heat recuperation , 2014 .

[47]  Masashi Katsuki,et al.  Advanced low NOx combustion using highly preheated air , 2001 .

[48]  Leonardo Tognotti,et al.  Experimental and numerical investigation of a micro-CHP flameless unit , 2012 .

[49]  A. Carlos Fernandez-Pello,et al.  Micropower generation using combustion: Issues and approaches , 2002 .

[50]  R. Masel,et al.  Flame dynamics and structure within sub‐millimeter combustors , 2007 .