Modeling, numerical optimization, and irreversibility reduction of a triple-pressure reheat combined cycle

The main methods for improving the efficiency of the combined cycle are: increasing the inlet temperature of the gas turbine (TIT), reducing the irreversibility of the heat recovery steam generator (HRSG), and optimization. In this paper, modeling and optimization of the triple-pressure reheat combined cycle as well as irreversibility reduction of its HRSG are considered. Constraints were set on the minimum temperature difference for pinch points (PPm), the temperature difference for superheat approach, the steam turbine inlet temperature and pressure, the stack temperature, and the dryness fraction at steam turbine outlet. The triple-pressure reheat combined cycle was optimized at 41 different maximum values of TIT using two different methods; the direct search and the variable metric. A feasible technique to reduce the irreversibility of the HRSG of the combined cycle was introduced. The optimized and the reduced-irreversibility triple-pressure reheat combined cycles were compared with the regularly designed triple-pressure reheat combined cycle, which is the typical design for a commercial combined cycle. The effects of varying the TIT on the performance of all cycles were presented and discussed. The results indicate that the optimized triple-pressure reheat combined cycle is up to 1.7% higher in efficiency than the reduced-irreversibility triple-pressure reheat combined cycle, which is 1.9–2.1% higher in efficiency than the regularly designed triple-pressure reheat combined cycle when all cycles are compared at the same values of TIT and PPm. The optimized and reduced-irreversibility combined cycles were compared with the most efficient commercially available combined cycle at the same value of TIT.

[1]  Garret N. Vanderplaats,et al.  Numerical Optimization Techniques for Engineering Design: With Applications , 1984 .

[2]  Jerry A. Ebeling,et al.  Thermal Energy Storage and Inlet Air Cooling for Combined Cycle , 1994 .

[3]  B. K. Hodge,et al.  Analysis and design of energy systems , 1985 .

[4]  Ken Wicker.  Save money while saving the planet , 2003 .

[5]  Manuel Valdés,et al.  Optimization of heat recovery steam generators for combined cycle gas turbine power plants , 2001 .

[6]  Alessandro Franco,et al.  THERMOECONOMIC OPTIMIZATION OF HEAT RECOVERY STEAM GENERATORS OPERATING PARAMETERS FOR COMBINED PLANTS , 2004 .

[7]  A. Bassily.  Performance improvements of the recuperated gas turbine cycle using absorption inlet cooling and evaporative aftercooling , 2002 .

[8]  Abdul Khaliq,et al.  Exergy optimization of an irreversible combined heat-and-power system , 2005 .

[9]  Ashraf M. Bassily.  Effects of evaporative inlet and aftercooling on the recuperated gas turbine cycle , 2001 .

[10]  T. E. Dehaan.  Gas overfiring: a viable option for stoker units firing solid fuel , 1993 .

[11]  Richard Edwin Sonntag,et al.  Fundamentals of Thermodynamics , 1998 .

[12]  G. T. Polley,et al.  Thermodynamical Optimization of a Combined Cycle Plant Performance , 1994 .

[13]  C Kail.  Evaluation of advanced combined cycle power plants , 1998 .

[14]  A. M. Bassily.  Performance improvements of the intercooled reheat regenerative gas turbine cycles using indirect evaporative cooling of the inlet air and evaporative cooling of the compressor discharge , 2001 .

[15]  David E. Searles,et al.  Inlet Conditioning Enhances Performance of Modern Combined Cycle Plants for Cost-Effective Power Generation , 1996 .

[16]  Walter Jury,et al.  Process Optimization of an Integrated Combined Cycle — The Impact and Benefit of Sequential Combustion , 1997 .

[17]  Henry Cohen,et al.  Gas turbine theory , 1973 .

[18]  Olav Bolland,et al.  A Comparative Evaluation of Advanced Combined Cycle Alternatives , 1990 .

[19]  Sudipta De,et al.  Design and operation of a heat recovery steam generator with minimum irreversibility , 1997 .

[20]  M. Boswell,et al.  Choose best option for enhancing combined-cycle output , 1993 .

[21]  David Gordon Wilson,et al.  The utilization of recuperated and regenerated engine cycles for high-efficiency gas turbines in the 21st century , 1996 .

[22]  A. M Bassily.  Performance improvements of the intercooled reheat recuperated gas-turbine cycle using absorption inlet-cooling and evaporative after-cooling , 2004 .

[23]  A. M. Bassily,et al.  Modeling, numerical optimization, and irreversibility reduction of a dual-pressure reheat combined-cycle , 2005 .

[24]  Alessandro Franco,et al.  Thermoeconomic evaluation of the feasibility of highly efficient combined cycle power plants , 2004 .

[25]  M. R. von Spakovsky,et al.  The Design and Performance Optimization of Thermal Systems , 1990 .