Implementation of high voltage gain interleaved boost converter combined with Switched Capacitor for the low power application

This paper discuss about the high efficient boost converter for the low power application. In order to implement the high efficient boost converter the transformerless converter is approached meanwhile the high output can be achieved with the help of switched capacitor and coupled inductor with low duty cycle. Problem of High Inrush Current to the Switches due to the Charging and Discharging Nature of Switched Capacitor can be avoided with the help of coupled inductor in the input side. The simulation of the proposed interleaved boost converter with switched capacitor is done with input voltage of 20v and output voltage of 200v using MATLAB software.

[1]  Jorge L. Duarte,et al.  Line-Interactive UPS Using a Fuel Cell as the Primary Source , 2008, IEEE Transactions on Industrial Electronics.

[2]  Wuhua Li,et al.  Interleaved High Step-Up Converter With Winding-Cross-Coupled Inductors and Voltage Multiplier Cells , 2012, IEEE Transactions on Power Electronics.

[3]  Wuhua Li,et al.  A Family of Interleaved DC–DC Converters DeducedFrom a Basic Cell With Winding-Cross-CoupledInductors (WCCIs) for High Step-Upor Step-Down Conversions , 2008, IEEE Transactions on Power Electronics.

[4]  V. Sivachidambaranathan,et al.  Performance Analysis of Transformer-Less Two Phase Interleaved High Gain DC Converter using MPPT Algorithm , 2015 .

[5]  Alberto Reatti,et al.  Low-cost high power-density electronic ballast for automotive HID lamp , 2000 .

[6]  V. Sivachidambaranathan.  High Frequency Isolated Series Parallel Resonant Converter , 2015 .

[7]  Luiz Henrique S. C. Barreto,et al.  High-Voltage Gain Boost Converter Based on Three-State Commutation Cell for Battery Charging Using PV Panels in a Single Conversion Stage , 2014, IEEE Transactions on Power Electronics.

[8]  K. Shujaee,et al.  Solar Battery Chargers for NiMH Batteries , 2005, IEEE Transactions on Power Electronics.

[9]  V. Senthil Nayagam.  Power Reliability Improvement of Inverter with Photovoltaic System , 2015 .

[10]  J. Komathi.  Simulation of Multi output Fly back Converter with Integrated Auxiliary Buck Converter with reduced components , 2015 .

[11]  Jiann-Fuh Chen,et al.  Novel High Step-Up DC–DC Converter for Distributed Generation System , 2013, IEEE Transactions on Industrial Electronics.

[12]  Seddik Bacha,et al.  Cascaded DC–DC Converter Photovoltaic Systems: Power Optimization Issues , 2011, IEEE Transactions on Industrial Electronics.

[13]  J. Lee,et al.  Non-isolated high-gain boost converter using voltage-stacking cell , 2008 .

[14]  J.-J. Huselstein,et al.  Multicell Interleaved Flyback Using Intercell Transformers , 2007, IEEE Transactions on Power Electronics.

[15]  B. Sidda Reddy,et al.  International Journal of Applied Engineering Research , 2018 .

[16]  Bor-Ren Lin,et al.  Analysis of an Interleaved Three-Level ZVS Converter With Series-Connected Transformers , 2013, IEEE Transactions on Power Electronics.

[17]  Sheldon S. Williamson,et al.  Power-Electronics-Based Solutions for Plug-in Hybrid Electric Vehicle Energy Storage and Management Systems , 2010, IEEE Transactions on Industrial Electronics.

[18]  V. Sivachidambaranathan,et al.  Enhancement of Active Power Filter Operational Performance using SRF Theory for Renewable Source , 2015 .

[19]  Thierry Meynard,et al.  Interactions between fuel cells and power converters influence of current harmonics on a fuel cell stack , 2004, PESC 2004.