The effect of carriage type on yarding productivity and cost

ABSTRACT The authors describe a study conducted under controlled conditions, with the goal of determining the eventual benefits of replacing the conventional clamped carriage with an unclamped motorized dropline carriage. The rigging was a classic three-cable configuration common to European yarder operations, with a single span standing skyline. The mainline and haulback line were used to move the carriage back and forth along the span. Two carriage types were used to gauge productivity and extraction cost differences between clamped (Hochleitner BW4000) and unclamped motorized dropline (SEIK Skybull 30/60) carriages. The authors conducted a classic time study, recoding work time, delay time and load size individually for 83 cycles. Replacing the standard clamped carriage with the unclamped motorized dropline carriage resulted in a productivity increase equal or larger than 30%. Extraction and processing cost decreased between 10% and 17%, depending on extraction distance. These results are valid for the specific set-up considered with the study, and may not be generalized without repeating the experiment under more varied conditions: however, they are very encouraging and may justify further investigations aimed at determining the effect of carriage type on fuel consumption and machine wear.

[1]  Hans Rudolf Heinimann,et al.  Optimum geometric layout of a single cable road , 2012, European Journal of Forest Research.

[2]  Natascia Magagnotti,et al.  The effect of harvesting method on biomass retention and operational efficiency in low-value mountain forests , 2016, European Journal of Forest Research.

[3]  Raffaele Spinelli,et al.  Analyzing and Estimating Delays in Harvester Operations , 2008 .

[4]  Natascia Magagnotti,et al.  Landing Characteristics for Harvesting Operations in New Zealand , 2011 .

[5]  Bruce R. Hartsough,et al.  Economics of Harvesting to Maintain High Structural Diversity and Resulting Damage to Residual Trees , 2003 .

[6]  N. Na.  A New Guide , 1971 .

[7]  Ola Lindroos,et al.  Cable yarding productivity models: a systematic review over the period 2000–2011 , 2016 .

[8]  Karl Stampfer,et al.  Efficiency and ergonomic benefits of using radio controlled chokers in cable yarding. , 2010 .

[9]  Natascia Magagnotti,et al.  Harvesting alternatives for mallee agroforestry plantations in Western Australia , 2014, Agroforestry Systems.

[10]  Lars Eliasson,et al.  The COST model for calculation of forest operations costs , 2014 .

[11]  Neil K. Huyler,et al.  Cycle-time equation for the Koller K300 cable yarder operating on steep slopes in the Northeast , 1997 .

[12]  J. F. McNeel,et al.  Improving Cable Thinning System Productivity by Modifying Felling Phase Operations , 1997 .

[13]  Rien Visser,et al.  Productivity Models for Cable Yarding in Alpine Forests , 2015 .

[14]  Natascia Magagnotti,et al.  Benchmarking the impact of traditional small-scale logging systems used in Mediterranean forestry , 2010 .

[15]  Karl Stampfer,et al.  Expanding Ground-based Harvesting onto Steep Terrain: A Review , 2015 .

[16]  Natascia Magagnotti,et al.  The role of work studies in forest engineering: status and perspectives , 2015 .

[17]  R. Visser,et al.  A Survey of Logging Contract Rates in the Southern European Alps , 2017, Small-scale Forestry.

[18]  Natascia Magagnotti,et al.  A new guide for work studies in forestry , 2013 .

[19]  Toshiaki Tasaka,et al.  The ability of a carriages developed for a mobile tower yarder: A comparison of the hauling force and walking time in a line pulling out process , 2007, Journal of Forest Research.

[20]  Natascia Magagnotti,et al.  Cable logging contract rates in the alps: The effect of regional variability and technical constraints , 2015 .

[21]  Natascia Magagnotti,et al.  Skyline tension, shock loading, payload and performance for a European cable yarder using two different carriage types , 2016, European Journal of Forest Research.