Cogging torque reduction in axial flux machines for small wind turbines

This paper presents a technique for cogging torque reduction in an axial-flux permanent-magnet (PM) generator suitable for use in a small wind turbine. These machines can be compact and have high power density; they are axially short with larger diameter which makes then very suitable for a wind turbine. The inherent cogging torque can cause problems during turbine start-up and cut-in. In this paper, a turbine is characterized via the measurement in a wind tunnel. The characteristics are then used to determine the specification for the generator. A method called “hybrid skew” is proposed for cogging torque reduction. 3-D finite element analysis is applied to evaluate the method and a 88 % reduction of peak cogging torque was obtained when combined with another known technique. This significantly improves the turbine performance at low start-up speed while maintaining high power density. The technique can reduce manufacturing confusion in N/S pole placement and allow a simple magnet shape for lower cost manufacturing.

[1]  M.A. Valenzuela,et al.  Cogging Torque Reduction in an Axial Flux PM Machine via Stator Slot Displacement and Skewing , 2007, IEEE Transactions on Industry Applications.

[2]  S. Brisset,et al.  Design and Optimization of a Nine-Phase Axial-Flux PM Synchronous Generator With Concentrated Winding for Direct-Drive Wind Turbine , 2006, IEEE Transactions on Industry Applications.

[3]  Xiuhe Wang,et al.  The optimization of pole arc coefficient to reduce cogging torque in surface-mounted permanent magnet motors , 2006, IEEE Transactions on Magnetics.

[4]  E. Muljadi,et al.  Axial flux, modular, permanent-magnet generator with a toroidal winding for wind turbine applications , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[5]  Thomas A. Lipo,et al.  Cogging torque minimization technique for multiple-rotor, axial-flux, surface-mounted-PM motors: alternating magnet pole-arcs in facing rotors , 2003, 38th IAS Annual Meeting on Conference Record of the Industry Applications Conference, 2003..

[6]  D. Howe,et al.  Influence of design parameters on cogging torque in permanent magnet machines , 1997, 1997 IEEE International Electric Machines and Drives Conference Record.

[7]  Pascal Brochet,et al.  Design and Optimization of a Nine-Phase Axial-Flux PM Synchronous Generator With Concentrated Winding for Direct-Drive Wind Turbine , 2006 .

[8]  L.L. Lai,et al.  An Axial-Flux Permanent-Magnet Synchronous Generator for a Direct-Coupled Wind-Turbine System , 2007, IEEE Transactions on Energy Conversion.

[9]  Jacek F. Gieras,et al.  Axial Flux Permanent Magnet Brushless Machines , 2005 .

[10]  J.A. Tapia,et al.  Design Consideration to Reduce Cogging Torque in Axial Flux Permanent-Magnet Machines , 2007, IEEE Transactions on Magnetics.

[11]  H. Lesani,et al.  Design considerations of high speed axial flux permanent magnet generator with coreless stator , 2007, 2007 International Power Engineering Conference (IPEC 2007).

[12]  P. Pillay,et al.  PM wind generator topologies , 2005, IEEE Transactions on Industry Applications.