Proposal and Evaluation of On-Machine Measurement System for Square End Milling in Machining Center by Acoustic Emission Technique

[1]  Takashi Miyoshi,et al.  On-Machine Cutting Edge Profile Measurement for Micro Milling Tool (1st Report, Laser Diffraction Gauge Method and its Verifications) , 2004 .

[2]  Takashi Nomura,et al.  Non-contact Method for Detecting the Tip Position of a Micro-tool Using the Peak of the Contrast of Images , 2009 .

[3]  Alan Hase,et al.  Correlation of Abrasive Wear Phenomenon and AE Signals , 2006 .

[4]  Nagayoshi Kasashima,et al.  In-Process Laser Monitoring of Milling Tool Failure , 1997 .

[5]  Alan Hase,et al.  The relationship between acoustic emission signals and cutting phenomena in turning process , 2014 .

[6]  Sangkee Min,et al.  Acoustic emission based tool contact detection for ultra-precision machining , 2011 .

[7]  Ichiro Inasaki,et al.  Monitoring of turning process with acoustic emission signals. , 1986 .

[8]  Ichiro Inasaki,et al.  Monitoring of Milling Process with an Acoustic Emission Sensor. , 1993 .

[9]  Alan Hase,et al.  Scanning electron microscope observation study for identification of wear mechanism using acoustic emission technique , 2014 .

[10]  Martin B.G. Jun,et al.  An Acoustic Emission-Based Method for Determining Contact Between a Tool and Workpiece at the Microscale , 2008 .

[11]  Makio Mizuno,et al.  Studies on Friction and Wear Utilizing Acoustic Emission : Relation between Friction and Wear Mode and Acoustic Emission Signals , 1989 .

[12]  Sangkee Min,et al.  A study on initial contact detection for precision micro-mold and surface generation of vertical side walls in micromachining , 2008 .