A data analysis and simulation framework for the PANDA collaboration PANDA Computing Group

In spring 2006 the FAIR Baseline Technical Report (BTR) [1] was presented to the International Steering Committee (ISC) of FAIR. The BTR was accepted by the ISC as technical description and scope of the FAIR project and basis for the international negotiations for the creation of the FAIR GmbH. The negotiations commenced in autumn 2006. In parallel the working groups on Administrative and Financial Issues (AFI) and Science and Technical Issues (STI) prepared the documents that are necessary for the establishment of the FAIR company. This task was completed by the end of 2006. The ISC established the Joint Core Team which has the task to manage the FAIR project until the formal creation of the FAIR GmbH. Great effort has been put into consolidating the ion-optical layout of the facility as well as the design and specifications of the various accelerator elements, shown in the figure below. The current status in this area is presented in the section of the FAIR division in this report. The BTR defines the initial scientific program of FAIR. The corresponding experiments are listed in the table below. PAX/ASSIA and AIC have to prove their feasibility but provisions in the accelerator design and civil construction will be made for them. Layout of the FAIR complex. The accelerator consists of the double ring synchrotron SIS 100/300, the injection complex UNILAC, p-LINAC and SIS 18, and the storage rings (NESR, RESR/CR and HESR). The other acronyms characterize positions of experiments listed in the table on the next page. The NUSTAR experiments (light grey in table) behind the Super-FRS will be located in areas HE, LE and the NESR, HEDgeHOB and WDM in area PP and BIOMAT in AP. The SPARC experiment will involve target positions over the entire complex. CBM, PANDA and FLAIR are shown in situ. 1 The experiment collaborations of FAIR have worked hard on the necessary R&D for their detectors. Reports about the progress of the various collaborations are presented in this section of this report. These efforts will lead in due time to various technical design reports that are prerequisite for the start of construction of the respective experiments. However it should be noted that only a small fraction of the full activities of the experiments are reported here, as this is the Annual Report of GSI and the vast majority of collaborators are external. Experiment Research Program Technical Facility R3B Nuclear …

[1]  A. Staiano.  POS , 2022, The Fairchild Books Dictionary of Fashion.

[2]  M. Grieser,et al.  Ultra-low energy storage ring at FLAIR , 2005, Hyperfine Interactions.

[3]  P. Shcherbakov,et al.  Analysis of the Eddy Current Relaxation Time Effects in the FAIR SIS 100 Main Magnets , 2007, IEEE Transactions on Applied Superconductivity.

[4]  S. Russenschuck,et al.  Magnetic and Thermal Characteristics of a Model Dipole Magnet for the SIS 300 , 2007, IEEE Transactions on Applied Superconductivity.

[5]  A. Kalimov,et al.  Status of the Design of a Full Length Superferric Dipole and Quadrupole Magnets for the FAIR SIS 100 Synchrotron , 2007, IEEE Transactions on Applied Superconductivity.

[6]  S. Y. Shim,et al.  Development of FAIR superconducting magnets and cryogenic system * , 2007 .

[7]  F. Nolden,et al.  On stochastic cooling of multi-component fragment beams , 2006 .

[8]  F. Nolden,et al.  Pick‐Up and Kicker Electrodes for the CR , 2006 .

[9]  Manfred Glesner,et al.  Implementation of Realtime and Highspeed Phase Detector on FPGA , 2006, ARC.

[10]  K. Beckert,et al.  THE COLLECTOR RING CR OF THE FAIR PROJECT , 2006 .

[11]  T. Weiland,et al.  NUMERICAL IMPEDANCE CALCULATIONS FOR THE GSI SIS-100/300 KICKERS ∗ , 2006 .

[12]  T. Weiland,et al.  Transverse coupling impedance of a ferrite kicker magnet: Comparison between simulations and measurements ∗ , 2006 .

[13]  C. Welsch.  COOLING RATES AT ULTRA-LOW ENERGY STORAGE RINGS , 2006 .

[14]  O. Boine-Frankenheim,et al.  ANALYSIS OF MEASURED TRANSVERSE BEAM ECHOES IN RHIC , 2006 .

[15]  Maria Vittoria Garzelli,et al.  Nuclear Models in FLUKA: Present Capabilities, Open Problems, and Future Improvements , 2005 .

[16]  Harald Klingbeil,et al.  A fast DSP-based phase-detector for closed-loop RF control in synchrotrons , 2005, IEEE Transactions on Instrumentation and Measurement.

[17]  Wolfgang Vinzenz,et al.  THE BUNCH COMPRESSOR SYSTEM FOR SIS18 AT GSI , 2004 .

[18]  Daniele Davino,et al.  Improved analytical model of the transverse coupling impedance of ferrite kicker magnets , 2003 .

[19]  A. Kalimov,et al.  Optimization of a superferric nuclotron type dipole for the GSI fast pulsed synchrotron , 2002 .

[20]  B. G. Taylor,et al.  Timing Distribution at the LHC , 2002 .

[21]  Masaaki Suetake,et al.  RF reference distribution using fibre-optic links for KEKB accelerator , 2001, PACS2001. Proceedings of the 2001 Particle Accelerator Conference (Cat. No.01CH37268).

[22]  F. Völker,et al.  POWER CONVERTERS OF THE MAIN DIPOLE AND QUADRUPOLE MAGNET STRINGS OF THE ANTIPROTON DECELERATOR AT CERN , 2000 .

[23]  J. Hickey.  THE I&I REPORT , 1999 .

[24]  D. McGinnis,et al.  Slotted waveguide slow-wave stochastic cooling arrays , 1999, Proceedings of the 1999 Particle Accelerator Conference (Cat. No.99CH36366).

[25]  P. R. Sala,et al.  FLUKA: Present status and future developments , 1993 .

[26]  L. Faltin.  Slot-type pick-up and kicker for stochastic beam cooling , 1978 .

[27]  R. Fink,et al.  NEW PRINCIPLE FOR POWER SUPPLIES FOR SYNCtHROTRON MAGNETS WITtiOUT TRACKING ERRORS , 2022 .