Rapid Prototyping of Piezoelectric Ceramics via Selective Laser Sintering and Gelcasting

This article presents a new lost mold rapid prototyping method which combines selective laser sintering (SLS) and gelcasting techniques for fabricating piezoelectric ceramics. SLS was used to fabricate sacrificial molds of the desired structure of the ceramic part. Then aqueous PZT (lead zirconate titanate) suspension was cast in the mold and solidified in situ through formation of a three-dimensional network gel. Because the polymer mold can be easily removed at the initial stage of sintering and the gelcast PZT body has a high green strength, the desired geometry of the PZT part can be completely retained after sintering of the ceramics. Complex-shaped PZT parts were successfully fabricated after using concentrated PZT suspension with low viscosity. Densities and electrical properties, such as the d33, the relative permittivity e, the dielectric loss tgδ and the electromechanical coupling factor Kp of the gelcast PZT parts were also compared with those of the die-pressed PZT samples. The results indicated that the gel-forming process did not deteriorate the electrical properties of the samples, if proper dispersant was selected in developing concentrated ceramic slurry.

[1]  D. Guo,et al.  Application of gelcasting to the fabrication of piezoelectric ceramic parts , 2003 .

[2]  S. E. Feinberg,et al.  Hydroxyapatite implants with designed internal architecture , 2001, Journal of materials science. Materials in medicine.

[3]  M. Cima,et al.  Production of injection molding tooling with conformal cooling channels using the three dimensional printing process , 2000 .

[4]  S. Danforth,et al.  Multiple molds route for fabricating piezoelectric ceramic/polymer composites , 1999 .

[5]  S. Danforth,et al.  Development of piezoelectric ceramics and composites via SFF techniques for transducers , 1998 .

[6]  Duc Truong Pham,et al.  A comparison of rapid prototyping technologies , 1998 .

[7]  David B. Marshall,et al.  Rapid prototyping of functional ceramic composites , 1996 .

[8]  Joel W. Barlow,et al.  Selective laser sintering of alumina with polymer binders , 1995 .

[9]  M. Janney,et al.  Gelcasting of Alumina , 1991 .

[10]  H. A. Barnes,et al.  Shear‐Thickening (“Dilatancy”) in Suspensions of Nonaggregating Solid Particles Dispersed in Newtonian Liquids , 1989 .

[11]  P H Krebsbach,et al.  Indirect solid free form fabrication of local and global porous, biomimetic and composite 3D polymer-ceramic scaffolds. , 2003, Biomaterials.

[12]  Stephen C. Danforth,et al.  Fabrication of Piezoelectric Ceramic/Polymer Composite Transducers Using Fused Deposition of Ceramics , 2000 .

[13]  R. Crawford,et al.  Solid Freeform Fabrication: A New Direction in Manufacturing , 1997 .