Optical Design for Stationary Solar Concentrators

Solar electricity is one of the most promising technologies for our future electricity supply. By using concentrators, it is possible to reduce the cost of generating photovoltaic electricity. This thesis discusses how to design stationary low concentrating systems for photovoltaic or PV/Thermal applications. The first chapters briefly explain the optics of solar energy concentrators. The theoretical maximum concentration ratios of two dimensional and three dimensional systems were derived using the concept of etendue conservation and a review of current concentrators was presented. In order to improve existing concentrators, it is important to identify the most significant losses. This was done by characterization of an asymmetrically truncated CPC fitted with standard solar cells. The non uniform irradiance distribution on the cells was identified as the single most important reason for electrical losses. To address the problems of non uniform irradiance distribution, a structured reflector was introduced in the characterized system. The structured reflector created a more homogeneous light distribution on the cells, but because of larger optical losses, it was difficult to show any improved performance. It was expected that the more uniform distribution would improve the annual output, but to what extent was difficult to estimate. A new simulation based method for evaluation of photovoltaic concentrators was therefore developed. It consisted of three steps, optical simulations of the concentrator, electrical simulations to evaluate how the light distribution affected the output, and finally annual simulations to get an estimate of the annual electrical output. Using the new method, two new concentrators were developed. One of the systems was intended for roof integration, and the other for wall integration. Both systems were fitted with structured reflectors. The concentration ratio of both systems was increased compared to their references in order to utilize the optimum potential of the structured reflectors. It was shown that the roof concentrator would yield 191 kWh per m2 solar cells. This was 20% higher than the reference system. The wall concentrator was estimated to generate 213 kWh per m2 solar cells, which was 10% higher than the reference wall concentrator. Measurements on the newly developed roof concentrator showed that the more uniform irradiance distribution and increased concentration ratio increased the electrical output in the meridian plane. However, because of low manufacturing precision it was difficult to demonstrate this for all angles of incidence. The last chapter of the thesis discusses the advantages and disadvantages of possible changes to stationary photovoltaic concentrators. The chapter ends by defining a set of rules on how to design stationary concentrators with standard cells for maximum annual electrical output. (Less)

[1]  Björn Karlsson,et al.  Improving Asymmetrical CPCS for Photovoltaics by using micro structured Reflectors , 2004 .

[2]  Johan Nilsson,et al.  Design, Building Integration and Performance of a Hybrid Solar Wall Element , 2004 .

[3]  Björn Karlsson,et al.  Design of concentrating elements with CIS thin-film solar cells for facade integration , 2003 .

[4]  Björn Karlsson,et al.  Design and modelling of low-concentrating photovoltaic solar energy systems and investigation of irradiation distribution on modules in such systems , 2004 .

[5]  Björn Karlsson,et al.  Evaluation of CPC-collector designs for stand-alone, roof- or wall installation , 2005 .

[6]  Andreas Fieber.  Building Integration of Solar Energy. A Multifunctional Approach , 2005 .

[7]  Bengt Perers,et al.  External reflectors for large solar collector arrays, simulation model and experimental results , 1993 .

[8]  Maria Wall,et al.  Solar Protection in Buildings , 2001 .

[9]  N. Fraidenraich,et al.  Design procedure of V‐trough cavities for photovoltaic systems , 1998 .

[10]  Antonio Luque,et al.  Experimental verification of the illumination profile influence on the series resistance of concentrator solar cells , 1981 .

[11]  Maria Wall,et al.  Solar Protection in Buildings. Part 2: 2000-2002 , 2003 .

[12]  Roland Winston,et al.  Practical design considerations for CPC solar collectors , 1979 .

[13]  Björn Karlsson,et al.  Development of a MeReCo-Hybrid for Hammarby Sjöstad, Stockholm , 2004 .

[14]  P. Würfel,et al.  Physics of solar cells , 2005 .

[15]  Björn Karlsson,et al.  Optimized Truncation of a wide acceptance angle CPC , 2003 .

[16]  Johan Nilsson.  A Novel Method for Rapid Design and Evaluation of Photovoltaic Concentrators , 2007 .

[17]  Bengt Perers,et al.  Cooling of PV modules equipped with low-concentrating CPC reflectors , 1999 .

[18]  Spiros Papaefthimiou,et al.  CPC solar collectors with flat bifacial absorbers , 2000 .

[19]  D. R. Mills,et al.  Symmetrical and asymmetrical ideal cylindrical radiation transformers and concentrators , 1979 .

[20]  Philip C. Eames,et al.  Linear Dielectric Non-Imaging Concentrating Covers For PV Integrated Building Facades , 2000 .

[21]  Björn Karlsson,et al.  Irradiation distribution diagrams and their use for estimating collectable energy , 1997 .

[22]  Ralf Leutz,et al.  Squaring the circle: the use of microstructures for converting and homogenizing beam patterns , 2003, SPIE Optics + Photonics.

[23]  D. E. Williamson,et al.  Cone Channel Condenser Optics , 1952 .

[24]  J. Eikelboom,et al.  Improved treatment of the strongly varying slope in fitting solar cell I-V curves , 1996, Conference Record of the Twenty Fifth IEEE Photovoltaic Specialists Conference - 1996.

[25]  D. Schroder,et al.  Solar cell contact resistance—A review , 1984, IEEE Transactions on Electron Devices.

[26]  Bengt Perers,et al.  Optical properties of nonimaging concentrators with corrugated reflectors , 1994, Other Conferences.

[27]  Richard M. Swanson,et al.  The promise of concentrators , 2000 .

[28]  Y. Tripanagnostopoulos,et al.  Hybrid photovoltaic/thermal solar systems , 2002 .

[29]  Roland Winston,et al.  Consequences of etendue and skewness conservation for nonimaging devices with inhomogeneous sources and targets , 1997, Optics + Photonics.

[30]  Harald Ries,et al.  Upper bounds for the yearly energy delivery of stationary solar concentrators and the implications for concentrator optical design , 1996 .

[31]  Ralf Leutz,et al.  Micro-structured reflector surfaces for a stationary asymmetric parabolic solar concentrator , 2007 .

[32]  David R. Mills,et al.  New ideal concentrators for distant radiation sources , 1979 .

[33]  Antonio Luque,et al.  Electric and thermal model for non-uniformly illuminated concentration cells , 1998 .

[34]  L. Fraas,et al.  A novel space photovoltaic module using a linear Fresnel lens and a line-focus tandem cell receiver , 1993, Conference Record of the Twenty Third IEEE Photovoltaic Specialists Conference - 1993 (Cat. No.93CH3283-9).

[35]  David R. Mills,et al.  Multi-tower solar array , 2003 .

[36]  Lars Stolt,et al.  CIGS thin film PV modules for low-concentrating systems , 2001 .

[37]  D. Mills,et al.  Asymmetrical non-imaging cylindrical solar concentrators , 1978 .

[38]  Robert Pitz-Paal,et al.  Assessment of the potential improvement due to multiple apertures in central receiver systems with secondary concentrators , 2006 .

[39]  Antonio Luque,et al.  Solar Cells and Optics for Photovoltaic Concentration , 1989 .

[40]  Björn Karlsson,et al.  Optical properties, durability, and system aspects of a new aluminium-polymer-laminated steel reflector for solar concentrators , 2004 .

[41]  Alvin F. Hildebrandt,et al.  Solar thermal power system based on optical transmission , 1976 .

[42]  B. Chao.  COMPARISON OF SOLAR CONCENTRATORS , 2003 .

[43]  M. Green.  Solar Cells : Operating Principles, Technology and System Applications , 1981 .

[44]  A. Rabl.  Optical and thermal properties of Compound Parabolic Concentrators , 1975 .

[45]  Björn Karlsson,et al.  Biaxial model for the incidence angle dependence of the optical efficiency of photovoltaic systems with asymmetric reflectors , 2006 .

[46]  A. Maldonado,et al.  Physical properties of ZnO:F obtained from a fresh and aged solution of zinc acetate and zinc acetylacetonate , 2006 .

[47]  H. H. Safwat,et al.  Determination of the optimum orientations for the double-exposure, flat-plate collector and its reflectors , 1966 .

[48]  Roland Winston,et al.  Performance limitations of translationally symmetric nonimaging devices , 2001, SPIE Optics + Photonics.

[49]  Jeffrey M. Gordon,et al.  Truncation of CPC solar collectors and its effect on energy collection , 1985 .

[50]  Björn Karlsson,et al.  Optical efficiency of a PV-thermal hybrid CPC module for high latitudes , 2001 .

[51]  Helena Bülow-Hübe,et al.  Energy-Efficient Window Systems - Effects on Energy Use and Daylight in Buildings , 2001 .

[52]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[53]  A. Luque,et al.  The EUCLIDES prototype: An efficient parabolic trough for PV concentration , 1996, Conference Record of the Twenty Fifth IEEE Photovoltaic Specialists Conference - 1996.

[54]  Takao Kashiwagi,et al.  DESIGN OF A NONIMAGING FRESNEL LENS FOR SOLAR CONCENTRATORS 1 1 Paper presented at the ISES Solar Wo , 1999 .

[55]  Roland Winston,et al.  Principles of cylindrical concentrators for solar energy , 1975 .

[56]  W. R. McIntire.  Factored approximations for biaxial incident angle modifiers , 1982 .

[57]  David R. Mills.  The place of extreme asymmetrical non-focussing concentrators in solar energy utilization , 1978 .

[58]  Bengt Perers,et al.  On the factorisation of incidence angle modifiers for CPC collectors , 1995 .

[59]  B Karlsson,et al.  Optical acceptance function of modified compound parabolic concentrators with linear corrugated reflectors. , 1998, Applied optics.

[60]  J. Coventry.  Performance of a concentrating photovoltaic/thermal solar collector , 2005 .

[61]  Daniel Feuermann,et al.  High-concentration photovoltaic designs based on miniature parabolic dishes , 2001, SPIE Optics + Photonics.

[62]  H. Håkansson,et al.  Electrical and thermal characterization of a PV-CPC hybrid , 2007 .

[63]  Roland Winston,et al.  Principles of solar concentrators of a novel design , 1974 .

[64]  Ralf Leutz,et al.  Microstructured light guides overcoming the two-dimensional concentration limit. , 2005, Applied optics.

[65]  Maria Wall,et al.  Sustainable Solar Housing Volume 1 , 2009 .

[66]  P. Benítez,et al.  A high-gain, compact, nonimaging concentrator: RXI. , 1995, Applied optics.

[67]  Tapas K. Mallick,et al.  The design and experimental characterisation of an asymmetric compound parabolic photovoltaic concentrator for building façade integration in the UK , 2004 .

[68]  Evan Franklin,et al.  Effects of highly non-uniform illumination distribution on electrical performance of solar cells , 2002 .