Restart time correlation for core annular flow in pipeline lubrication of high-viscous oil

One of the fundamental questions that must be addressed in the effective design and operation of pipeline lubrication of heavy oil is; “how much time will be needed to restart a blocked core annular flow (CAF) line after shutdown due to fouling or pump failures”, if the pipe is to be cleaned using water only. In this work, laboratory results of shutdown and restart experiments of high-viscous oil conducted in a 5.5-m-long PVC horizontal pipe with internal diameter of 26 mm are first presented. A new correlation for the prediction of the restart time of a shutdown core annular flow line is then formulated. The predictive capabilities of the correlation are checked against measured restart time and pressure drop evolution data. Somewhat high but still reasonable predictions are obtained. The restart time correlation, together with the associated correlations formulated as well, can be of practical importance during the engineering design of high-viscous oil pipeline transportation facility for predicting restart process.

[1]  A. Saniere,et al.  Pipeline Transportation of Heavy Oils, a Strategic, Economic and Technological Challenge , 2004 .

[2]  Pietro Poesio,et al.  Experimental study on the restart of core-annular flow , 2012 .

[3]  Daniel D. Joseph,et al.  Fundamentals of two-fluid dynamics , 1993 .

[4]  Daniel D. Joseph,et al.  Cement-lined pipes for water lubricated transport of heavy oil , 1996 .

[5]  P. Poesio,et al.  Experiments on Start-Up of an Oil-Water Core Annular Flow Through a Horizontal or Nearly Horizontal Pipe , 2007 .

[6]  V. A. Adewusi,et al.  Optimal formulation of caustic systems for emulsion transportation and dehydration of heavy oil , 1993 .

[7]  Abdelsalam Al-Sarkhi,et al.  Effect of drag reducing polymers on oil-water flow in a horizontal pipe , 2009 .

[8]  Antonio Carlos Bannwart,et al.  Flow Patterns in Heavy Crude Oil-Water Flow , 2001 .

[9]  Antonio Carlos Bannwart,et al.  Wettability alteration of internal surfaces of pipelines for use in the transportation of heavy oil via core-flow , 2006 .

[10]  Antonio Carlos Bannwart,et al.  A model for interpretation of a re-start experiment of viscous oil-water annular flow , 2007 .

[11]  Antonio Carlos Bannwart,et al.  Contact angle measurements and wetting behavior of inner surfaces of pipelines exposed to heavy crude oil and water , 2006 .

[12]  Yannick Peysson,et al.  Pipeline Lubrication of Heavy Oil: Experimental Investigation of Flow and Restart Problems , 2007 .

[13]  Neima Brauner,et al.  Liquid-Liquid Two-Phase Flow Systems , 2003 .

[14]  Yannick Peysson,et al.  Experimental Study of the Pipeline Lubrication for Heavy Oil Transport , 2004 .

[15]  R. V. A. Oliemans,et al.  Core-Annular Flow of Oil and Water through a Pipeline , 1986 .

[16]  Prasanta Kumar Das,et al.  Review of oil water core annular flow , 2009 .

[17]  Antonio C. S. Ramos,et al.  Asfaltenos em petroleos brasileiros : agregação em solventes aromaticos, desenvolvimento de aditivos e estabilização de emulsões , 2001 .

[18]  Daniel D. Joseph,et al.  CORE-ANNULAR FLOWS , 1997 .