Soft and hard natures of Nd2Fe14B permanent magnet explored by first-order-reversal-curves

Two commercial Nd2Fe14B samples, MQP-B and sintered-NdFeB were investigated using synchrotronbased x-ray diffraction and first-order-reversal-curves (FORCs). Despite differing in magnetic and structural properties, the two samples were found to comprise two major ferromagnetic components in FORCs. For the sintered-NdFeB case, the soft component may originate from the intrinsically soft Nd-f site which was coupled with its local Fe atomic environment that differs in magnetic anisotropy from the Nd-g site (intrinsically hard). It may directly originate from the Nd-rich phase or microstructural imperfection, while the former possibility (Nd-f site) appears greater than the latter. While for the MQP-B, the minor second phase resulting from high structural disorder was likely in charge of the presence of the soft component. Sophisticated FORCs analyses revealed the natures of the soft and hard components, soft–hard coupling and switching reversibility of the two cases, irrespective of the origins of their two components. This provides insights to the origin of magnetic stability and reversal dynamics of Nd 2 Fe14B that have not been fully understood by conventional magnetic analyses. The coexistence of the two components led to an incoherent reversal undermining the magnetic stability of Nd2Fe14B. This is a fundamental problem as to why the performance extremity can only be improved finitely through extrinsic tuning. From FORCs simulation we understand that the soft–hard coupling was moderate in a real Nd2Fe14B compound. A stronger soft–hard coupling is necessary to conquer the anisotropic competition to enable a coherent reversal that will promote the magnetic hardness.

[1]  M. Sagawa,et al.  Improvement of coercivity of sintered NdFeB permanent magnets by heat treatment , 2002 .

[2]  I. Schuller,et al.  Temperature induced single domain-vortex state transition in sub-100 nm Fe nanodots , 2007 .

[3]  Jiro Yamasaki,et al.  Anisotropic Nd–Fe–B thin‐film magnets for milli‐size motor , 1991 .

[4]  P. Canfield,et al.  Atomic origin of magnetocrystalline anisotropy in Nd(2)Fe(14)B. , 2005, Physical review letters.

[5]  T. G. Woodcock,et al.  Influence of defect thickness on the angular dependence of coercivity in rare-earth permanent magnets , 2014, 1603.08248.

[6]  Caroline A. Ross,et al.  First-order reversal curve diagram analysis of a perpendicular nickel nanopillar array , 2005 .

[7]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[8]  I. Panagiotopoulos.  A simple approach to the First Order Reversal Curves (FORC) of two-phase magnetic systems , 2011 .

[9]  A. Stancu,et al.  Using experimental FORC distribution as input for a Preisach-type model , 2006, INTERMAG 2006 - IEEE International Magnetics Conference.

[10]  B. Ma,et al.  Microstructural control of NdFeB cast ingots for achieving 50 MGOe sintered magnets , 1996 .

[11]  Andrew P. Roberts,et al.  Characterizing interactions in fine magnetic particle systems using first order reversal curves , 1999 .

[12]  K. Rao,et al.  Effect of Al, Cu, Ga, and Nb additions on the magnetic properties and microstructural features of sintered NdFeB , 2002 .

[13]  G. Han,et al.  Effective anisotropy between magnetically soft and hard grains in nanocomposite magnets , 2005 .

[14]  Andrew G. Glen,et al.  APPL , 2001 .

[15]  V. Stolyarov,et al.  Controllable nanocrystallization in amorphous Nd9Fe85B6 via combined application of severe plastic deformation and thermal annealing , 2007 .

[16]  G. Han,et al.  Study of high-coercivity sintered NdFeB magnets , 2007 .

[17]  Recent developments in the sintering of NdFeB , 2001 .

[18]  A. Stancu,et al.  Experimental and micromagnetic first-order reversal curves analysis in NdFeB-based bulk “exchange spring”-type permanent magnets , 2007 .

[19]  H. Chiriac,et al.  Magnetic properties and microstructure in NdFeB strip-cast permanent magnets , 2001 .

[20]  E. Jezierska,et al.  Improvement of the Properties of Hard Magnetic NdFeb/Fe Nanocomposites by Minor Addition of Refractory Metals , 2011 .

[21]  D. M. Tsamakis,et al.  Torque transfer through plastic bonded Nd2Fe14B magnetic gear system , 1996 .

[22]  Yamada,et al.  Crystal-field analysis of the magnetization process in a series of Nd2Fe14B-type compounds. , 1988, Physical Review B (Condensed Matter).

[23]  L. Clime,et al.  Reversible and quasireversible information in first-order reversal curve diagrams , 2007 .

[24]  Zhongwu Liu,et al.  The practical limits for enhancing magnetic property combinations for bulk nanocrystalline NdFeB alloys through Pr, Co and Dy substitutions , 2007 .

[25]  Helen Ashton,et al.  Encyclopedia of Geomagnetism and Paleomagnetism , 2008 .

[26]  F. Preisach.  Über die magnetische Nachwirkung , 1935 .

[27]  S. Andreev,et al.  Microstructure–magnetic properties relationships in nanocrystalline Nd–Fe–Co–Ge–B annealed ribbons , 2006 .

[28]  Jinwoo Kim,et al.  Effect of cyclic sintering process for NdFeB magnet on microstructure and magnetic properties , 2012 .

[29]  Tingting Liu,et al.  Effect of Terbium addition on the coercivity of the sintered NdFeB magnets , 2010 .

[30]  L. Pampillo,et al.  First-order reversal curve analysis in the hysteretic behavior of boron-rich nanocomposite Nd-Fe-B ribbons , 2007 .

[31]  Youwei Du,et al.  Effects of Mn doping on structural and magnetic properties in NdFeB nanocomposites , 2004 .

[32]  D. Gubbins,et al.  Encyclopedia of geomagnetism and paleomagnetism , 2007 .

[33]  Hyoung-Tae Kim,et al.  Nanocrystalline NdFeB magnets fabricated by a modified hot-working process , 2003 .

[34]  T. Schrefl,et al.  First order reversal curve studies of permanent magnets , 2012 .

[35]  David Brown,et al.  Developments in the processing and properties of NdFeb-type permanent magnets , 2002 .

[36]  M. Katter,et al.  Dependence of the Mean Grain Size and Coercivity of Sintered Nd-Fe-B Magnets on the Initial Powder Particle Size , 2006, INTERMAG 2006 - IEEE International Magnetics Conference.

[37]  A. Manaf,et al.  Magnetic properties and microstructural characterisation of isotropic nanocrystalline Fe-Nd-B based alloys , 1993 .

[38]  R. Street,et al.  Mechanically alloyed nanocomposite magnets (invited) , 1998 .

[39]  M. Schlesinger,et al.  Fundamentals of Electrochemical Deposition , 1998 .

[40]  Baoyi Wang,et al.  Exchange-coupling interaction, effective anisotropy and coercivity in nanocomposite permanent materials , 2003 .

[41]  I. Schuller,et al.  Magnetic fingerprints of sub-100 nm Fe dots , 2007, 0704.0127.

[42]  J. Jakubowicz,et al.  Nanocomposite Nd2(Fe,Co,Cr)14B/α-Fe materials , 1998 .

[43]  G. Han,et al.  Magnetic properties and coercivity mechanism of isotropic HDDR NdFeB bonded magnets with Co and Dy addition , 2003 .

[44]  T. Schrefl,et al.  Grain-size dependence of remanence and coercive field of isotropic nanocrystalline composite permanent magnets , 1996 .

[45]  J. F. Herbst,et al.  R 2 Fe 14 B materials: Intrinsic properties and technological aspects , 1991 .

[46]  C. R. Pike.  First-order reversal-curve diagrams and reversible magnetization , 2003 .

[47]  Y. Liu,et al.  Effect of Nb substitution on the temperature characteristics and microstructures of rapid-quenched NdFeB alloy , 2007 .

[48]  A. Yelon,et al.  First-order reversal curve diagrams of magnetic entities with mean interaction field: A physical analysis perspective , 2008 .

[49]  Vittorio Basso,et al.  Considerations on the physical interpretation of the Preisach model of ferromagnetic hysteresis , 1993 .

[50]  H. Kronmüller,et al.  Initial magnetization curve and hardening mechanism in rapidly quenched NdFeB magnets , 1990 .

[51]  B. Ma,et al.  The effects of average grain size on the magnetic properties and corrosion resistance of NdFeB sintered magnets , 1996 .

[52]  H. Davies.  High coercivity Zr and Co substituted (Nd-Pr)-Fe-B nanophase hard magnetic alloys , 2001 .