Reducing NOx Emissions for a 600 MWe Down-Fired Pulverized-Coal Utility Boiler by Applying a Novel Combustion System.

A novel combustion system was applied to a 600 MWe Foster Wheeler (FW) down-fired pulverized-coal utility boiler to solve high NOx emissions, without causing an obvious increase in the carbon content of fly ash. The unit included moving fuel-lean nozzles from the arches to the front/rear walls and rearranging staged air as well as introducing separated overfire air (SOFA). Numerical simulations were carried out under the original and novel combustion systems to evaluate the performance of combustion and NOx emissions in the furnace. The simulated results were found to be in good agreement with the in situ measurements. The novel combustion system enlarged the recirculation zones below the arches, thereby strengthening the combustion stability considerably. The coal/air downward penetration depth was markedly extended, and the pulverized-coal travel path in the lower furnace significantly increased, which contributed to the burnout degree. The introduction of SOFA resulted in a low-oxygen and strong-reducing atmosphere in the lower furnace region to reduce NOx emissions evidently. The industrial measurements showed that NOx emissions at full load decreased significantly by 50%, from 1501 mg/m3 (O2 at 6%) to 751 mg/m3 (O2 at 6%). The carbon content in the fly ash increased only slightly, from 4.13 to 4.30%.

[1]  J. J. Pis,et al.  Nitric oxide reduction in coal combustion: role of char surface complexes in heterogeneous reactions. , 2002, Environmental science & technology.

[2]  C. Yin.  On gas and particle radiation in pulverized fuel combustion furnaces , 2015 .

[3]  Shien Hui,et al.  Study of optimal pulverized coal concentration in a four-wall tangentially fired furnace , 2011 .

[4]  G. Soete.  Overall reaction rates of NO and N2 formation from fuel nitrogen , 1975 .

[5]  S. C. Hill,et al.  Modeling of nitrogen oxides formation and destruction in combustion systems , 2000 .

[6]  Lin Ma,et al.  Modelling methods for co-fired pulverised fuel furnaces , 2009 .

[7]  Chang Nyung Kim,et al.  Numerical investigation on the flow, combustion and NOx emission characteristics in a 500 MWe tangentially fired pulverized-coal boiler , 2009 .

[8]  Filip Johnsson,et al.  Emission control of nitrogen oxides in the oxy-fuel process , 2009 .

[9]  S. S. Daood,et al.  Combustion of Pakistani Lignite (Thar Coal) in a Pilot-Scale Pulverized Fuel Down-Fired Combustion Test Facility , 2014 .

[10]  M. Pourkashanian,et al.  MODELLING PULVERISED COAL COMBUSTION USING A DETAILED COAL COMBUSTION MODEL , 2006 .

[11]  Huaichun Zhou,et al.  Improving the Performance of a 300 MW Down-Fired Pulverized-Coal Utility Boiler by Inclining Downward the F-Layer Secondary Air , 2010 .

[12]  Qingyan Fang,et al.  Numerical Simulation of Multifuel Combustion in a 200 MW Tangentially Fired Utility Boiler , 2012 .

[13]  S. S. Daood,et al.  Deep-staged, oxygen enriched combustion of coal , 2012 .

[14]  Qingyan Fang,et al.  Numerical simulations of the slagging characteristics in a down-fired, pulverized-coal boiler furnace , 2010 .

[15]  S. S. Daood,et al.  Investigation of the influence of metallic fuel improvers on coal combustion/pyrolysis , 2014 .

[16]  Luis I. Díez,et al.  Numerical investigation of NOx emissions from a tangentially-fired utility boiler under conventional and overfire air operation , 2008 .

[17]  Shien Hui,et al.  NOx emission and thermal efficiency of a 300 MWe utility boiler retrofitted by air staging , 2009 .

[18]  Zhengqi Li,et al.  Review of gas/particle flow, coal combustion, and NOx emission characteristics within down-fired boilers , 2014 .

[19]  Min Kuang,et al.  Influence of staged-air on airflow, combustion characteristics and NO(x) emissions of a down-fired pulverized-coal 300 MW(e) utility boiler with direct flow split burners. , 2010, Environmental science & technology.

[20]  Klaus R. G. Hein,et al.  Development of an air staging technology to reduce NOx emissions in grate fired boilers , 2005 .

[21]  B. M. Gibbs,et al.  NOx control in coal combustion by combining biomass co-firing, oxygen enrichment and SNCR , 2013 .

[22]  János M. Beér,et al.  Combustion technology developments in power generation in response to environmental challenges , 2000 .

[23]  Behdad Moghtaderi,et al.  A computational fluid dynamics based study of the combustion characteristics of coal blends in pulverised coal-fired furnace , 2004 .

[24]  Min Kuang,et al.  Improving combustion characteristics and NO(x) emissions of a down-fired 350 MW(e) utility boiler with multiple injection and multiple staging. , 2011, Environmental science & technology.

[25]  J. Azevedo,et al.  EXPERIMENTAL CHARACTERIZATION OF AN INDUSTRIAL PULVERIZED COAL-FIRED FURNACE UNDER DEEP STAGING CONDITIONS , 2007 .

[26]  Zhichao Chen,et al.  Improved NOx emissions and combustion characteristics for a retrofitted down-fired 300-MWe utility boiler. , 2010, Environmental science & technology.

[27]  Kim Dam-Johansen,et al.  The effect of combustion conditions in a full-scale low-NOx coal fired unit on fly ash properties for its application in concrete mixtures , 2009 .

[28]  Zhengchun Lin,et al.  Effect of Air-Staging on Anthracite Combustion and NOx Formation , 2009 .

[29]  Jean-Luc Harion,et al.  Investigation of the flow, combustion, heat-transfer and emissions from a 609MW utility tangentially fired pulverized-coal boiler , 2002 .

[30]  S. S. Daood,et al.  Fuel additive technology – NOx reduction, combustion efficiency and fly ash improvement for coal fired power stations , 2014 .

[31]  Zhichao Chen,et al.  Influence of the overfire air ratio on the NO(x) emission and combustion characteristics of a down-fired 300-MW(e) utility boiler. , 2010, Environmental science & technology.