The Multilevel Technique for Improving Filterless class-d Audio amplifiers

Class-D amplifier features very high efficiency on power delivery because its switching operation consumes tiny static power on very low on-resistance. In this work, a multilevel technique is presented to improve total-harmonic-distortion (THD) and signal-to-noise-ratio (SNR) of pulse-width-modulation (PWM) filterless class-D amplifiers. The proposed method consists of a multilevel converter and a time division adder (TDA) followed by PWM modulator. The PWM-modulated signal is arranged into several time divisions and then integrated and encoded to a set of parallel control signals for multilevel converter. Instead of the two-level PWM signal, the output signal of a multilevel converter is as stairway with less transient variation. The performance of THD and SNR are therefore improved because the instantaneous variation of signal is greatly reduced. To demonstrate the proposed method, a filterless audio amplifier was implemented by TSMC 5 V–0.35 μm CMOS technology. With 8 Ω speaker and 550 mW maximum power, experiment results show that the THD, SNR and power efficiency can be achieved over 0.02%, 85 dB and 85%, respectively.

[1]  Philip T. Krein,et al.  High-fidelity PWM inverter for digital audio amplification: Spectral analysis, real-time DSP implementation, and results , 2003 .

[2]  Edgar Sánchez-Sinencio,et al.  A Low-Power High-PSRR Clock-Free Current-Controlled Class-D Audio Amplifier , 2011, IEEE Journal of Solid-State Circuits.

[3]  G. Burra,et al.  A 700+-mW class D design with direct battery hookup in a 90-nm process , 2005, IEEE Journal of Solid-State Circuits.

[4]  P.P. Siniscalchi,et al.  A 20 W/Channel Class-D Amplifier With Near-Zero Common-Mode Radiated Emissions , 2009, IEEE Journal of Solid-State Circuits.

[5]  Fang Zheng Peng,et al.  Multilevel converters-a new breed of power converters , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[6]  Edgar Sánchez-Sinencio,et al.  Design of a Class D Audio Amplifier IC Using Sliding Mode Control and Negative Feedback , 2007, IEEE Transactions on Consumer Electronics.

[7]  Mehdi Ferdowsi,et al.  Active Capacitor Voltage Balancing in Single-Phase Flying-Capacitor Multilevel Power Converters , 2012, IEEE Transactions on Industrial Electronics.

[8]  Mei-Ling Yeh,et al.  An Electromagnetic Interference (EMI) Reduced High-Efficiency Switching Power Amplifier , 2010, IEEE Transactions on Power Electronics.

[9]  P.N. Enjeti,et al.  A Carrier-Based PWM Method With Optimal Switching Sequence for a Multilevel Four-Leg Voltage-Source Inverter , 2008, IEEE Transactions on Industry Applications.

[10]  Marco Berkhout,et al.  Class-D Audio Amplifiers in Mobile Applications , 2010, IEEE Transactions on Circuits and Systems I: Regular Papers.

[11]  Joseph Sylvester Chang,et al.  Filterless class D amplifiers: power-efficiency and power dissipation , 2010, IET Circuits Devices Syst..

[12]  Henry Shu-Hung Chung,et al.  Reduction of power converter EMI emission using soft-switching technique , 1998 .

[13]  V.F. Pires,et al.  Narrow Pulse Elimination PWM for Multilevel Digital Audio Power Amplifiers Using Two Cascaded H-Bridges as a Nine-Level Converter , 2007, IEEE Transactions on Power Electronics.

[14]  J. S. Chang,et al.  Analysis and design of power efficient class D amplifier output stages , 2000 .

[15]  Francisco D. Freijedo,et al.  Multilevel multiphase space vector PWM algorithm with switching state redundancy applied to three-phase four-leg converters , 2009, IECON 2010 - 36th Annual Conference on IEEE Industrial Electronics Society.

[16]  Simon S. Ang,et al.  A multi-loop voltage feedback filterless class-D switching audio amplifier using unipolar pulse-width-modulation , 2004, IEEE Transactions on Consumer Electronics.

[17]  Jang-Kyoo Shin,et al.  Low cost implementation of filterless class D audio amplifier with constant switching frequency , 2006, IEEE Transactions on Consumer Electronics.

[18]  Edgar Sánchez-Sinencio,et al.  Low-Power High-Efficiency Class D Audio Power Amplifiers , 2009, IEEE Journal of Solid-State Circuits.

[19]  Simon Cimin Li,et al.  New high-efficiency 2.5 V/0.45 W RWDM class-D audio amplifier for portable consumer electronics , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.