Online Estimation of Ship's Mass and Center of Mass Using Inertial Measurements

A ship's roll dynamics is sensitive to the mass and mass distribution. Changes in these physical properties might introduce unpredictable behavior of the ship and a worst-case scenario is that the ship will capsize. In this paper, a recently proposed approach for online estimation of mass and center of mass is validated using experimental data. The experiments were performed using a scale model of a ship in a wave basin. The data were collected in free run experiments where the rudder angle was recorded and the ship's motion was measured using an inertial measurement unit. The motion measurements are used in conjunction with a model of the roll dynamics to estimate the desired properties. The estimator uses the rudder angle measurements together with an instrumental variable method to mitigate the influence of disturbances. The experimental study shows that the properties can be estimated with quite good accuracy but that variance and robustness properties can be improved further.

[1]  Mogens Blanke,et al.  Rudder-Roll Damping Autopilot Robustness to Sway-Yaw-Roll Couplings , 1993 .

[2]  H.K. Fathy,et al.  Online vehicle mass estimation using recursive least squares and supervisory data extraction , 2008, 2008 American Control Conference.

[3]  Biao Huang,et al.  System Identification , 2000, Control Theory for Physicists.

[4]  Fredrik Gustafsson,et al.  Identifiability of physical parameters in systems with limited sensors , 2014 .

[5]  Lennart Ljung,et al.  System Identification: Theory for the User , 1987 .

[6]  P. Young,et al.  A REFINED IV METHOD FOR CLOSED-LOOP SYSTEM IDENTIFICATION , 2006 .

[7]  Maxime Thys.  Theoretical and experimental investigation of a free running fishing vessel at small frequency of encounter , 2013 .

[8]  Thor I. Fossen,et al.  Handbook of Marine Craft Hydrodynamics and Motion Control: Fossen/Handbook of Marine Craft Hydrodynamics and Motion Control , 2011 .

[9]  Alex Simpkins,et al.  System Identification: Theory for the User, 2nd Edition (Ljung, L.; 1999) [On the Shelf] , 2012, IEEE Robotics & Automation Magazine.

[10]  Alexandre S. Bazanella,et al.  Closed-loop identification of MIMO systems: a new look at identifiability and experiment design , 2007, 2007 European Control Conference (ECC).

[11]  Fredrik Gustafsson,et al.  Modeling for IMU-based Online Estimation of a Ship's Mass and Center of Mass , 2015 .

[12]  Alexandre N. Simos,et al.  Estimating directional wave spectrum based on stationary ship motion measurements , 2003 .

[13]  Toshio Iseki,et al.  Bayesian Estimation of Directional Wave Spectra For Ship Guidance System , 2002 .

[14]  Leigh McCue,et al.  Handbook of Marine Craft Hydrodynamics and Motion Control [Bookshelf] , 2016, IEEE Control Systems.

[15]  Jonas Linder,et al.  Graybox Modelling of Ships Using Indirect Input Measurements , 2014 .

[16]  Ian Postlethwaite,et al.  Multivariable Feedback Control: Analysis and Design , 1996 .

[17]  Tristan Perez,et al.  Ship Motion Control: Course Keeping and Roll Stabilisation Using Rudder and Fins , 2005 .

[18]  Fredrik Gustafsson,et al.  A closed-loop instrumental variable approach to mass and center of mass estimation using IMU data , 2014, 53rd IEEE Conference on Decision and Control.