论文信息 - Analysis of Cutting Zone Machinability during the Drilling of XCr18Ni8 Stainless Steel

Analysis of Cutting Zone Machinability during the Drilling of XCr18Ni8 Stainless Steel

This paper presents the conclusions of machinability tests on a XCr18Ni8 stainless steel. The content of this article also focuses on the analysis of selected basic indicators of steel machinability: quality of the processed surface. The results of the article are conclusions for working theory and practice for drillng of austenitic stainless steels. Based on the cutting tests, cutting speeds of 40 to 60 m/min, feed rate of 0.04 to 1.2 mm and screw drill carbide monolite.

[1] K. Stępień,et al. Statistical Validation of the Method for Measuring Radius Variations of Components on the Machine Tool , 2011 .

[2] N. Suh. New theories of wear and their implications for tool materials , 1980 .

[3] P. C. Veenstra,et al. The Minimum Energy Principle for the Cutting Process in Theory and Experiment , 1981 .

[4] Anton Panda,et al. Accompanying phenomena in the cutting zone machinability during turning of stainless steels , 2009 .

[5] I. Jawahir,et al. Tool-wear mechanisms in hard turning with polycrystalline cubic boron nitride tools , 2001 .

[6] Donald Peckner,et al. Handbook of Stainless Steels , 1977 .

[7] Anton Panda,et al. Study of changes under the machined surface and accompanying phenomena in the cutting zone during drilling of stainless steels with low carbon content , 2011 .

[8] J. H. Dautzenberg,et al. Forces and Plastic Work in Cutting , 1983 .

[9] Bryan Kok Ann Ngoi,et al. Wear characteristics of PCBN tools in the ultra-precision machining of stainless steel at low speeds , 2003 .