Mass flow measurement of pneumatically conveyed solids using electrical capacitance tomography

This paper describes a measurement system for mass flow measurement in a pneumatic pipeline. The system mainly consists of a volumetric concentration sensor and a velocity sensor. The concentration sensor is an electrical capacitance sensor which has eight electrodes; the velocity sensor is based on cross-correlating two signals derived from a pair of capacitance sensors. A cyclone is employed in this system where the sensors are placed in order to compensate the inhomogeneity of the sensor sensitivity. Experimental results obtained on a pneumatic conveyer circulating coal ash demonstrate that this system is capable of detecting various velocity profiles and solids distributions and providing an absolute mass flow rate of solids within a good agreement with the reference reading from load cells.

[1]  Steven L. Ceccio,et al.  Capacitance measurements of solid concentration in gas–solid flows , 2003 .

[2]  Shien Hui,et al.  A novel capacitive system for the concentration measurement of pneumatically conveyed pulverized fuel at power stations , 2006 .

[3]  Steven L. Ceccio,et al.  Quantitative measurement of solids distribution in gas–solid riser flows using electrical impedance tomography and gamma densitometry tomography , 2006 .

[4]  Tomasz Dyakowski,et al.  Measurement of particle velocity distribution in a vertical channel , 1993 .

[5]  Lihui Peng,et al.  Image reconstruction algorithms for electrical capacitance tomography , 2003 .

[6]  Steve Woodhead,et al.  Laser Doppler velocimetry measurements of particle velocity profiles in gas-solid two-phase flows , 1995, Proceedings of 1995 IEEE Instrumentation and Measurement Technology Conference - IMTC '95.

[7]  K. Abe,et al.  Mass Flowmeter Using Heat Transfer for Dense Phase Solid Gas Two Phase Flow , 1986 .

[8]  A. Plaskowski,et al.  Cross Correlation Flowmeters, Their Design and Application , 1987 .

[9]  Mark A. Bennett,et al.  Application of capacitance electrical tomography for on-line and off-line analysis of flow pattern in horizontal pipeline of pneumatic conveyer , 2000 .

[10]  Tony P. Pridmore,et al.  Optical fibre sensors for process tomography , 1995 .

[11]  Wuqiang Yang,et al.  Role of tomography in gas/solids flow measurement , 2000 .

[12]  Richard A Williams,et al.  Solids Flow Imaging and Attrition Studies in a Pneumatic Conveyor , 1995 .

[13]  Wuqiang Yang,et al.  Optimization of an iterative image reconstruction algorithm for electrical capacitance tomography , 1999 .

[14]  R A Furness,et al.  Mass Flow Measurement — A State of the Art Review , 1990 .

[15]  Wuqiang Yang,et al.  Prior-online iteration for image reconstruction with electrical capacitance tomography , 2004 .

[16]  Yong Yan,et al.  Mass flow measurement of pneumatically conveyed solids using radiometric sensors , 2000 .

[17]  Yong Yan,et al.  REVIEW ARTICLE: Mass flow measurement of bulk solids in pneumatic pipelines , 1996 .

[18]  Joachim Werther,et al.  Measurement of local particle velocities and velocity distributions in gas-solid flows by means of the spatial filter method , 1997 .

[19]  Nabil Gindy,et al.  Investigation on concentration distribution and mass flow rate measurement for gravity chute conveyor by optical tomography system , 2006 .