Development and validation of a time-series model for real-time thermal load estimation

Abstract Dynamic cooling load changes caused by weather, occupants and equipment use are prevailing challenges for heating, ventilating and air conditioning (HVAC) system design, operation and controls. The thermal capacity of a building envelope delays conduction heat gains while the thermal capacity of the whole structure delays radiative cooling loads. These delays make cooling load calculations inherently complicated. It has been challenging to accurately estimate cooling load in a building in real-time. In this paper, a time-series cooling load model is deduced from a simplified resistance–capacitance (RC) model to provide an efficient solution with manageable computational requirements. In addition, the time-series model is also tested on a thermal zone in an office building, defined in EnergyPlus as a single zone with an ideal HVAC system. RC parameters of building envelope and internal mass are obtained using theoretical characteristics of the building construction in frequency domain and EnergyPlus data, respectively. These are used in formulation of a time-series representation of the cooling load for three scenarios of light, medium, and heavy construction of a thermal zone in an office building. For all scenarios, cooling load with the simplified time series model is estimated within 7% mean absolute percentage error relative to EnergyPlus.

[1]  Samuel Hassid.  A linear model for passive solar calculations: Evaluation of performance , 1985 .

[2]  Fredrik Wallin,et al.  Forecasting for demand response in smart grids: An analysis on use of anthropologic and structural data and short term multiple loads forecasting , 2012 .

[3]  Siew-Chong Tan,et al.  Development of an ambient air temperature prediction model , 2014 .

[4]  Prabir Barooah,et al.  Identification of multi-zone building thermal interaction model from data , 2011, IEEE Conference on Decision and Control and European Control Conference.

[5]  Martine Baelmans,et al.  Thermal response of thermally activated building systems (TABS) in office buildings , 2009 .

[6]  Francesco Causone,et al.  Solar radiation and cooling load calculation for radiant systems: Definition and evaluation of the Direct Solar Load , 2010 .

[7]  Brandon Hencey,et al.  Online building thermal parameter estimation via Unscented Kalman Filtering , 2012, 2012 American Control Conference (ACC).

[8]  A. R. Braga,et al.  On the characterization and monitoring of building energy demand using statistical process control methodologies , 2013 .

[9]  Melanie Mitchell,et al.  An introduction to genetic algorithms , 1996 .

[10]  R. Britter,et al.  A resistance-capacitance network model for the analysis of the interactions between the energy performance of buildings and the urban climate , 2012 .

[11]  Zheng O'Neill,et al.  MODEL-BASED THERMAL LOAD ESTIMATION IN BUILDINGS , 2010 .

[12]  Andrew G. Alleyne,et al.  IDENTIFICATION OF BUILDING MODEL PARAMETERS AND LOADS USING ON-SITE DATA LOGS , 2008 .

[13]  Shengwei Wang,et al.  Parameter estimation of internal thermal mass of building dynamic models using genetic algorithm , 2006 .

[14]  Shuichi Hokoi,et al.  Statistical time series models of solar radiation and outdoor temperature — Identification of seasonal models by Kalman filter , 1990 .

[15]  Fred Bauman,et al.  Cooling load differences between radiant and air systems , 2013 .

[16]  Edward Henry Mathews,et al.  Efficient, steady state solution of a time variable RC network, for building thermal analysis , 1992 .

[17]  John Mitchell,et al.  Transfer Functions for Efficient Calculation of Multidimensional Transient Heat Transfer , 1989 .

[18]  Christophe Menezo,et al.  IDENTIFICATION OF EQUIVALENT THERMAL RC NETWORK MODELS BASED ON STEP RESPONSE AND GENETIC ALGORITHMS , 2011 .

[19]  Li Song,et al.  Next-Day Daily Energy Consumption Forecast Model Development and Model Implementation , 2012 .

[20]  William J. Kaiser,et al.  Real-time, appliance-level electricity use feedback system: How to engage users? , 2014 .

[21]  Gudni Jóhannesson,et al.  Optimised RC Networks Incorporated within Macro-Elements for Modelling Thermally Activated Building Constructions , 2004 .

[22]  Edward Henry Mathews,et al.  A two-port envelope model for building heat transfer , 1998 .

[23]  Peng Xu,et al.  THE BUILDING CONTROLS VIRTUAL TEST BED - A SIMULATION ENVIRONMENT FOR DEVELOPING AND TESTING CONTROL ALGORITHMS, STRATEGIES AND SYSTEMS , 2007 .

[24]  Michael Wetter,et al.  A framework for simulation-based real-time whole building performance assessment , 2012 .