Effective discharge calculation: a practical guide

Abstract : An alluvial river adjusts the dimensions of its channel to the wide range of flows that mobilize its boundary sediments. However, in man)' rivers it has been demonstrated that a single representative discharge can be used to determine a stable channel geometry. The use of a single representative discharge is the foundation of "regime" and "hydraulic geometry" theories for detennining morphological characteristics of alluvial channels and rivers. This representative discharge has been given several names by different researchers including dominant discharge, channel forming discharge, effective discharge, and bankfull discharge. This has led to some confusion. The channel forming discharge and the dominant discharge are equivalent and are defined as a theoretical discharge that if maintained indefinitely would result in the same channel geometry as the existing channel subiect to the natural range of flow events. Although conceptually attractive, this definition is not necessarily physically feasible, because bank line vegetation, bank stability and even the bed configuration would be different in a natural stream than in a constant discharge stream. Channel-forming discharge concepts are applicable to stable stream systems, i.e., streams that are neither aggrading or degrading. Channel-forming discharge can be estimated using one of three prescribed methodologies. One such deterministic discharge is the bankfull discharge, which is the discharge that fills the channel to the top of its banks. Another deterministic discharge used to represent the channel-forming discharge is a specified recurrence interval discharge, typically between the mean annual and five-year peak. This report focuses on a third approach to determine the channel-forming discharge, known as the effective discharge. The effective discharge transports the largest fraction of the bed material load. Because of this, the effective discharge can be a good estimator for channel-forming discharge.

[1]  K. Woodyer.  Bankfull Frequency in Rivers , 1968, Handbook of Engineering Hydrology (Three-Volume Set).

[2]  Ronald R. Copeland,et al.  Channel Restoration Hydraulic Design Procedure , 1998 .

[3]  P. Carling,et al.  The concept of dominant discharge applied to two gravel-bed streams in relation to channel stability thresholds , 1988 .

[4]  D. E. Burkham,et al.  Channel changes of the Gila River in Safford Valley, Arizona, 1846-1970 , 1972 .

[5]  R. Millar,et al.  Effect of Bank Stability on Geometry of Gravel Rivers , 1993 .

[6]  Maurice L. Albertson,et al.  Uniform Water Conveyance Channels in Alluvial Materials , 1960 .

[7]  W. White,et al.  Analytical Approach to River Regime , 1982 .

[8]  Charles M. Elliott,et al.  The WES Stream Investigation and Streambank Stabilization Handbook , 1997 .

[9]  C. W. Carlston,et al.  The relation of free meander geometry to stream discharge and its geomorphic implications , 1965 .

[10]  K. Clayton,et al.  Transactions of the Institute of British Geographers , 1959 .

[11]  M. Wolman,et al.  Relative scales of time and effectiveness of climate in watershed geomorphology , 1978 .

[12]  V. Yevjevich.  Probability and statistics in hydrology , 1972 .

[13]  R. Müller,et al.  Formulas for Bed-Load transport , 1948 .

[14]  J. T. Hack,et al.  Geomorphology and forest ecology of a mountain region in the central Appalachians , 1960 .

[15]  L. B. Leopold,et al.  River channel patterns: Braided, meandering, and straight , 1957 .

[16]  C. Thorne,et al.  Magnitude‐frequency analysis of sediment transport in the lower Mississippi river , 1994 .

[17]  C. W. Bray,et al.  Standards of Service for Flood Defence , 1992 .

[18]  S. Schumm.  Episodic Erosion: A Modification of the Geomorphic Cycle, , 1976 .

[19]  L. B. Leopold,et al.  River meanders - Theory of minimum variance , 1966 .

[20]  L. Brush.  Drainage basins, channels, and flow characteristics of selected streams in central Pennsylvania , 1961 .

[21]  Thomas Blench,et al.  Regime behaviour of canals and rivers , 1957 .

[22]  N. Raphelt.  Guidance on the Selection and Use of Sediment Discharge Formulas , 1990 .

[23]  Avijit Gupta,et al.  Effects of high‐magnitude floods on channel form: A case study in Maryland Piedmont , 1974 .

[24]  J. T. Limerinos.  Determination of the manning coefficient from measured bed roughness in natural channels , 1970 .

[25]  E. W. Lane.  Design of Stable Channels , 1955 .

[26]  L. B. Leopold,et al.  Quasi-equilibrium states in channel morphology , 1964 .

[27]  C. Thorne,et al.  Magnitude and Frequency Analysis in Large Rivers , 1987 .

[28]  M. Gordon Wolman,et al.  Fluvial Processes in Geomorphology , 1965 .

[29]  G. Dury.  Magnitude-frequency analysis and channel morphometry , 1973 .

[30]  C. W. Carlston.  Downstream variations in the hydraulic geometry of streams; special emphasis on mean velocity , 1969 .

[31]  Melvin J. Dubnick.  Army Corps of Engineers , 1998 .

[32]  J. Gardiner.  River projects and conservation : a manual for holistic appraisal , 1990 .

[33]  W. Emmett.  The channels and waters of the upper Salmon River area, Idaho , 1975 .

[34]  W. T. Pecora,et al.  Principles of underfit streams , 1964 .

[35]  R G Kennedy,et al.  THE PREVENTION OF SILTING IN IRRIGATION CANALS. (INCLUDING APPENDIX). , 1895 .

[36]  Ronald R Copeland,et al.  Application of Channel Stability Methods - Case Studies , 1994 .

[37]  Keith Richards,et al.  Rivers: Form and Process in Alluvial Channels , 1982 .

[38]  C. Thorne,et al.  Stable Channels with Mobile Gravel Beds , 1986 .

[39]  Fred B. Toffaleti.  A procedure for computation of the total river sand discharge and detailed distribution, bed to surface , 1968 .

[40]  G. Pickup,et al.  Effects of hydrologic regime on magnitude and frequency of dominant discharge , 1976 .

[41]  Sheila F. Knight,et al.  Demonstration Erosion Control Project Monitoring Program. Fiscal Year 1993 Report. Volume 6. Appendix E. Model Study of the Demonstration Erosion Control 10-ft Riprap Drop Grade Control Structure , 1994 .

[42]  L. B. Leopold,et al.  The hydraulic geometry of stream channels and some physiographic implications , 1953 .

[43]  M. Wolman,et al.  Magnitude and Frequency of Forces in Geomorphic Processes , 1960, The Journal of Geology.

[44]  E. Andrews.  Bed-material entrainment and hydraulic geometry of gravel-bed rivers in Colorado , 1984 .

[45]  Claude Cavendish Inglis,et al.  The behaviour and control of rivers and canals (with the aid of models) , 1957 .

[46]  L. Robbins.  Suspended sediment and bed material studies on the Lower Mississippi River , 1977 .

[47]  Howard H. Chang.  STABLE ALLUVIAL CANAL DESIGN , 1980 .

[48]  E. Andrews.  Effective and bankfull discharges of streams in the Yampa River basin, Colorado and Wyoming , 1980 .

[49]  C. Thorne,et al.  Geomorphological River Channel Reconnaissance for River Analysis, Engineering and Management , 1996 .

[50]  S. Schumm,et al.  Channel widening and flood-plain construction along Cimarron River in southwestern Kansas , 1963 .

[51]  G. Lacey,et al.  MEANDERS AND THEIR BEARING ON RIVER TRAINING. MARITIME AND WATERWAYS ENGINEERING DIVISION. , 1947 .

[52]  William Robert Brownlie,et al.  Prediction of flow depth and sediment discharge in open channels , 1982 .

[53]  Rolf Kellerhals,et al.  Stable Channels with Gravel-Paved Beds , 1967 .

[54]  S D Halevoor Nagabhushanaiah ph.,et al.  MEANDERING OF RIVERS , 1967 .

[55]  W. R. Osterkamp,et al.  Perennial-streamflow characteristics related to channel geometry and sediment in Missouri River basin , 1982 .

[56]  R. Bagnold.  An approach to the sediment transport problem from general physics , 1966 .