Comparison between numerical simulation and on-orbit experiment of oscillating heat pipes

Abstract This study investigated the startup behavior of Oscillating Heat Pipes (OHPs) by comparing numerical simulation and on-orbit experimental data. Previous studies suggested that initial vapor-liquid distribution affects startup behavior. However, they provided no experimental evidence to validate this hypothesis because experimentally reproducing and specifying initial vapor-liquid distribution in OHPs is virtually impossible. Thus, a numerical approach is necessary to generate the initial vapor-liquid distribution and to understand the internal thermofluid behavior of OHPs. In this study, a one-dimensional numerical model of an OHP with check valves was first developed. Then, the model was compared with data from an on-orbit experiment. Finally, simulation of OHP startup behavior with several types of initial vapor-liquid distributions showed that OHP startup difficulty is due to localization of liquids in the cooling section.

[1]  Hiroki Nagai,et al.  Operational Characteristics of the Oscillating Heat Pipe with Noncondensable Gas , 2015 .

[2]  S. M. Pouryoussefi,et al.  Numerical investigation of chaotic flow in a 2D closed-loop pulsating heat pipe , 2016 .

[3]  Hiroki Nagai,et al.  Study on thermal cycle in oscillating heat pipes by numerical analysis , 2017 .

[4]  Vadim Nikolayev.  Oscillatory instability of the gas–liquid meniscus in a capillary under the imposed temperature difference , 2013 .

[5]  Takayoshi Inoue,et al.  Oscillating heat pipe simulation considering bubble generation Part II: Effects of fitting and design parameters , 2013 .

[6]  Takayoshi Inoue,et al.  Oscillating heat pipe simulation considering bubble generation Part I: Presentation of the model and effects of a bubble generation , 2013 .

[7]  Sameer Khandekar,et al.  Closed loop pulsating heat pipes: Part A: parametric experimental investigations , 2003 .

[8]  Hiroki Nagai,et al.  HEAT TANSFER PERFORMANCE OF OSCILLATING HEAT PIPE BY DIFFERENCE OF SURFACE CHARACTERISTICS , 2014 .

[9]  Vadim Nikolayev,et al.  EVALUATION OF THE VAPOR THERMODYNAMIC STATE IN PHP , 2014 .

[10]  Hiroyuki Sugita,et al.  Development of Flat Plate Heat Pipe and the Project of On-orbit Experiment , 2011 .

[11]  H. Itō,et al.  Friction Factors for Turbulent Flow in Curved Pipes , 1959 .

[12]  David Quéré,et al.  Quick deposition of a fluid on the wall of a tube , 2000 .

[13]  H. Itō,et al.  Laminar Flow in Curved Pipes , 1969 .

[14]  M. Rieutord,et al.  Fluid Dynamics: An Introduction , 2014 .

[15]  F. Bretherton.  The motion of long bubbles in tubes , 1961, Journal of Fluid Mechanics.

[16]  Frédéric Lefèvre,et al.  Thermally induced two-phase oscillating flow inside a capillary tube , 2010 .

[17]  Manfred Groll,et al.  Closed loop pulsating heat pipes Part B: visualization and semi-empirical modeling , 2003 .

[18]  Chris R. Kleijn,et al.  Inertial and Interfacial Effects on Pressure Drop of Taylor Flow in Capillaries , 2005 .

[19]  Vadim Nikolayev,et al.  A Dynamic Film Model of the Pulsating Heat Pipe , 2011, 2112.00623.

[20]  Hiroyuki Sugita,et al.  INITIAL EVALUATION OF ON-ORBIT EXPERIMENT OF FLAT-PLATE HEAT PIPE , 2014 .

[21]  Yuwen Zhang,et al.  Thermal Modeling of Unlooped and Looped Pulsating Heat Pipes , 2001, Heat Transfer: Volume 3 — Fluid-Physics and Heat Transfer for Macro- and Micro-Scale Gas-Liquid and Phase-Change Flows.

[22]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[23]  Alec Norton,et al.  Dynamics: an introduction , 1996 .

[24]  Manfred Groll,et al.  An insight into thermo-hydrodynamic coupling in closed loop pulsating heat pipes , 2004 .

[25]  R. Hino,et al.  Studies on heat transfer and flow characteristics in subcooled flow boiling. Part 2. Flow characteristics , 1985 .