Disturbance-free BIST for loop characterization of DC-DC buck converters

Complex electronic systems include multiple power domains and drastically varying dynamic power consumption patterns, requiring the use of multiple power conversion and regulation units. High frequency switching converters have been gaining prominence in the DC-DC converter market due to their high efficiency. Unfortunately, they are also subject to higher process variations jeopardizing stable operation of the power supply. This paper presents a technique to track changes in the dynamic loop characteristics of the DC-DC converters without disturbing the normal mode of operation using a white noise based excitation and correlation. White noise excitation is generated via pseudo random disturbance at reference and PWM input of the converter with the test signal energy being spread over a wide bandwidth, below the converter noise and ripple floor. Test signal analysis is achieved by correlating the pseudo random input sequence with the output response and thereby accumulating the desired behavior over time and pulling it above the noise floor of the measurement set-up. An off-the-shelf power converter, LM27402 is used as the DUT for the experimental verification. Experimental results show that the proposed technique can estimate converter's natural frequency and Q-factor within ±2.5% and ±0.7% error margin respectively, over changes in load inductance and capacitance.

[1]  Francis E. Fisher,et al.  On the vibrations of overdamped systems , 1990 .

[2]  Lennart Ljung,et al.  System Identification: Theory for the User , 1987 .

[3]  D. Maksimovic,et al.  System identification of power converters with digital control through cross-correlation methods , 2005, IEEE Transactions on Power Electronics.

[4]  E. Santi,et al.  Improved Online Identification of a DC–DC Converter and Its Control Loop Gain Using Cross-Correlation Methods , 2009, IEEE Transactions on Power Electronics.

[5]  Bo-Youn Cho,et al.  Empirical small-signal modeling of switching converters using Pspice , 1995, Proceedings of PESC '95 - Power Electronics Specialist Conference.

[6]  B. Johansson,et al.  Possibilities of obtaining small-signal models of DC-to-DC power converters by means of system identification , 2000, INTELEC. Twenty-Second International Telecommunications Energy Conference (Cat. No.00CH37131).

[7]  Wilfred Gomes,et al.  5.9 Haswell: A family of IA 22nm processors , 2014, 2014 IEEE International Solid-State Circuits Conference Digest of Technical Papers (ISSCC).

[8]  Abhijit Chatterjee,et al.  Alternative “safe” test of hysteretic power converters , 2014, 2014 IEEE 32nd VLSI Test Symposium (VTS).

[9]  Gene F. Franklin,et al.  Digital control of dynamic systems , 1980 .

[10]  Robert W. Erickson,et al.  Fundamentals of Power Electronics , 2001 .

[11]  Sule Ozev,et al.  A built-in self-test technique for load inductance and lossless current sensing of DC-DC converters , 2014, 2014 IEEE 32nd VLSI Test Symposium (VTS).

[12]  Tomi Roinila,et al.  Circular correlation based identification of switching power converter with uncertainty analysis using fuzzy density approach , 2009, Simul. Model. Pract. Theory.

[13]  Dragan Maksimovic,et al.  Computer-aided small-signal analysis based on impulse response of DC/DC switching power converters , 2000 .

[14]  K. R. Godfrey,et al.  Introduction to binary signals used in system identification , 1991 .

[15]  Francis E. Fisher,et al.  Determination of vibration parameters in moderately damped systems , 1990 .

[16]  S. Saggini,et al.  Digital Autotuning of DC–DC Converters Based on a Model Reference Impulse Response , 2011, IEEE Transactions on Power Electronics.