A New High Step-Up DC/DC Converter Structure by Using Coupled Inductor with Reduced Switch-Voltage Stress

Abstract In this paper, a new high step-up DC/DC converter for renewable energy systems is proposed, which provides high voltage gain by using a coupled inductor without having to have high-duty cycle and high-turn ratio. Moreover, the voltage gain increased by using capacitors charging techniques. In the proposed converter, the energy of leakage inductors of the coupled inductor is recycled to the load. This feature not only reduces stress on main switch but also increases the converter efficiency. Also, due to the configuration of the proposed structure, the voltage stress on the main switch is significantly reduced. Since the stress is low in this topology, low voltage switch with small ON-state resistance value can be used to reduce the conduction losses. As a result, losses decrease and the efficiency increases. Meanwhile, the main switch is placed in series with the source and it can control the flow of energy from source to load. The operating principles and steady-state analysis of the proposed converter are discussed in details. Finally, the prototype circuit with 12 V input voltage, 300 V output voltage, and 60 W output power is operated to verify its performance.

[1]  Mutsuo Nakaoka,et al.  High frequency PWM controlled step-up chopper type DC–DC power converters with reduced peak switch voltage stress , 2004 .

[2]  Y.-M. Chen,et al.  Buck and boost derived converter for livestock/poultry stunning applications , 2006, Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06..

[3]  Xuefeng Hu,et al.  A High Voltage Gain DC–DC Converter Integrating Coupled-Inductor and Diode–Capacitor Techniques , 2014, IEEE Transactions on Power Electronics.

[4]  A.M. Salamah,et al.  Single-Phase Voltage Source Inverter With a Bidirectional Buck–Boost Stage for Harmonic Injection and Distributed Generation , 2009, IEEE Transactions on Power Electronics.

[5]  Adrian Ioinovici,et al.  A cascade boost-switched-capacitor-converter - two level inverter with an optimized multilevel output waveform , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.

[6]  Dmitri Vinnikov,et al.  Step-Up DC/DC Converters With Cascaded Quasi-Z-Source Network , 2012, IEEE Transactions on Industrial Electronics.

[7]  Shuai Jiang,et al.  Grid-Connected Boost-Half-Bridge Photovoltaic Microinverter System Using Repetitive Current Control and Maximum Power Point Tracking , 2012, IEEE Transactions on Power Electronics.

[8]  F. Blaabjerg,et al.  A review of single-phase grid-connected inverters for photovoltaic modules , 2005, IEEE Transactions on Industry Applications.

[9]  Tsorng-Juu Liang,et al.  Novel High Step-Up DC–DC Converter With Coupled-Inductor and Voltage-Doubler Circuits , 2011, IEEE Transactions on Industrial Electronics.

[10]  Fatih Evran,et al.  Isolated High Step-Up DC–DC Converter With Low Voltage Stress , 2014, IEEE Transactions on Power Electronics.

[11]  Yu Tang,et al.  Dual Switches DC/DC Converter With Three-Winding-Coupled Inductor and Charge Pump , 2016, IEEE Transactions on Power Electronics.

[12]  Ebrahim Babaei,et al.  A generalized ultra step-up DC–DC converter for high voltage application with design considerations , 2013 .

[13]  Jonathan W. Kimball,et al.  Effects of stray inductance on hard-switched switched capacitor converters , 2014, 2014 Power and Energy Conference at Illinois (PECI).

[14]  Ka Wai Eric Cheng,et al.  A Step-Up Switched-Capacitor Multilevel Inverter With Self-Voltage Balancing , 2014, IEEE Transactions on Industrial Electronics.

[15]  Tsorng-Juu Liang,et al.  A Boost Converter With Capacitor Multiplier and Coupled Inductor for AC Module Applications , 2013, IEEE Transactions on Industrial Electronics.

[16]  Tao Zhou,et al.  Energy Management and Power Control of a Hybrid Active Wind Generator for Distributed Power Generation and Grid Integration , 2011, IEEE Transactions on Industrial Electronics.

[17]  Bangyin Liu,et al.  Photovoltaic DC-Building-Module-Based BIPV System—Concept and Design Considerations , 2011, IEEE Transactions on Power Electronics.

[18]  Slobodan Cuk,et al.  A three-switch high-voltage converter , 1999 .

[19]  Ebrahim Babaei,et al.  Operational Modes and Output-Voltage-Ripple Analysis and Design Considerations of Buck–Boost DC–DC Converters , 2012, IEEE Transactions on Industrial Electronics.

[20]  Woo Young Choi,et al.  High-Efficiency Power Conditioning System for Grid-Connected Photovoltaic Modules , 2011 .

[21]  Stephen J. Finney,et al.  The RCD snubber revisited , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.

[22]  Abdul Ahad,et al.  AN INTEGRATED BOOST RESONANT CONVERTER FOR PHOTOVOLTAIC APPLICATIONS , 2014 .

[23]  Jiann-Fuh Chen,et al.  Novel High Step-Up DC–DC Converter for Distributed Generation System , 2013, IEEE Transactions on Industrial Electronics.

[24]  Dylan Dah-Chuan Lu,et al.  Flyback-based high step-up converter with reduced power processing stages , 2012 .

[25]  Y. Berkovich,et al.  Switched Coupled-Inductor Cell for DC-DC Converters with Very Large Conversion Ratio , 2011, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[26]  Dmitri Vinnikov,et al.  Quasi-Z-Source-Based Isolated DC/DC Converters for Distributed Power Generation , 2011, IEEE Transactions on Industrial Electronics.

[27]  Jih-Sheng Lai,et al.  Hybrid-Frequency Modulation for PWM-Integrated Resonant Converters , 2013, IEEE Transactions on Power Electronics.

[28]  Xinke Wu,et al.  Analysis and Derivations for a Family ZVS Converter Based on a New Active Clamp ZVS Cell , 2008, IEEE Transactions on Industrial Electronics.

[29]  Xinbo Ruan,et al.  Nonisolated High Step-Up DC–DC Converters Adopting Switched-Capacitor Cell , 2015, IEEE Transactions on Industrial Electronics.

[30]  Rong-Jong Wai,et al.  High-efficiency Voltage-clamped DC-DC converter with reduced reverse-recovery current and switch-Voltage stress , 2006, IEEE Transactions on Industrial Electronics.

[31]  A. Costabeber,et al.  High Step-Up Ratio Flyback Converter With Active Clamp and Voltage Multiplier , 2011, IEEE Transactions on Power Electronics.

[32]  Ebrahim Babaei,et al.  Analysis of voltage and current stresses of a generalised step-up DC-DC converter , 2014 .

[33]  Akshay Kumar Rathore,et al.  Analysis, Design and Experimental Results of Wide Range ZVS Active-Clamped L-L Type Current-Fed DC/DC Converter for Fuel Cells to Utility Interface , 2012, IEEE Transactions on Industrial Electronics.

[34]  Emmanuel C. Tatakis,et al.  Active voltage clamp in flyback converters operating in CCM mode under wide load variation , 2004, IEEE Transactions on Industrial Electronics.

[35]  Wu Gan Non-isolated High Step-up DC-DC Converters Adopting Switched-capacitor Cell , 2015 .

[36]  Wuhua Li,et al.  Single-Phase Improved Active Clamp Coupled-Inductor-Based Converter With Extended Voltage Doubler Cell , 2012, IEEE Transactions on Power Electronics.

[37]  Bin Gu,et al.  Hybrid Transformer ZVS/ZCS DC–DC Converter With Optimized Magnetics and Improved Power Devices Utilization for Photovoltaic Module Applications , 2015, IEEE Transactions on Power Electronics.