Two new mechanisms for laser cleaning using Nd:YAG sources

Abstract Two new methods for the laser cleaning using a Q-swihed Nd:YAG laser have been developed and investigated. These offer increased efficiency and reduction in possible substrate damage for a wide range of substrate/encrustation combinations. In angular laser cleaning, it is shown that by controlling the angle of incidence of the cleaning laser, significant improvement in the efficiency of cleaning can be achieved when compared with conventional cleaning with a normal angle of incidence. A model is proposed to explain this effect. In laser shock cleaning, a completely different approach is presented. By aligning the incoming laser beam to be horizontal to the surface to be cleaned but close to it and selecting operating parameters that lead to a breakdown of the air above the object to be cleaned, a laser-induced shock wave is produced that is very much more effective than conventional normal incidence cleaning in removing surface pollutants. However, because the laser does not come into contact with the substrate, this method significantly minimises the potential for substrate damage. Again, a model for the cleaning process is presented. The results for the operation of both methods on polluted marble are presented.

[1]  David C. Emmony,et al.  The Use of Laser Energy to Clean Polluted Stone Sculpture , 1992 .

[2]  John F. Asmus,et al.  Studies On The Interaction Of Laser Radiation With Art Artifacts , 1974, Optics & Photonics.

[3]  Yongfeng Lu,et al.  Characterization of ejected particles during laser cleaning , 2000 .

[4]  J. Ready.  Effects of high-power laser radiation , 1971 .

[5]  T.K. Fowler,et al.  Nuclear fusion , 1989, IEEE Potentials.

[6]  R. Reed,et al.  Ancient skins, parchments and leathers , 1972 .

[7]  K. Mittal,et al.  Particles on Surfaces 1 , 1989 .

[8]  D. Kane,et al.  A quantitative analysis of single pulse ultraviolet dry laser cleaning , 1999 .

[9]  R. F. Harrison,et al.  Impulse coupling to targets in vacuum by KrF, HF, and CO2 single‐pulse lasers , 1988 .

[10]  G. Vereecke,et al.  Laser-assisted removal of particles on silicon wafers , 1999 .

[11]  R. A. Bowling,et al.  A Theoretical Review of Particle Adhesion , 1988 .

[12]  John F. Asmus,et al.  Light for Art Conservation , 1987 .

[13]  J. M. Lee,et al.  Angular laser cleaning for effective removal of particles. from a solid surface , 2000 .

[14]  Ken Watkins,et al.  In-process monitoring techniques for laser cleaning , 2000 .

[15]  J. F. Asmus.  More light for art conservation , 1986, IEEE Circuits and Devices Magazine.

[16]  Yongfeng Lu,et al.  Laser removal of particles from magnetic head sliders , 1996 .

[17]  B. Wolff-Rottke,et al.  Cleaning of optical surfaces by excimer laser radiation , 1996 .

[18]  Costas P. Grigoropoulos,et al.  Laser Cleaning Of Surface Contaminants , 1997, Technical Digest CLEO/Pacific Rim '97 Pacific Rim Conference on Lasers and Electro-Optics.