On-the-field simulation of fertilizer spreading: Part 1 - Modeling

Abstract The field elevation and its variation represent a disturbance in the spreading process that is not handled yet by centrifugal spreaders. This stems in part from the knowledge gap regarding the possible application errors of fertilizer on non-flat fields. To address this issue, a new model has been developed, integrating both the field elevation and the tractor motion. The model was employed in the paper (“On-the-field simulation of fertilizer spreading: Part 2 – Uniformity investigation”). The model was based on transformation matrices to update the initial conditions of the ballistic flight of particles in the field coordinate system at each new position of the tractor, as it moves along a given trajectory on a given DEM (digital elevation model). An experimental validation was conducted using a radial bench in different static configurations, which also provided the unknown input data for the model. High correlation coefficients were found between the characteristics of the simulated and measured spread patterns, even where, in the simulation, the model parameters were fixed and the spreader inclination varied. Thus, in addition to proving the reliability of the model, the measurements also helped determining the limits of validity of the assumptions within which on-the-field simulations can be carried out.

[1]  Jonas Koko,et al.  Optimization of a fertilizer spreading process , 2009, Math. Comput. Simul..

[2]  Y. Yildirim.  Effect of Side to Side Spreader Angle on Pattern Uniformity in Single- and Twin-Disc Rotary Fertilizer Spreaders , 2008 .

[3]  Ian J. Yule,et al.  Estimation of the in‐field variation in fertiliser application , 2007 .

[4]  Tony E Grift,et al.  Analysis and Control of Uniformity by the Feed Gate Adaptation of a Granular Spreader , 2009 .

[5]  Emmanuel Piron,et al.  Centrifugal Spreading: an Analytical Model for the Motion of Fertiliser Particles on a Spinning Disc , 2005 .

[6]  P. P. Brown,et al.  Sphere Drag and Settling Velocity Revisited , 2003 .

[7]  Denis Miclet,et al.  How mass flow and rotational speed affect fertiliser centrifugal spreading: Potential interpretation in terms of the amount of fertiliser per vane , 2012 .

[8]  Herman Ramon,et al.  Experimental characterisation of the cylindrical distribution pattern of centrifugal fertiliser spreaders: towards an alternative for spreading hall measurements , 2003 .

[9]  R. L. Parish.  EFFECT OF IMPELLER ANGLE ON PATTERN UNIFORMITY , 2003 .

[10]  Logah Perumal,et al.  Quaternion and Its Application in Rotation Using Sets of Regions , 2016 .

[11]  C. J. Coetzee,et al.  Discrete element method modelling of a centrifugal fertiliser spreader , 2011 .

[12]  Herman Ramon,et al.  Model for Simulation of Particle Flow on a Centrifugal Fertiliser Spreader , 2004 .

[13]  Michel Paindavoine,et al.  High Speed Stereovision Setup for Position and Motion Estimation of Fertilizer Particles Leaving a Centrifugal Spreader , 2014, Sensors.

[14]  Tony E Grift.  Spread Pattern Analysis Tool (SPAT): I. Development and theoretical examples , 2000 .

[15]  Tony E Grift,et al.  Aerodynamic properties of individual fertilizer particles , 1997 .

[16]  Tony E Grift,et al.  Dynamic Friction Coefficient Measurement of Granular Fertiliser Particles , 2006 .

[17]  Herman Ramon,et al.  Experimental Characterisation of the Tangential and Cylindrical Fertiliser Distribution Pattern from a Spinning Disc: A Parameter Study , 2003 .

[18]  R. L. Parish.  Effect of Rough Operating Surface on Rotary Spreader Distribution Pattern , 1991 .

[19]  Emmanuel Piron,et al.  Centrifugal spreading of fertiliser: Deducing three-dimensional velocities from horizontal outlet angles using computer vision , 2008 .

[20]  Tony E Grift,et al.  Measurement of velocity and diameter of individual fertilizer particles by an optical method. , 1997 .

[21]  Denis Miclet,et al.  CEMIB: an innovative bench for spreader eco-design. , 2010 .

[22]  Y. T. Lee,et al.  Performing Euler angle rotations in CAD systems , 1995, Comput. Aided Des..

[23]  Herman Ramon,et al.  DEM simulations of the particle flow on a centrifugal fertilizer spreader , 2009 .

[24]  M. I. Minguez,et al.  Evolution not revolution of farming systems will best feed and green the world , 2012 .

[25]  Jan Willem Hofstee,et al.  Handling and spreading of fertilizers part 1: Physical properties of fertilizer in relation to particle motion , 1990 .

[26]  Tony E Grift,et al.  Feed Gate Adaptation of a Spinner Spreader for Uniformity Control , 2006 .

[27]  David Nuyttens,et al.  Development of a Stereovision-Based Technique to Measure the Spread Patterns of Granular Fertilizer Spreaders , 2017, Sensors.

[28]  Ian J. Yule,et al.  The Effect of Field Conditions on In-Field Spread Patterns from Twin Disk Spreaders , 2015 .

[29]  Denis Miclet,et al.  Estimation of two-dimensional fertiliser mass flow distributions by recording granule impacts , 2013 .

[30]  Jan Pieters,et al.  A simulation of the influence of spinning on the ballistic flight of spherical fertiliser grains , 2014 .

[31]  Shahid Hussain,et al.  Sustainable Agriculture Through Integrated Soil Fertility Management on Degraded Lands , 2013 .

[32]  Hanspeter Liniger,et al.  Soil Erosion and Conservation in Global Agriculture , 2008 .

[33]  Jan Pieters,et al.  Determing the drag coefficient of fertilizer grains using stereovision , 2014 .

[34]  Richard L. Parish,et al.  Pattern Sensitivity to Location of Fertilizer Drop Point on a Rotary Spreader Impeller , 1986 .

[35]  Pete Smith,et al.  Delivering food security without increasing pressure on land , 2013 .

[36]  J. De Baerdemaeker,et al.  Calculation of fertilizer distribution patterns from a spinning disc spreader by means of a simulation model , 1996 .