论文信息 - Size Minimization of the Cam Mechanisms with Translating Roll Follower

Size Minimization of the Cam Mechanisms with Translating Roll Follower

An important problem in the cam mechanisms synthesis is their total size as a minimization condition (criteria). Usual this condition is reduced to the cam size only, which is not correct because the cam does not function alone. For a cam mechanism with translating follower, the length of follower΄s guiding is a very important contributor to the total size of the cam mechanism.In this paper the case of cam mechanism with roll edge follower is taken into consideration

[1] Jorge Angeles,et al. Optimization of cam mechanisms , 1991 .

[2] Yoshio Terauchi,et al. A computer-aided method for optimum design of plate cam-size avoiding undercutting and separation phenomena—II: Design nomograms , 1984 .

[3] Jorge Angeles,et al. The size-minimization of planar cam mechanisms , 2001 .

[4] Mechanisms. Fourth World Congress on the Theory of Machines and Mechanisms : papers read at the Congress at the University of Newcastle upon Tyne, 8-12 September, 1975 , 1975 .

[5] S Carra,et al. Synthesis of cams with negative radius follower and evaluation of the pressure angle , 2004 .

[6] D. Perju,et al. Cam Mechanism with Flat/Tangential Translating Follower and Its Size , 2010 .

[7] Yoshio Terauchi,et al. A computer-aided method for optimum design of plate cam size avoiding undercutting and separation phenomena—I Design procedure and cycloidal cam design results , 1983 .