Whole-body Vibration Exposure Intervention among Professional Bus and Truck Drivers: A Laboratory Evaluation of Seat-suspension Designs

Long-term exposure to seated whole-body vibration (WBV) is one of the leading risk factors for the development of low back disorders. Professional bus and truck drivers are regularly exposed to continuous WBV, since they spend the majority of their working hours driving heavy vehicles. This study measured WBV exposures among professional bus and truck drivers and evaluated the effects of seat-suspension designs using simulated field-collected data on a vibration table. WBV exposures were measured and compared across three different seat designs: an air-ride bus seat, an air-ride truck seat, and an electromagnetically active (EM-active) seat. Air-ride seats use a compressed-air bladder to attenuate vibrations, and they have been in operation throughout the transportation industry for many years. The EM-active seat is a relatively new design that incorporates a microprocessor-controlled actuator to dampen vibration. The vibration table simulated seven WBV exposure scenarios: four segments of vertical vibration and three scenarios that used field-collected driving data on different road surfaces—a city street, a freeway, and a section of rough roadway. The field scenarios used tri-axial WBV data that had been collected at the seat pan and at the driver's sternum, in accordance with ISO 2631-1 and 2631-5. This study found that WBV was significantly greater in the vertical direction (z-axis) than in the lateral directions (x-and y-axes) for each of the three road types and each of the three types of seats. Quantitative comparisons of the results showed that the floor-to-seat-pan transmissibility was significantly lower for the EM-active seat than for either the air-ride bus seat or the air-ride truck seat, across all three road types. This study also demonstrated that seat-suspension designs have a significant effect on the vibrations transmitted to vehicle operators, and the study's results may prove useful in designing future seat suspensions.

[1]  Richard W. Kent,et al.  Thoracic and lumbar spinal impact tolerance. , 2008, Accident; analysis and prevention.

[2]  J Sandover,et al.  Dynamic Loading as a Possible Source of Low-Back Disorders , 1983, Spine.

[3]  Michael J. Griffin,et al.  Effects of frequency, magnitude, damping, and direction on the discomfort of vertical whole-body mechanical shocks , 2008 .

[4]  Leonid Kalichman,et al.  Low back pain among professional bus drivers: ergonomic and occupational-psychosocial risk factors. , 2010, The Israel Medical Association journal : IMAJ.

[5]  A. Starkweather,et al.  Low back pain. , 2015, Nursing.

[6]  N J Mansfield,et al.  Self-reported musculoskeletal problems amongst professional truck drivers , 2007, Ergonomics.

[7]  E D Richter,et al.  Working conditions and fatigue in professional truck drivers at Israeli ports , 2005, Injury Prevention.

[8]  Michael J Jorgensen,et al.  Repeatability of a Checklist for Evaluating Cab Design Characteristics of Heavy Mobile Equipment , 2007, Journal of occupational and environmental hygiene.

[9]  Hugh W. Davies,et al.  Whole body vibrations and back disorders among motor vehicle drivers and heavy equipment operators: a review of the scientific evidence , 1999 .

[10]  F. Guillon,et al.  VERTICAL VIBRATION TRANSMISSION THROUGH THE LUMBAR SPINE OF THE SEATED SUBJECT—FIRST RESULTS , 1998 .

[11]  Ryan P. Blood,et al.  Whole body vibration exposures in metropolitan bus drivers: A comparison of three seats , 2010 .

[12]  Allard J van der Beek,et al.  World at work: truck drivers , 2011, Occupational and Environmental Medicine.

[13]  Niklas Gloeckner,et al.  Handbook Of Human Vibration , 2016 .

[14]  E Thalheimer,et al.  Practical approach to measurement and evaluation of exposure to whole-body vibration in the workplace. , 1996, Seminars in perinatology.

[15]  T. Keller,et al.  Mechanical behavior of the human lumbar spine. II. Fatigue strength during dynamic compressive loading , 1987, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[16]  D G Wilder,et al.  Epidemiological and aetiological aspects of low back pain in vibration environments - an update. , 1996, Clinical biomechanics.

[17]  Jack T Dennerlein,et al.  Using “Exposure Prediction Rules” for Exposure Assessment: An Example on Whole-Body Vibration in Taxi Drivers , 2004, Epidemiology.

[18]  Michael J. Griffin,et al.  Power absorbed during whole-body vertical vibration: Effects of sitting posture, backrest, and footrest , 2010 .

[19]  P. Brinckmann,et al.  Fatigue fracture of human lumbar vertebrae. , 1988, Clinical biomechanics.

[20]  M Pope,et al.  The effect of posture and seat suspension design on discomfort and back muscle fatigue during simulated truck driving. , 1994, Applied ergonomics.

[21]  M H W Frings-Dresen,et al.  Low back pain in drivers exposed to whole body vibration: analysis of a dose–response pattern , 2008, Occupational and Environmental Medicine.

[22]  Brad Kreitz,et al.  Occupational Low Back Pain: assessment, treatment and prevention , 1994 .

[23]  Ryan P. Blood,et al.  Whole body vibration exposures in forklift operators: comparison of a mechanical and air suspension seat , 2010, Ergonomics.

[24]  M Fritz.  Estimation of spine forces under whole-body vibration by means of a biomechanical model and transfer functions. , 1997, Aviation, space, and environmental medicine.

[25]  M. J. Griffin,et al.  5 – Whole-body Vibration and Health , 1990 .

[26]  M Fritz,et al.  Description of the relation between the forces acting in the lumbar spine and whole-body vibrations by means of transfer functions. , 2000, Clinical biomechanics.

[27]  M. Magnusson,et al.  The role of whole body vibration, posture and manual materials handling as risk factors for low back pain in occupational drivers , 2008, Ergonomics.