Model Based Approach by Combination of Test and Simulation Methodologies for NVH Investigation and Improvement of a Rear Wheel Drive Vehicle

[1]  Herman Van der Auweraer,et al.  Virtual engineering at work: the challenges for designing mechatronic products , 2012, Engineering with Computers.

[2]  Masashi Kato,et al.  Development of Super Ultra Flat Torque Converter with Multi Plate Lock-up Clutch , 2009 .

[3]  Klaus Wolff,et al.  Aspects of Driveline Integration for Optimized Vehicle NVH Characteristics , 2007 .

[4]  Pragasen Pillay,et al.  Low-vibration design of switched reluctance motors for automotive applications using modal analysis , 2003 .

[5]  Thomas G. Leone,et al.  Fuel Economy Benefit of Cylinder Deactivation - Sensitivity to Vehicle Application and Operating Constraints , 2001 .

[6]  Dean Tomazic,et al.  Integration of Engine Start/Stop Systems with Emphasis on NVH and Launch Behavior , 2013 .

[7]  Wim Desmet,et al.  Stable force identification in structural dynamics using Kalman filtering and dummy-measurements , 2015 .

[8]  Ahsan Kareem,et al.  Estimation of modal loads using structural response , 2009 .

[9]  Anders Wedin,et al.  Reduction of Vibrations in Engines using Centrifugal Pendulum Vibration Absorbers , 2011 .

[10]  Zhe Li,et al.  Improving Low Frequency Torsional Vibrations NVH Performance through Analysis and Test , 2007 .

[11]  T. G. Carne,et al.  Experimental modal analysis for microelectromechanical systems , 2005 .

[12]  Thorsten Raatz,et al.  Potentials and Limits of Downsizing a Diesel Engine , 2011 .

[13]  J. C. Samin,et al.  Multiphysics modeling and optimization of mechatronic multibody systems , 2007 .

[14]  Alan G. Haddow,et al.  Centrifugal Pendulum Vibration Absorbers: An Experimental and Theoretical Investigation , 2003 .

[15]  Harald Stoffels,et al.  NVH Aspects of a Downsized Turbocharged Gasoline Powertrain with Direct Injection , 2003 .