Characteristic evaluation for synchronous motors using a universal drive system

This work proposes a new universal drive system using a real-time interface (RTI). In the universal drive system; the RTI connects real-time simulation software tools with experimental equipment directly. After numerical analysis of the simulation software tools, the RTI takes in an analysis result to the experimental equipment immediately, then an experiment are performed with the experimental equipment. The stability of control systems can be online examined by the experiment. This method is greatly helpful to early carry out the detection and the solution technique of actual problems. Moreover, characteristics of surface permanent magnet (SPM) synchronous motors and synchronous reluctance (SynR) motors are measured using the proposed universal drive system. From the experimental result, it is confirmed that the SynR motor loss becomes small rather than the SPM synchronous motor at the time of high rotation and low torque operation.

[1]  Kazunobu Ohyama,et al.  Recent Advances of Reluctance Torque Assisted Motors , 2003 .

[2]  Shigeo Morimoto,et al.  Rotor design and control method of synchronous reluctance motor with multiflux barrier , 1998, 1998 International Conference on Power Electronic Drives and Energy Systems for Industrial Growth, 1998. Proceedings..

[3]  Mineo Tsuji,et al.  Stability Analysis Methods for Digital Vector Control System of Induction Motor , 2003 .

[4]  Satoshi Ogasawara,et al.  Simulation in Power Electronic Systems , 2002 .

[5]  Timothy J. E. Miller,et al.  Maximising the saliency ratio of the synchronous reluctance motor , 1993 .

[6]  Hirofumi Akagi,et al.  A Simulation Method for High-Speed and High-Accuracy Calculation , 2001 .

[7]  V. Toigo,et al.  Full-digital control boards for IGBT full-bridge switching converters , 2002 .

[8]  Shigeo Morimoto,et al.  Parameter Measurement of PM Motor in dq Equivalent Circuit , 1993 .

[9]  Akira Kimura.  Robust Nonlinear Speed Control Method for Rolling Stock with Jerk Limitation , 2002 .

[10]  Takao Kawabata,et al.  Vector Control of AC Motor Using PWM Inverter with Output LC Filter , 2002 .

[11]  Shigeo Morimoto,et al.  Loss minimization control of permanent magnet synchronous motor drives , 1994, IEEE Trans. Ind. Electron..

[12]  Daniel H. Cromer.  Implementation Guide , 2019, Leaner Six Sigma.

[13]  Hirofumi Akagi,et al.  A position-sensorless IPM motor drive system using a position estimation based on magnetic saliency , 1998 .

[14]  Yoko Amano.  A NEW DESIGN FOR A UNIVERSAL DRIVE SYSTEM OF SYNCHRONOUS MOTORS(Engineering) , 2004 .

[15]  Hirofumi Akagi,et al.  A position-sensorless IPM motor drive system using a position estimation based on magnetic saliency , 2000 .

[16]  Yoshihiro Ohnishi,et al.  A Design of Self-Tuning PID Control Systems Based on Pole-Assignment Method , 2003 .

[17]  Bran Selic,et al.  Using models in real-time software design , 2003 .

[18]  Karl-Erik Årzén,et al.  Trends in software and control , 2003 .